Increasing Ohm's On Coils

Hi there,

so I got this idea to reuse coils. My coils are expensive and some people on Youtube reuse successfully because it saves money and works.

If you reuse your coils, HOW do you do it?

Can I use surgical spirit (and water later of course) to clean them?  

Im new to external battery mods but have been vaping for 3 years and I know how to prime a coil with e-juice. I go the extra mile after I prime the coil and let it sit for a minute. Then I fill up the tank put it back together and do not touch it for at least an hour or two just to make sure. I just got my now verified as legit sigelei sobra with the moonshot 120 both of the coils from that taste like those knock off BS eBay fake coils. I started off at a very low wattage and I don't know what's wrong both coils are disgusting. It's not exactly a burnt taste or a dry taste it's like a sour off taste and I can't use them. It also makes me feel like I have something in the back of my throat. What in the heck is going on? Do these coils take awhile to become usable? They're the coils that came with the mod and I verified the mod so I assume the coils are also okay. I even went so far as to try the second coil on a different mod but with the same tank just in case the mod was frying things the very first hit. Can anyone give me an idea of what's going on so I know what I need to do and also if anyone could tell me whether or not the Cascade baby coils will fit in the moonshot 120  

Hi I've been in the vaping industry for years now and have had many tanks over the years both mesh and normal coil, for me mesh was amazing at flavour and for more cooler vape lovers, however I found that normal coils provided more cloud and less juice consumption with some tanks and were able to achieve the same amount of flavour as mesh with the right build. But I still curious as too how many people prefer mesh over normal coils and vice versa and why ?  

I'm so tired of the recent "mesh only" craze. I just don't understand it at all.

I have used roundwire sub tanks for close to 4 years, and can generally get a pretty accurate flavour representation from my juices. Obviously some are better than others, but the og Uwell Crown coils and .4 Cleito coils are pretty stellar.

Recently decided to mix it up and try something new, so i went on the hunt for a new sub tank, only for the market to be completely littered with mesh-only tanks. The only tanks i could find that still use roundwire are from years ago.

I figured i had been missing something, so i picked up a collection of mesh sub tanks, only to be dissapointed by every one of them.

The list was:
Ehpro Raptor with both the raptor coils and the Horizontech Falcon coils.
Innokin isub B.
Aspire Odan Evo.
Aspire Cleito Pro.
Geekvape Zeus.

I got absolutely zero of the liquid nuance that i get from 3+ year old roundwire coils. I just get a blast of full-on "all the flavours at once", and for juices with sweetener, that is the primary profile. Interestingly, i found that with fruit flavours, it was a little more palatable, but since i primarily vape bakerys this wasnt all that much use.

I figured i would give the mesh rta's and rda's a shot, as everyone is raving about them, so i picked up:
Wotofo Profile RDA.
Wotofo Profile Unity RTA.
VandyVape Mesh RTA.

Tried all of them, same dissapointing experience. They were basically mesh sub tanks in RTA form. Literally exactly the same "flavour".

So, after wasting a chunk of money on all of these, im back to using the Cleito Pro with the 0.4ohm Cleito coils and the Uwell Crown Mini with the og Uwell Crown coils with the occasional use of the Wake Mod co RTA when i can be bothered to rebuild.

Is it just me? I dont understand the hype in any way. Maybe it's just my particular flavour profile doesn't work great with mesh, or maybe its just me, i dunno. It's just a shame to see that any recent sub tanks that come out are all mesh, apart from the very occasional sprinkling of roundwire thrown in here and there.

Anyone else have a similar experience? And have any recommendations on recent sub tanks to try that aren't just mesh?  

Whenever I clean my coils and pop it back in, I always get a very bad muted taste. Worse then it was when it was "dirty".... so my question is, is cleaning really worth it? Its never once paid off for me  

Does old coils have any negative affects?

