Hey gang,can you please help me out. I ordered 3 bottles of freebase Pachamama Fuji,coastal cloud mango berries and hesiwnberg the Berg for the NOVO2,will it be able to handle the juice even though it’s not salts? I have 1ohm mesh pods and I have 1.4 pods here,I’m debating if I should cancel my order . Any thoughts will be much appreciated thank you !
The juices are all 70/30
I got a great number of responses on my last post, with tons of useful information, so here’s another question I have for you all. What is the best type of juice for flavor in a MTL RTA?
I’ve found that lower mg salt nic usually tastes better than its higher mg counterpart - I.E. a 30mg and a 50mg bottle of the same juice will taste better in the 30mg option.
I’ve read about people smoking 0, 3, and 6mg freebase in pod systems, so I bought some myself to try it out in my MTL RTA (the lady at the vape shop said 3mg would have a lot more flavor than Nic salts).
I’m not sure if I somehow got a bad batch of juice (I have 4 different flavors/ 2 different brands so idk the likelihood of that) or what, but it doesn't have a prominent taste.
Ive tried from .6 to 1.2ohm coils with 28ga stainless steel single round, as well as some 1ohm mtl fused claptons. Is it possible to make the juice work with my current set up or do I need to buy different gauge wire and up my watts? I’m not interested in heavy cloud production, just flavor.
Are there any pods or AIO that handle high levels of PG (50 to 100%)? And any suggestions of what to do with the Suorin Air I can't use?
I literally just got my order, a Suorin Air and after opening the box, the insert lets me know its useless to me. I didn't remember to factor in types of ejuice when I was researching vape pods. Apparently it won't do well with anything less than 60VG/40PG and my lungs can't handle that ratio. The most I can do is a 50/50 blend but since I've been making my own its easier to just do pure PG. Especially since all I make is menthol using crystals.
As the question speaks for itself, I’ve run into this scenario a few times specifically with vype. Every now and then, every puff since the first one tastes like a burnt and already used coil. It seems to happen in 1 in every 5 pods or so. Is this just bad luck, or is could it be a possibility they are reusing pods to save money, and if it were the case, would it be considered illegal to sell already used pods?
Can someone suggest an online source for purchasing a organizer for my vaping device, pods, atomizers, and juices? I'm particularly concerned about the positioning of the pods, because I'm a weekend only vaper, and during the week I take the pods off and sit them resovoir tip down, as I was instructed to do. Thanks.
Hey guys,
So I ordered some 0mg bottles of eliquid 60ml online (full bottles not short fills) in a flavor that I have been vaping for awhile.
I took them to my local Vape shop and asked my usual guy to add nicotine to them. I normally smoke 6MG on my sub-ohm set up @ 0.2 ohms and 70w. So he added 6MG like he usually does.
When I got home it tasted weird. I would t say it was harsh, but it definitely had more of a throat hit / kick to it.
Normally @ 6MG I can pull / suck until I run out of breath and it comes out smooth. However this time I would hit it for 2-3 seconds and had to stop as it felt over powering.
As mentioned it wasn’t too harsh, and didn’t make me cough or anything. It just felt stronger and after a few puffs I felt a weird peppery feeling in my throat. Like I had just ate a spicy meal or food with a lot of pepper.
What could have gone wrong? I’m guessing 1 of the following things:
- He put in too much nicotine by mistake and more than 6MG? I called him after the fact, and he swears he put 6MG using the same calculations as always.
- He used the wrong type of nicotine? I normally always use 6MG freebase. Maybe he put in salts?
- Normally I give him 60ml short fills, this time I gave him full 60ml bottles. So maybe that screwed up his calculations of how much nicotine to add?
- His nicotine has gone bad / oxidized? Although the color of the juice looks normal and isn’t overly dark or red.
- Maybe I just need to let the juice sit for a few days for the nicotine to absorb into the liquid better? (Although this has never been an issue in the past)
Luckily I also asked him to add 3mg and 4.5mg to a few bottles (for my wife who prefers 3-4.5mg). I tested the 3mg and it tastes fine and smokes smooth. Although it does feel like the nicotine is a little too low for me. I then added some 4.5mg to my tank (which was half full of 3mg) and it seemed to be perfect. Like the 6MG I was used to in the past.
As this point I’m thinking to just get some 120ml chubby gorilla bottles and mix 60ml @ 3mg w/ 60ml @ 6mg and hopefully that will do the trick.
If anyone has any thoughts or ideas on what went wrong please let me know.
Thanks!
