Help!

Hi everybody,

Just a quick question I’m preety sure of the issue just want some advice.

Using my Pulse 24 RTA and all I can describe this as is inhaling a Bon fire.


Sometimes when I put the top back on after dripping I guess the cap is pushing to tight on the coil? Which will then glow red and just blow out hot disgusting smoke, which I normally clock and don’t inhale but today didn’t and literally was coughing my guts up for ages.

Question is what is actually doing this to the coil? Am I right the lid is to tight and anybody had this before.

Also anything to worry about inhaling the bonfire

Thanks People.  


Similar Content



Having A Hard Time Adjusting.

I’ve been away from vaping for about 7 yrs. I don’t have any of my old equipment, which now I miss very much. I’ve been trying to get back to vaping for health reasons, and having to learn all over again. Everything is dual coil. I NEVER used dual coil, but I’m trying to learn. I got a Vaporesso PM40, a Drag S a hcigar vt inbox and a POS squonker that I’m using for a dripper (reviews said they leak and short out causing me to fire by their self. I joy cappo squonk box).
Do I figure dual coil watts and amps like I did my single coil builds. I never got into the low sub-ohm thing. Maybe 0.9-1 ohm.
It’s good to be back in ECF again.  

Coil Placing Question

I was building my Avocado RTA today and for my second coil, I noticed that I must’ve wrapped it backwards as the upper leg went in the lower slot (the other coil had the top leg going in the top slot and bottom in the bottom). The tank reads on the ohm meter just fine. I am just wondering if I should re-wrap the coil so that the legs line up with the slots or if it’s fine as is? I hope this question makes sense. Thanks in advance!  

Bitter Taste Since Morning?

my tank's been on a leak streak. relatively new and still on first coil. haven't bought back ups yet, since i'm not sure it's a keeper.

I had to chain at high wattage (for coil) to get the gurgling to stop. might;ve burnt it. no dry hits thus far_ well kind of one... but mainly been bitter after today's fiasco.. i did fire it without inhaling a bit too.

the only discernible thing is a bitter taste sticking. is that an indicator of coil being burnt (didn't happen on my gear)?  

Nic Salts And Dl Hits?

I’m curious as to why you shouldn’t do DL when using nic salts. I’ve got an Aegis Hero with a 0.6 coil at 15 watts. Even with the airflow closed off, it’s still to loose for a MTL. I keep reading and hearing I shouldn’t use nic salts for DL. The worst thing I’ve experienced so far is a mild headache. The nic salt is a 30mg.
Thanks in advance. ECF is my only true support group and I’m having a really hard time not smoking the stinkiest. Been back to vaping for about a month, and keep telling myself it’s all about baby steps. Not how many I smoke but how many I don’t smoke. I’ve got to quit for health reasons.  

I Am Stumped On This Kanger Subtank Rba Deck Problem...

So I finally got around to putting a coil on the rba deck...my typical kayfun build, 28 ga @ 1.3-1.4 ohms. Everything looked good, coil tight....raised off the deck...screwed into the ohm meter....weirdness ensues....said 3.85 ohms...took it off, put it back on...said 4.6 ohms....looked to see if the coil screws were tight ...check. both tails tight under the screws...check. The coil deck screwed into the base...yep. No moisture in the base, nope. Put it on the ipv...said 7.7 ohms, then 4.2, then 3.90.............


Put the stock coils in the base, everything normal. Is there something I could be missing in the coil deck??? I got nothing else. No, I had not put the chimney on, so no short there. I may wrap another coil and see....I can only think that something is amiss in that little coil deck....or I am missing something in the build that is obvious. It's a really nice, tight looking coil too.  

Washed The Coil?

Hey guys I’ve been enjoying vaping for a few months now and I’m loving it.
I’ve learnt how to fix some leaks and backspits so I am happy with that .
But I have washed one of my coil cleaning it under tap water and left it to air out for a week cuz I used another coil at this time.


I’m not getting much juice and the cotton in the coil is quite hard. So I’m sucking mostly Heat vape
But it’s not terrible or anything?

What should I do ?

Kind regards  

Inhalation Methods

I recently discovered a new way to vape. Well it's the same way I used to smoke cigarettes; keeping the hit in my mouth while only inhaling a small amount off of that. I think it's the way most people smoke cigars or tobacco too. My question for you all is... what is your preferred inhalation method? Do you like to take full hits that fill your lungs and deeply inhale the vapor. Or do you prefer to hold most of it in your mouth, take a shallow breath to get some off of the top.  

New Stuff Acquired And Taste Issues

Hello,

It’s my first message here.

Im not a new vaper, I’m vaping since 2010.

But today I do have a question, I’m troubled.

I used a lot of vaping stuff since 2010, but I was stucked on a Nautilus 2 since 3 years, moving from 0.7 coil to 1.8, depending on my needs.

2 days ago, I acquired a Vaporesso Target PM80 SE.

I tried 0.2, 0.6 and 0.8 GTX coils.

But something new and disturbing is happening : all my favorites eliquids (DIY using concentrate mixes with 10% total flavor) taste strong sweetener, almost only sweetener and nothing else. It covers my entire mouth really fast and it becomes disgusting after a few puffs.

What do you thing is happening ??  

6mg Sub Ohm 0.2 @ 70w Too Much?

Hey guys,

I’m new to vaping. I have been a heavy 2 pack a day Marlboro light smoker for 20 years. I recently got into vaping and so far it has been an amazing journey!

I started with a small pod device (Caliburn) with 16MG nic salt. I found that I was still not able to quit smoking. I went back to my local Vape shop and got some 20mg nic salt juice, and that was too strong! It made me dizzy and confused and I just felt unwell. Even though @20mg I was getting a lot of nicotine I still wanted to smoke a cigarette.

On a whim I decided to give sub ohm vaping a try. I got myself a Lost Vape Thelema DNA 250c + a Freemax Mesh Pro 2 tank. I opted with 6MG freebase juice at 70/30. And sure enough it worked! I was able to quit smoking and have been smoke free for a week now!

My question though, is 6MG freebase nic @0.2 ohms (dual mesh), 70-80 watts too much? I feel fine for the most part and my cravings for cigarettes are under control. However from what I’ve read (and what the guy at my local Vape shop says) is that for sub ohm vaping you generally should stick to about 3mg of nicotine.

I know everyone is different, and you should do what works for you. But I’m just worried that with the large amount of Vapor I’m producing 6MG might just be a little risky.

I Vape quite a lot (200-250 puffs a day) and probably somewhere around 15-20ml of juice a day (at 0.2 ohms @ 70w the juice burns pretty quick). As mentioned above I generally feel fine. However sometimes I do feel a bit out of breath and like my chest is heavy. This could be gas (perhaps from inhaling so much air?). Or it could just be me adjusting from cigarettes to vaping. I don’t feel nauseous or have headaches.

Please let me know your opinions. Would really appreciate some advice from more experienced vapers!

Thanks!  

Long Ago But Back

Dam, I have not been on this site in a minute! Was sitting around thinking about the beginning of all of this and thought; I wonder if ECF is still around? It is and my log in still worked! Seriously, super excited to see this fantastic forum is still alive and kicking! I learned literally everything I know on here and am looking forward to getting back to some straight up vape talk! I have truly missed this site. Help me jump back in here, how is everyone? Who’s who today? I’m listed as a vet (and that’s true for sure) but I feel like my first day on here back in 09! I don’t know anyone now.