New Mod And Tank For 10 W Vaper

Hi everybody, I have lost track of new vaping gear and need an advice.
Finally one of my mods died. The newest one, Joyetech eVic Primo. Bad from the beginning (because of its faulty protection) it just stopped working. Another mod should die soon. It is a clone of iStick 30, 4+ years old. It's my best mode, but its battery already is at about of half capacity (after about 1500 charges).
So, now I use iStick 30, iStick Pico 25 and iStick Pico. Tanks (from best to worst) Kayfun 5, Siren 2, Ammit, OBS Engine NANO.
I need a new mod and, possibly, a new tank.
Thanks for reading.  


Similar Content



Melo 5 Tank On Istick Pico?

Does anyone knows if the Melo 5 tank will fit/work on an iStick Pico?  

Istick Pico And Nautilus 2 S, Options And Alternatives?

Greetings to all

Having quit cigs, I am alternating With Jf Minifit*20mg Nicsalt for outside and nic craving, and Aspire K4*3mg regNic at home, because as it leaks and, at just over 12cm, too big, annoying for pocket. K4 is great to vape and at length with low nic, since I do sometimes just need to keep puffing, and I am worried about how much I use the minifit with the 20.

I am hoping y'all'll be able to advise and help. The following is a rather stretched permutation of a similar thread (with older gear and less details):
Will the Aspire Nautilus fit the iStick Pico?

Looking now to have something with the (1)dual function, to gradually lower the nicotine while shifting the settings to keep things cofortable and satisfying. In other words, I am seeking to have something that can do both 20mg Nicsalt and Subohm.
(2)Size (averse to large devices) and (2)leakage are priorities. So is (4)ease of filling and coil replacement. In addition, if possible, I would like to exclusively (5?)keep with salts (even as I lower the nic).

The boys at the store recommended istick pico + nautilus 2s. Does this setup work for the numbered and underlined above? Do the pieces fit? If so, can I use the sub-ohm coil for low nicsalt or is the material of the salt just bad for sub-ohm regardless of nic level?

Which is easier to fill/change coil: nautilus 2s standard or TPD? ANy other differences? Is the TPD available in Europe?

Is nautilus the only tank with the dual function?

Is it worth having two tanks to be able to keep shifting? Whether Nautilus 2s or another? And is there some sort of bag or case for my stuff to keep in my backpack (saw a lady with something for her stick in her purse once)?

Given the purpose of ease, Should I consider the Orion Lost vape, or is the ability to lower the wattage just not enough, and I need something with high-ohm. Keeping in mind I don't like anything higher than 3mg on the Aspire K4.

What about Chubby Bunny and Magico? Easy alterntives that vape better than Minifit, have a little more options but not too complicated and still easy to use, fill, etc?

I noticed, pico is small, together with 2s they'll be bigger than K4. Given the purpose of size, what about the istick pico baby + nautilus mini? Do the sizes fit and can nautilus mini take high/sub-ohm coils?

Is nautilus mini easy to fill like 2s or is it like the old nautilus requiring cap removal?

On their website, I read that nautilus mini has 2ml capacity and standard/tpd 2.6, but in the thread above it said the standard has 5ml. Who's correct?

Why didn't the boy recommend other setups? I came across istick pico X and Snowwolf mini and what about Aspire own mods like the one that comes with nautilus; the Zelos, K1 Stealth or Reax Mini?

Finally, is there antyhing I should know about VG/PG percentages with Salts and any of the devices above?

Thanks in advance!  

Quick Question But Not Sure If Anyone Can Help Me

So I had an OG iStick with an ehpro kayfun v2...good set up worked well. Now the kayfun is stuck on the mod and I can't get it off. It turns slightly and makes a "click" sound then nothing. Anybody ever have this happen and fix it? I'm assuming maybe I had the airflow screw too far out and it could've dropped into the airflow grooves on top of the istick? Or maybe the threads finally just locked it up on me? I bought an new 50w istick, but I want my kayfun on it. Prob gonna just go buy a Lemo, but if I could manage to get my kayfun back I'd still like to use it in my rotation. Any thoughts?  

Bow 30, Clone Of Istick 30

A week ago I have bought Bou 30W which is a clone of iStick 30.

Bou 30W Style Variable Wattage Box Mod Black

On page of Angelsigs it is written it can go from 2W to 30W, and it is a lie. I hoped it is improved version of iStick, but seems it has the same circuit in. It starts only from 5 W, and quite often I like to vape at lower wattages (you know, to suck on pacifier without really spending any juice). And it is a bit too small to be comfortable. Vamo is still better, and I can just replace batteries instead of charging the whole device (where are phones with replaceable battery?)

