Mixing Nic From Different Vendors

I've got 2 x bottles of Carolina 100mg PG liquid, both about 1 year old. I started mixing liquids with it today, and noticed that the nicotine mixture has begun to oxidize. This liquid is normally clear, but has begun to take-on a sort-of orange hue.

I mixed 2 x 60ml bottles of Mothers Milk, and 2 x my RY4 w/cheesecake and coffee. The oxidized nicotine liquid gives these liquids a tobacco-like throat hit that I haven't gotten since I quite smoking. It's the one thing that I've always missed about smoking. I could get this when mixing my liquids at 18mg, but never at 3mg.

I keep my liquids in the refrigerator, but I'm thinking I could maybe accelerate the oxidization process, by leaving the liquids unsealed?  

Hi,

Unfortunately they are about to ban nicotine E juice in my country in 6 months time. I was stocking up on my regular E juice but this is not really a long term feasible solution.

Luckily I vape unflavoured, so I figure it shouldn't be too hard to make myself.

I had a bit of a look around and found liquid nicotine, up to 250mg/ml, or nicotine salts, both USP, whatever that means.

Just wondering what the best nicotine product would be for long term storage and quality. If someone could recommend a vendor and product that would be great. I normally vape 70/30 pg juice from Heather's heavenly vapes.

I would prefer a liquid than a salt unless there is a big difference in shelf life.

Thanks for your advice  

Hi,

I just bought a litre of 100mg/ml unflavoured PG E juice.

I calculated that if it doesn't go off it should last me 10 years. It came in a sealed plastic bottle.

I bought a dark amber glass bottle (which I have sterilized) to put it in but I was wondering if it would be better to leave it in the original sealed plastic bottle rather than breaking the seal to put it in the glass bottle? I took the lid off and it has a proper seal over the rim of the bottle like a Gatorade.

Also the glass bottle I bought came with a plastic lid but I doubt it will be 100% airtight.

Thanks for your advice, any other tips would be much appreciated.  

Looking for any good suggestions on battery storage and transport. I've searched around on here and don't seem to see a whole lot of discussions on the topic. Some that I've seen include medicine bottles (free if you have 'em) and the Krazy Glue storage tube

I loved this thought and found it for $1.50 on Amazon (as an add-on) but looking for other ideas. Thanks!

 

Since I do all my vaping shopping online and will soon not be able to get eliquid containing nicotine by mail in the US, can one buy liquid nicotine now, store it and add it to pre made liquid? I know that I would have to probably use one of the apps out there to figure out how much to add to 30 or 60 mg of liquid to obtain a 3 mg amount. I don't even know if this is possible. I don't want to go the route of making my own since I have certain flavors I like from a couple of vendors and can probably not match these flavors doing it myself.
I have been vaping for 6 years now and am afraid that I will be forced back to smoking cigarettes when I run out of my current supply.  

Hi I have a question about nicotine strength in my juice for sub-ohm vaping: I've only started vaping my tfv12 prince smok tank 4 days ago, so total newbie- used to do only mtl before that. I'm currently using Q4 coils, 0.4 ohm, vaping at 50-60 Watts: quite happy with a cooler vape, I tried them at 70-90 but slightly too warm for me, maybe in the future it will change.
Majority of the sites and youtube videos that I came across where sub-ohm vaping was discussed said that the maximum nicotine strength used when sub-ohm vaping should be 6mg/ml. So I've mixed a few juices, 70/30 vg/pg, ranging from 3-6mg nic. I noticed that I'm chain-vaping with very little nicotine hit. But i kept nicotine cravings sattisfied with my mtl device used simultanously.
Today however, I wanted to check something. I've mixed some 65/35 VG/PG liquid for my gf's smok nord pod a few days ago, with nicotine at approx. 11.5mg/ml, so I popped it into my prince tank to try it. Expected to choke on it but no- it vapes great at 60 Watts, tastes good (carnival sherbet concentrate + a little bit of strawberry cream concentrate added) nicotine hit: I can feel it, but unless I go crazy it doesn't make me nic sick.

Is this normal? Why do people recommend going max 6mg nic for sub-ohm vaping? Is it because they aren't recent ex-smokers or they never were smokers, and just use low nic liquids at their stage of vaping? Thanks  

Hey guys,

So I ordered some 0mg bottles of eliquid 60ml online (full bottles not short fills) in a flavor that I have been vaping for awhile.

