So, I have a few coils that are barely used - I took them out of the tank after one flavor and rinsed them out, then set them aside to dry. Is this okay to do or is it bad practice? I just don’t like mixing certain flavors and have an OCD habit of wanting a coil dedicated to a particular flavor...
Hello knowledgeable guys and gals of ECF!!!
I like to switch flavors a lot, perhaps a little to often. I have read here that flavors can linger within the wicking material for quite some time. So long in fact that my habit of switching flavors doesn't provide enough time to work the old flavor out entirely. I have a bunch of extra coils for my nautilus mini and my Subtank mini. For accurate flavor I will switch out a coil for a flavor change. So I essentially have a coil for each flavor.
So here is my question!
How can I properly care for, or store these coils when they are not in use? Right now I have them sitting in a little dish of water so the juice doesn't dry up and gunk them up. Will this method harm them? Can I leave them in the water for a day or so, perhaps a few days even?
Thanks for taking the time to read this! I hope I'm not damaging my coils!
First off, I would like to say that I’m very new to vaping. I started off with a JUUL, then a Smok Novo 2, and eventually got sick of buying pods.
Now I have a Hellvape MD, and an Ares 2 - the first provides better flavor, but it’s still not comparable to what I was getting in my pod systems. I just recently purchased a BP Mods Pioneer, and I’m hoping that gives me better results. I’m using an Aegis Mini for a mod.
I’m trying to figure out what I’m doing wrong, because it’s really frustrating to spend all this money for worse flavor, when I was hoping it would let me save money.
I have about 40 bottles of salt nic flavors that are 50 or 35 mg, and a couple 3mg freebase I bought (120ml for $7 seemed like a steal). I would really like to get away from the salt nic, but I seem to get even worse flavor from the 3mg.
I’m using 2.5ID 28ga SS316L round wire from Master Wire Supply (I have a spool) with Puffs Organic Cotton. My coils are usually .7ohms, but I’ve tried up to 1ohm. I’ve also tried 1 ohm Vandy Vape Superfine MTL fused claptons, and experienced similar results.
I’m using the MD with the most restrictive airflow settings (3 small hole airflow disk), low (2-3) adjustable AFC setting. I have my coil as low as possible to the airflow, and I have thinned / fluffed my wicks.
I haven’t tried adjusting the airflow below the coil on the Ares 2, because the video instructions say wide open airflow below the coil is the best for flavor (I have found the opposite to be true for the MD).
Can someone provide me more insight?
Will 2mm ID coils with the same amount of wraps taste better than 2.5? Do coil ohms do anything for flavor, or does it only change how fast it heats up? Will I lose flavor if my coils hang outside the diameter of the airflow disk?
Is there a certain type of coil that would give me better flavor than regular round wire?
I use TC at 420F 20 watts
Any kind of feedback is appreciated and if I left anything out or you have questions about my set up that could help me out please ask! I’m at a loss on what to do, and it seems like no amount of research is helping
To keep this short I tend to change flavors in my delta 2 quite often and have a large assortment of flavors. That being said I never have enough replacement coils to keep switching them out fresh for flavor changing. I do wash my tank every time I change flavors but I don't wash the base and coil over fear of messing something up since I don't tend to let them dry before I decide to start vaping it again. I usually don't think about the transition flavor however I made the mistake today of switching from a caramel macchiato to a vanilla banana wafer pudding so as you can probably imagine the flavor is complete trash.. With all that cotton in the delta 2 coil, how long should I expect to have to vape like this? Ten toots in and I can still taste the macchiato like the cotton is reserving it just to teach me a lesson.