Otherwise it feels very sturdy, buttons are solid, battery life is good. I have not used iStick, but think there is practically no difference.  

Low Vapor Output From Istick 50w

So I pulled the trigger and decided to upgrade my istick 20w and get the istick 50w.
Came fully charged so threw on my nautilus and started vaping and I have to draw really hard to get some vapor. I've tried different wattages from 7-18 and the results are still low vapor. Not no vapor but not as much as I should be getting. So I thought it was a bad coil or atty so I threw the same tank onto my istick 20w and worked perfectly with a ton of vapor.
Threw it back on the 50 and made sure the counter was counting and took a vape for 7 seconds with about half the vapor from the 20w.
Am I doing something wrong?
thanks
Brian  

Istick Issues

I just got my new istick 20w and I'm having some problems. I'm really new to vw mods I've been strictly mech for over a year. so I put on my kayfun with a 1.4 ohm build and it maxes out at 12w any higher and I get a protection message. I put on my patriot at 1ohm and it won't fire at all. I cant figure out why it won't go any higher.  

Istick 20w With Subtank Nano?

Hi all

So I'm currently set up with an iStick 50w and a SubTank (big un) all thanks to you guys im in Vape Heaven.

want i want to ask is this -

My Girlfriend is now getting more into Vaping and hasnt touched a Cigarette in quite some time. she has an iStick 20w and loves it (cos its pink -_- )

but she's not liking the tanks (aspire Viva Nova, one with a cross on it (completely forgot the name) and a protank 3 mini)

Shes tried my subtank AND LOVES IT! she's liking the airy draw and the ultimate flavour.

My question is she likes to vape at around 3.0-3.3V. Will the Istick 20w be able to SAFELY handle the protank nano with the 1.2ohm coil in?

I've told her she may have to up the power abit but other than that she should be fine right?  

Finally! No More Urges To Buy New Gear!

Finally! I've tried so many sub ohm tanks with a shelf of them to prove it along with box mods and I've found my perfect set up that I'm 100 percent happy with. That urge of "must have more" and "must have the latest and greatest" has finally subsided after 100s of dollars spent. I can finally relax on hardware and focus on enjoying good juices. I still stay up on new tech but I'm finally happy on my go to juice vendor and hardware. Oh what a good feeling!

My goto set up: Atlantis V1 with cotton coils and 5ml upgrade and ipv mini 2 at 32 watts. Any higher then 32 and the vape is too warm to enjoy. To justify this, I personally own the following:

Atlantis V2
Subtank
Subtank mini using both Occ and rba
Delta I I using both coil and rba
Lemo
Lemo 2
Arctic tank
Starre tank
Herakles tank
Kayfun
Kay fun v4

Ipv mini 1
Istick 30
Istick 20
M50 with 65w upgrade

My go to juices are all from itcvapes. 20$ for 120ml for the win.

Time to sell off old items or give them to friends to help them quit smoking.

FYI I'm so busy that rebuilding isn't an option for me. It's much Cheaper, and I have a ton of kanthal in different gauges with a big bag of Koh Gen do, but I'd rather pay for convenience of coils.

Wonderful feeling!  

Istick 50w Resistance Reading .2ohms High

I have had my istick 50w for about 24 hours now. I the issue I am having is that all my 1.8ohm tanks are reading 2.0ohms on the display of the iStick. This is the case for my Aspire ET-S and Nautilus Minis. On two occasions the Nautilus tanks have read 1.9. Never 1.8. Even with brand new coils. I get the same result on 4 Nautilus Minis and 3 ET-S tanks. I get the same results with the mod turned off when I screw on the tanks as I do with the mod turned on. Any ideas or suggestions?  

1.2 Ohm/3.2v Battery .... Recommended Settings?

Sorry for not doing the research, but tomorrow I am leaving for a trip and appreciate any quick advice.

Yesterday, after purchasing a much-needed new tank, I finally realized that I had to semi-retire my Provari's. Evidently all is about wattage these days and not voltage.

At a local B&M, I grabbed a new iStick 30W and a Kangertech Subtank Nano, found a few Ohm's Law calculator sites, but I am still skeptical about the different setting recommendations I am getting.

Obviously, I do not want the iStick to blow up, but I am not getting the same vaping pleasure I did with the old-style provari and older tanks. Same eliquid, but zero throat hit and little vapor.

Can somebody please just provide me with the settings I need to use for this week?

I PROMISE to come back and contribute more again to this great community.

_______
Tobacco-free since March 2012 -- ONLY because of electronic cigarettes and the great ECF forum
_______

Thanks much,
Sea