Novo 2 Question , Feedback Please?

I bought some novo pods from vaping.com on Friday. They have already shipped and are in my state. Their website says that it is going to require age verification but I’m not going to be home when they deliver. Plus I don’t see anything about age verification on my tracking info. Am I going to need to be home for this? Hopefully they will be delivered soon.  

Hey gang,can you please help me out. I ordered 3 bottles of freebase Pachamama Fuji,coastal cloud mango berries and hesiwnberg the Berg for the NOVO2,will it be able to handle the juice even though it’s not salts? I have 1ohm mesh pods and I have 1.4 pods here,I’m debating if I should cancel my order . Any thoughts will be much appreciated thank you !
The juices are all 70/30  

Hi Guys,

So I originally had a nitecore i8 charger that I used to charge 8 x 18650 batteries. After using it for a few days I started noticing that it made a weird ticking noise and got VERY hot on the bottom. Needless to say this made me quite uncomfortable.

So I exchanged it for a Xtar VC8. So far it’s been amazing. No ticking or weird noises and it doesn’t get hot. It also comes with a nice screen that shows you some details about your batteries. This is what leads me to my question.

I noticed when charging my batteries most of them show as roughly 3.7v but others show as 4.1v. Also the longer they charge the higher the number goes. Is this normal? Sorry I’m a total idiot when it comes to batteries and voltages etc. If anyone could clue me in i would be very great full!

Thanks  

I was building my Avocado RTA today and for my second coil, I noticed that I must’ve wrapped it backwards as the upper leg went in the lower slot (the other coil had the top leg going in the top slot and bottom in the bottom). The tank reads on the ohm meter just fine. I am just wondering if I should re-wrap the coil so that the legs line up with the slots or if it’s fine as is? I hope this question makes sense. Thanks in advance!  

So I just purchased the 70w version, part from the chipset difference is there any other differences. I’m looking at customising and have noticed a lot of panels etc suitable for the 70w aren’t suitable for the dna60 version. So I’m a tad confused.  

Looking for a compatible battery for the Aspire CF VV. It’s been discontinued and because I already have 10 Clearomizer tanks and 5 boxes of the BVC Clearomizer Replacement Coils, I’ve been looking for some time for someone to answer the question of what battery I could use to replace the discontinued CF VV 1600mAh
Thanks. <3  

I purchased a Vaporesso Swag II.
It comes with two coils. One of them is a
0.15ohm GT4 Meshed Coil - rated for 50-75W, best 60-70W I liked how it tastes.

The Swag uses one battery only.
Is it safe to use Samsung 30Q 15A batteries and run the Swag at 65W?
If not, what battery would your recommend in order to use it safely at that wattage?

I’m asking because I have always considered the “rule”: maximum W = 3XA  

I am looking for a dual 21700 mod. The available ones, I probably will buy but, there aren't many to choose from. There are several single 21700 mods. My question is how long (on average) will a single battery mod charge last (I know this question is subjective). I vape around 65 watts, most of the ones I have seen online are rated 100 watts. I do not want to leave home and my mod die out because it was a single battery mod. I know I could carry a spare charged battery around, I just do not want to have to. Thanks  

I ponder that question when I read the Shipping Ban issues as well as the requirements ..

Will ECF become a hotbed of Member to Member transactions VIA the classified section .. ?? Will R&D on new hardware come to a near halt .. ??

Will some folks eventually just throw the Vape towel in when their supply runs out .. ?? Will new Vapers begin to slow coming into the fold .. ??

Will actual B&M Vape Shops thrive .. ??  

Hey guys, sorry if I post this in the wrong place, but I didn't find a sub forum that seems appropriate.

So, I have a BCV Surfrider clone (hybrid) and it has been working great but all the sudden this last weekend I noticed one of my batteries just stopped working.. not a big deal. So I put in another battery. Still not working. So I was playing around and I noticed that my button got extremely hot. I took the battery out and noticed that it was hotter than I've ever felt.

I was playing around with it to see if something is wrong, but everything seems fine. I accidentally put in the battery backwards and it worked fine like how it used to.

Anyone have any idea what is causing this?