I took them to my local Vape shop and asked my usual guy to add nicotine to them. I normally smoke 6MG on my sub-ohm set up @ 0.2 ohms and 70w. So he added 6MG like he usually does.

When I got home it tasted weird. I would t say it was harsh, but it definitely had more of a throat hit / kick to it.

Normally @ 6MG I can pull / suck until I run out of breath and it comes out smooth. However this time I would hit it for 2-3 seconds and had to stop as it felt over powering.

As mentioned it wasn’t too harsh, and didn’t make me cough or anything. It just felt stronger and after a few puffs I felt a weird peppery feeling in my throat. Like I had just ate a spicy meal or food with a lot of pepper.

What could have gone wrong? I’m guessing 1 of the following things:

- He put in too much nicotine by mistake and more than 6MG? I called him after the fact, and he swears he put 6MG using the same calculations as always.

- He used the wrong type of nicotine? I normally always use 6MG freebase. Maybe he put in salts?

- Normally I give him 60ml short fills, this time I gave him full 60ml bottles. So maybe that screwed up his calculations of how much nicotine to add?

- His nicotine has gone bad / oxidized? Although the color of the juice looks normal and isn’t overly dark or red.

- Maybe I just need to let the juice sit for a few days for the nicotine to absorb into the liquid better? (Although this has never been an issue in the past)

Luckily I also asked him to add 3mg and 4.5mg to a few bottles (for my wife who prefers 3-4.5mg). I tested the 3mg and it tastes fine and smokes smooth. Although it does feel like the nicotine is a little too low for me. I then added some 4.5mg to my tank (which was half full of 3mg) and it seemed to be perfect. Like the 6MG I was used to in the past.

As this point I’m thinking to just get some 120ml chubby gorilla bottles and mix 60ml @ 3mg w/ 60ml @ 6mg and hopefully that will do the trick.

If anyone has any thoughts or ideas on what went wrong please let me know.

Thanks!  

Hey guys, pretty new here only one previous post...
Was having problems with my K100 & Mini Nautilus combo for vaping, that's why I originally signed up!!
Talked about it with members & found my K100 was ultimately the problem, upgraded to a IPV Mini & I'm vaping like a king

& that's the issue so now I'm vaping about 6ml a day, I just smashed through a 15ml 12mg nicotine Cinnabun & 15ml 0mg nicotine Cinnabun.
(Mixing the two gives me great flavor & the right amount of nicotine hit)
So the point of this post was...

Where do you guys buy Juice?
( I usually buy from a local smoke shop about 10$ per 15ml )
Is that expensive ?
I've looked online & factoring shipping price I need to buy 3-4 bottles + to be saving money & I've bought online before, ( ordered 60$ in samples & the flavors were horrid in my opinion I guess that online vendor just isn't my taste ? )
So I'm just wondering is 10$ every 2-3 days the best I can do juice wise ?
Or are there some trusted online vendors you guys can agree on with good flavors & good prices?

I'm currently smoking from a local vendor I believe ( MadHatters )
& love there flavors.
 

Now that most of the stocking up is behind us, what would be a suitable procedure for maintaining items in storage?

For regulated mods, keeping them dry is probably all that is needed. But should the sealed wrap be removed to avoid condensation inside?

How about atomizers? I had a problem in removing the cap from a used RDA after it was in storage for two years. Had to resort to using WD40 because the o-rings became adhered to the metal surfaces. I ruined the o-rings in the process. Would it make sense to go through and disassemble/reassemble things at certain time intervals? Should items be stored disassembled? Will o-rings become permanently compressed over time? Maybe put some vg on the o-rings for storage? Or should o-rings be removed? It's already been said that things should be cleaned/soaked before going into storage.

I have one RDA that gets sticky while in use. I remove the cap about once a week, just so I can.

What do you do? What do you think?  

Hate tooth extraction.
Have to work around vaping for the next several days. Thinking about 50% 100mg Nicotine in VG, 25% PG, 20% plain VG, and maybe 5% of a mint flavor. Not for vaping, but to apply a drop it two directly onto the tip of tongue to avoid nicotine withdrawal.
Any ideas ?