First off, I would like to say that I’m very new to vaping. I started off with a JUUL, then a Smok Novo 2, and eventually got sick of buying pods.
Now I have a Hellvape MD, and an Ares 2 - the first provides better flavor, but it’s still not comparable to what I was getting in my pod systems. I just recently purchased a BP Mods Pioneer, and I’m hoping that gives me better results. I’m using an Aegis Mini for a mod.
I’m trying to figure out what I’m doing wrong, because it’s really frustrating to spend all this money for worse flavor, when I was hoping it would let me save money.
I have about 40 bottles of salt nic flavors that are 50 or 35 mg, and a couple 3mg freebase I bought (120ml for $7 seemed like a steal). I would really like to get away from the salt nic, but I seem to get even worse flavor from the 3mg.
I’m using 2.5ID 28ga SS316L round wire from Master Wire Supply (I have a spool) with Puffs Organic Cotton. My coils are usually .7ohms, but I’ve tried up to 1ohm. I’ve also tried 1 ohm Vandy Vape Superfine MTL fused claptons, and experienced similar results.
I’m using the MD with the most restrictive airflow settings (3 small hole airflow disk), low (2-3) adjustable AFC setting. I have my coil as low as possible to the airflow, and I have thinned / fluffed my wicks.
I haven’t tried adjusting the airflow below the coil on the Ares 2, because the video instructions say wide open airflow below the coil is the best for flavor (I have found the opposite to be true for the MD).
Can someone provide me more insight?
Will 2mm ID coils with the same amount of wraps taste better than 2.5? Do coil ohms do anything for flavor, or does it only change how fast it heats up? Will I lose flavor if my coils hang outside the diameter of the airflow disk?
Is there a certain type of coil that would give me better flavor than regular round wire?
I use TC at 420F 20 watts
Any kind of feedback is appreciated and if I left anything out or you have questions about my set up that could help me out please ask! I’m at a loss on what to do, and it seems like no amount of research is helping
74 days without a cigarette so I’m still new to this whole vaping thing.
Started with Juul, got tired of refilling pods very quickly.
Switched to a Smok Nord. Have grown tired of the hit/miss with cools.
Just got my Zenith tank. Went ahead and got the Kroma/Zenith kit and it’s my first non-pod setup.
Like it so far. Only issue so far is there seems to be a lot of juice coming through when I take a hit. When I take a drag but put a thin white piece of cloth over the tip there is a very noticeable amount of brown stain on the cloth. Had the same issue when I got my Smok Nord but I corrected by switching from 50/50 nic salts to a 70v/30p freebase.
Currently Using the same 70vg/30pg 6mg Halo Tribeca.
Using the 1.6ohm coil;
Started at 14 watts;
Dropped to 11 watts and it reduced the juice but also the temp of the vape.
Adjusting the airflow doesn’t really make a difference.
Anyone else having the same issue with the amount of juice coming into their mouth? Is this normal with this type of setup? Did I flood the coil or something? I primed it with 5 drops then let it sit for about 10-15 minutes before taking the first hit.
Will probably limit it use at the house because I don’t want to carry around so much weight in my pocket.
So I've got an Orion DNA system. Pods. And my juice keeps burning my throat even with new pods. The cotton isn't burnt and my juice is salt. Same brand I've been using for a while in fact. But now it's just starting to burn the back of my throat like free based juice. Idk what's up with that. My friend has the same device, and same pods (.25) as me and not only is his quieter, but it doesn't burn my throat either. Any advice?
Hey all, I’m looking to find some more good salt nicotine eliquids to vape on. I’m currently using the Think Vape Zeta AIO with the RBA for MTL. The salt nicotine eliquids I currently use are Ultimate Salts, Viking Vapes eliquid and TRASH candy salts at 10-20mg nic strength in 10ml bottles. I was wondering if there are any other brands to look out for here in the UK. I can’t get hold of any US salt nicotine eliquids cause of our TPD so I can’t get my hands on 30ml bottles that are 20mg+
I’m curious as to why you shouldn’t do DL when using nic salts. I’ve got an Aegis Hero with a 0.6 coil at 15 watts. Even with the airflow closed off, it’s still to loose for a MTL. I keep reading and hearing I shouldn’t use nic salts for DL. The worst thing I’ve experienced so far is a mild headache. The nic salt is a 30mg.
Thanks in advance. ECF is my only true support group and I’m having a really hard time not smoking the stinkiest. Been back to vaping for about a month, and keep telling myself it’s all about baby steps. Not how many I smoke but how many I don’t smoke. I’ve got to quit for health reasons.