I typically burn off the gunk on the coils and put it through a good rinse then change my wick every few days. This was especially true when I'm using standard kanthal on the Protank.

I recently switched to a Solomon 3 using claptons. I find that there is very little gunk on the coils, I still burn off what I can before replacing the wick. I usually change the coil every week and one wick in between. On this one however, I'm 2 weeks on on the same coil and had only replace my wick once using the same liquids that I normally use on the Protank.

What I notice is the vape isn't as smooth as if I were to put in a fresh coil. I think I just answered my own question but what do you guys have to say about it?  

To keep it short, my coils are lasting a day on average. I vape a 12mg store bought Skittles flavor and occasionally mix it with 18mg Menthol juice between 25-30 watts. The coils taste burnt and get clogged with some black crud. I'm priming the coils with juice, doing the dry hits that's recommended, essentially everything by the book but I can't get any decent lifespan out of these coils. Any insight would be greatly appreciated!  

Im pretty much freaking out right now, I have been vaping the same juice for 7 years and I just received the 3 bottles that I ordered and I went through 8 coils thinking I had bad coils, well it wasn't the coils I went and smelled my juice and it smelled like a burnt coil with a mix of burnt plastic. I called and they said they didn't change manufactures so I'm assuming something went wrong in the lab. Anyhow I have 1 good bottle left and that's only 30ml, I vape USA #1 from Ecig pros and hopefully they fix it otherwise I'm going to have to wait until they get there next batch which will be a while, because they just got this batch. So I need to find a new juice to vape for now, I prefer max Vg and tobacco flavors but not with the Carmel or dark colors. I love a little nutty flavor, so please can you give me some names juice and where to get it. Also I don't do the salt nic. Thanks so much  

Hello vapers! first! I'm a noob at this stuff because I just buy my tank and use it with the coils it comes with and second, my english isnt that good but I can understand it perfectly fine.

Anyway, Ive been searching everywhere but I couldnt find a solid answer to my question.
Im using an Aerotank Giant right now with a 1.8 ohm coil, if I put a 1.2 ohm I would have to use less voltage because I get a burnt taste and the coil burns pretty quick, Im about to order a Sub ohm tank soon and I'll use the stock coils, the one im getting is the Kangertech SubOhm tank.
Why do subohm coils use more voltage when normal coils use less?

I mean, Ive seen people do things like 0.2 ohm coil @ 100W + If I did anything over 3.5V on my 1.2 ohm coil itd burn instantly... SubOhm takes more voltage the lower you go and normal dual coils take less voltage the lower you go!

1.9 Ohm Dual coil = 3.7-3.8V for me
0.5 ohm OOC subtank sub ohm coil = 12-30W?!

Thanks in advance for taking the time to reply to this post and your patience!

Cheers!

Edit: by the way, Im planning to use my subtank with a 50/50 PG/VG 16mg nicotine, Is that ok?  

a few little questions. I actually like dripping my 3 mg nic in max better even than vaping. I drip using 3 mg nic on a Istick 50 watt set about 23 watts with a draw of about 2.5 seconds and the coils reading says 1.6 ohms and the air holes blocked a tad on the el diablo bael. I vape on the Istick 20 watts somewhere around 7 to 8 watts on factory coil of 1.8 in a nautilaus mini
my questions: 1) does sub ohm in a rebuildable tank give flavour similar to a dripper
drippers seem to require higher watts is this in anyway suggested as less healthy ( I am not too concerned about the increased supposed formaldehyde issue I believe Dr F had issue with the research and in my opinion I probably breathe more formaldehyde off gassing wandering around carpets and insulation and pressboard)
2) the nic level is quite a bit lower in the dripper Does this actually translate to a drop in nicotine/contine levels in my blood in other words would I need to drip more to keep my nic levels somewhat reasonable re setting off " the I want a smoke brain run"
3 if I were to drip only for 3 or 4 days am I likely to find my 12 mg vape to strong

thanks for any insight you might provide