Does Anyone Know...

GS Air coils/GS 3ml tanks.
I Googlefied this and Did see One place that said A worn out tank could make coils not last as long. (Sounds near fetched to me...)

Can an old tank start Causing premade coils to show Low ohms, like. 05 ohm?

I am pretty sure these are factory coils not FT copycats.
Bruce in Ocala, Fl  

Hey all,

So, I've been really happy with my new setup (iStick 50w and 30w, Nautilus and Mini Nautilus). Everything has been working smoothly, but I have a problem with the replacement coils I purchased (and cannot return).

Went to go change out the coil in one of my tanks this evening. Filled the tank up as usual, made sure the air shaft and drip tip were clean, screwed on my new coil, filled the tank, and let it sit and wick up for half an hour. Took some pulls without firing, dropped it to 8w (to "step up" and prime the new coil), and immediately got a nasty burnt hit that I can still taste an hour later. Unscrewed the tank to see what was wrong, and noticed the wicking material was bone dry.

For the longest time, I could not figure out what happened, why it wasn't wicking...until I looked closer. The e-liquid holes on the replacement coil I have are TINY! The coils that came with the tanks have holes that are at least twice, maybe three times the diameter. The holes are so small that my e-liquid will not even enter them to soak the wicking material. I checked the serial number scratch off on Aspire's site and both boxes of replacement coils I have came up as authentic.

I'm displeased. $22 down the drain, now I have to rush and find a dealer who has the "correct" coils. I cannot use these coils whatsoever, and the dealer I purchased from does not accepted returns on atomizers.



On the left is the coil that came with the tank (both of my tanks came with this exact same coil, and two replacements that look exactly like it, but I've used them up and am on the new ones). On the right, the coil I purchased in a replacement pack of 5. You can see they look nearly identical, except for the size of the wicking holes. Also, the piece at the bottom seems a bit more flimsy, as you can see in the picture, it's not exactly straight with the rest of the atomizer.

So, can anyone point me to a dealer that has the coils I need? I'm afraid of ordering from somewhere and getting the ones on the right, which are useless and do not soak up any e-liquid whatsoever.  

Hey everyone,

So I've had the crown 4 tank for about 6 or so months and switched to mesh coils a couple months ago, off and on. The reason being is that it seems with the 4-packs I've bought, it's almost guaranteed that 2 will be either VERY picky about how tight i screw the tank and coil on the base. It has to be JUST tight enough where the box gets an ohm reading, but any tighter it looks like it shorts out (the ohm reading blinks 0.00). I've never messed around with the coil before, i usually just end up going back to the traditional coils and dealing with the lacking taste. Any suggestions? I'm using the sub box mini v2 if that makes a difference.

Thanks!  

Hey guys whats up. Well I had gotten the Sub Mini tank, the first tank I got was a dud. I had nothing but issues with it since day one. Coils went bad in 1.5 days both coils, then the rba deck was giving my sigeili issues and errors.

So I sent it back, They replaced it, and I now have Version 2 as they say. This tank has 2 air slots and different Holes in the tank. I used the Stock .5 coil but was just getting wayyyy too many dry hits.. So I went to the RBA deck, been using the coil that came with it, and I have 100% organic cotton. So I been using that, but now I am getting Dry hits with this thing!!! every 4th hit Is Dry!! I have to cover the holes and pull to get teh cotton wet again, and then 4th hit shes dry again.

What is going on here? Anyone else have issues like this? I am really getting fed up with this and ready to just throw it away. What can I do about the situation or why is this happening?

E-juice = 80/20 Clear Liquid all fruity flavors 3MG  

So admittedly I dont know if this counts as m
odding when people are building actual boxes to fit atomized and house batteries from scratch but what's everyone think about this addition its a new use for something I dont use anymore the top to the tank of my evod 2 built by aspire a just kinda screwed it into the wide gauge tip of my baby beast sub ohm tank I'm using the .15 mesh coils and tightening the draw and I find that I can get quite lot of flavorful vapor at 40 watts and 2.70v set to hard hit on my aspire skystar

Curious what anyone might think of this and if anyone maybe has some other easy DIY flavour chase inovations  

I am happy to say I have been smoke free for a little over a year now, much credit to you good folks. As with many things a person tends to look for the Holy Grail, but that just isn't realistic... will I ever learn!

Anyway, looking for some opinions on some purchases. I have a Bliip, a Smok AL85, a Pico and a Nexus but would like to add/improve my collection. I like, on paper, the paranormal but price is an issue and it's probally more than I need. What I have learned in the last year what I like/use is Triton .4 ohm SS coils in the Melo. RTA's are good but find I'm lazy and they require more maintenance so to speak and I can get a month out of the Triton (a weekish out of my RTA builds).

I would like some suggestions on a mod that has at least 2 18650's, more so for fewer battery changes than available power. I think I would like a mod with 3 21700 cells (unicorn wings) ideally because portablity not an issue as I can use my other ones and I sit at my desk most of the time. One reason I like the Triton coils is lower power thus longer bat life. Also a suggestion on a tank that holds more than 2mm thus again fulfilling my human laziness. Size of tank doesn't mater (or so I think!). Also would like a tank that uses long lasting drop in coils with SS option that doesn't cost an arm and leg and readily available.

So, I want everything for nothing! Lol

Many thanks for any suggestions : )  

I had thought Segelei was one of the better tanks out there but seems that coils burn out easily. Been using below stated wattage for the most part. Recently got a freemax tank and the difference is night and day. I have a fuceli mod. 2 batteries 20 amp (25r or similar... All are either sony.,samsung or another recommend brand) and have no issue using at 80watts. The coil is not having issues tank is easier to filll(though my dumba** figured out that top slides by accident). I dont know the max that the battery can go to but if i believe with info i got here before with 2 batteries i should be good  

I am looking back at my spending this month, and I've realized the thing I used to get off tobacco and save money is now my full blown hobby and obsession. Bad? Nah - but it was eye opening and shocking! Recently (past 2-3 months) I've bought (this is just hardware. If I listed juices, this post would just be dumb long)

IPV Mini
IPV Mini V2
iStick 30w
Nitecore I4 charger (I2 became not good enough)
4x efest 18650 batteries (to add to the 4 I already own)
case to carry them all in while on the go
Atlantis 5ml extender
20 Atlantis coils
Delta II
10 delta II coils
Delta II RBA
Sense Herakles Tank
10 Herakles Coils
Horizon Arctic Tank
Pre-ordered Lemo II
Melo Tank
22ga, 24ga, 26ga, 28ga kanthal
ceramic tweezers
eleaf atomizer checker
wraps to protect/customize all my mods
Vape Life Drip Tips
Subtank Mini
Subtank mini OCC coils
Kayfun 4
Coil master kit
Screw driver sets
Torch
Butane for torch

Now I want the High Voltage tank

WHAT AM I DOING?! THE STRUGGLE IS REAL /endrant

My favorite so far: IPV Mini II rocking the Herackles tank at 55w - mmmmm

 

Considering getting the Sensis but wondering if the coil +, refresh and f0 modes really do improve coil life. I would probably use the adapter with the zenith tank as well as the pod so especially interested to hear anyone’s experience using it this way and whether you’ve seen the life of your coils noticeably increase. Thanks  

I recently upgraded to the Istick 30 and Subtank nano, and kinda want to try out a dripper, but do not want to build coils, check ohms etc. Are there any drippers available that take pre made coils? I guess I can wick if needed, but I'm not ready to jump into coil building yet. And if anyone could explain the benefits of dripping over a tank system, that would be great also I know changing flavors without dumping a tank, but any flavor or vapor advantages?