Hello
I have the wotofo serpent rta top airflow single coil tank now and I just purchased the augvape druga rta. Flavor is 100% better in the augvape drugA rta but juice leaks out the bottom of the tank every time which is why I have to stay with top airflow as it never has leaked on me. So I’m looking for a top airflow rta single coil . I typically vape between 20-30watts so I don’t need a powerhouse. I just want the flavor and don’t care about clouds. Can anyone recommend the best top airflow rta? The wotofo serpent works well but it takes a hit on flavor. The serpent only has 2 small air holes around the coil area and I think this is why it isn’t producing a good vape. I was looking at the Zeus? Augvape intake of the dual one? Or any others anyone can recommend ?
primary goal: outstanding flavor
No leaking
Lots of air holes around the coil
thanks for your time
Hey Guys,
I have been learning the ropes of RDA vaping, and so far I absolutely love it! As the title states I’m wondering what coils (FC, Aliens, etc) Would be best for flavor and vapor output? I’m currently running some Wotofo 0.33 Fused Claptons (~0.17 in dual coil) @ 60 Watts. The flavor and vapor is ok, But I’m looking for a little more. Maybe something I could run at a slightly higher wattage and get more vapor / flavor?
Any help would be greatly appreciated!
Thanks!
I recently picked up an infinite origen v2, my first build was single coil 2.4mm and it was not good on flavor, next build was dual coil 2.4mm at .5ohms, it was better on flavor. No matter what single coil build I try the flavor is just not there. Any suggestions on great flavor builds???
So my husband and I bought two zenith II tanks and inokin 1.6 ohm heads. My husband has not been impressed with the lack of flavor that it produces. Mine has been ok but I’m wondering if I need to clean the coil often? I usually use a nautilus tank and coil that I would clean each time I added liquid. Any help is appreciated as we bought 13 packs of these coils
sup, thanks for reading . I'm vaping for 3 years now, never had problem until now. I taste saltiness on my tongue after vaping for more than 10 seconds. I thought it might be coil so I changed them all. Maybe juice so i tried different ones different flavor. same thing.
I vaped for 3 years just Pomango and Menthol. Never had that problem. Recently I got into DIY Mixing so i ordered 14 different flavors and started experimenting. Mostly Peach, Mango, sweet mango CAP, Green Apple, Pomegranate. never went over % than whats recommended. After sweet Mango flavor CAP 5% solo flavor it started. I thought maybe its the mango flavor so Itried others and same thing, even Menthol. So its definitely something with my taste. I tried to eat lollipop candy and its there but barely noticeable because of the sugar from lolipop. Hmmmm.... Is it because i started experimenting with other flavors and I have so called"Vapers tongue " thingy?
When first time I tried mango and green apple , OMG it was spectacular taste!!!after few weeks now just salt mix with touch of sweetness and a litlle flavor on my tongue and I do let it go thru my nose and stuff too , to get most out of vaping experience, menthol is the strongest from them all that stays but its not the same as it was few weeks ago.
anybody had same issue? I found the thread from 2011 the guy had same issue.
18 days vaping - all juices now tasting salty sweet, but not in a good way.
I do feel,menthol,peach and other fruits flavor for 3-6 sec just after 10 seconds it becomes kinda salty on my tongue and lets see, umm upper patella of the jaw you call it? yeah... and im loosing flavor, very frustrating....
anyone can explain that or had similar experience?
thanks
I recently upgraded to the Istick 30 and Subtank nano, and kinda want to try out a dripper, but do not want to build coils, check ohms etc. Are there any drippers available that take pre made coils? I guess I can wick if needed, but I'm not ready to jump into coil building yet. And if anyone could explain the benefits of dripping over a tank system, that would be great also I know changing flavors without dumping a tank, but any flavor or vapor advantages?
I am trying to get the best flavor with the best single coil build.
Objectives:
Flavor
Smooth Vapor
Materials:
Kanthal Wire
35mg Nic Salts
I have noticed that either depending on the diameter of the coil or the spacing of the coil wraps You get a different kind of vape hit. It seems like higher gauge wire produces a smoother hit. And then couple that with a small diameter coil build, plus squishing the coil together to remove all coil spacing results in the smoothest possible vapor.
Can anyone confirm my findings? Or does anyone have any tips because I have still to replicate the smooth hit from clearomizer sub tank cartridge's that are non mesh. I am starting to think this is because the cotton is wrapped around the outside of the coil instead of being shoelace through the middle of the coil.