Gt Ccell .5 Ohm And Tc

Hello everyone,

I'm vaping with a Vaporesso Swag and have tested the GT2, GT4, Mesh and Ccell coils so far. I'm vaping 50/50 VG/PG liquid with 3ml/mg nicotine. I always use the coils at the lowest recommended wattage, airflow fully open and my puffs are usually 2 seconds long at max.
Now my problem, I'm going through coils faster than others change their underwear. I'm on my third coil now for 10ml (!) of liquid.
I prime my coils and I let them sit in the tank for at least 30 minutes before I use them. I get muted flavor after maybe 5ml of liquid and it tastes burnt after 10ml of liquid. I've also tried different liquid brands and at least 20 different flavors.
So what am I doing wrong? I'm about to quit vaping because of the immense cost of coils I go through. I just can't figure out what I'm doing wrong.  

So I've got a bit of a convoluted question. I've been vaping for about 8 years and followed most of the trends. Spent a fair amount of time in deep subohm territory with freebase juice, low nic levels, lots of thick flavorful clouds. Over the last two years I've gravitated towards the salt juices with the tiny mods and PIP coils. The cost of replacement coils is getting annoying when combined with the cost of salt nicotine juices in comparison to the freebase bottles I used to buy. To address this I've tried building my own high ohm coils on the SMOK Rpm rebuildable head. Results have been less than satisfactory.

For what ever reason, even when I can block the airflow and build a high ohm coil..the flavors in salt nicotine always taste awful, nothing like what they taste like in the rpm 1.0 coil. As near as I can tell, the only reason I can think of is the different style of wicks..inner cool wick for a DIY vrs outer wick for the smok prebuilts.

This got me thinking of building a juice that's a bit heavier and smoother with a higher vg content and flavor content to work in a DIY coil (prob something simple like a single 26-28 gauge spaced wrap) but still pack some of the nic punch (sans throat hit) as a salt based juice..and will still work in a pod device. I'm thinking it would probably need to be in the 12-15mg nic range to get a similar buzz as the 25-35mg nice I usually vape at low power.

Is this even feasible..or are the flavors and thickness of the old style free base juices incompatible with salt based nicotine? A 40pg/60vg juice with a 12-15mg salt nic level that will work on a .8 single coil at 10-15 watts or so I think. And not taste awful.

In my state it's becoming problematic to source flavors other then basic tobacco.. so it might be time to go strictly DIY with a pod type device.

Thoughts?  

I can only get about a 1-2 day life span out of coils that are organic cotton based. After 1-2 days, they start seeping a dark colored liquid into my tank and ruining the juice. This has happened in my Atlantis tank running Melo coils vaping at 32 watts and my Herakles tank running 55 watts. Keep in mind I vape about 7-10ml a day. Juices are 70VG/30PG or 80VG/20PG all at 3mg nic.

On the flip side, if I vape old school Atlantis coils at 32 watts on the same juices, I get a full week before this happens.

Any ideas on how to make cotton coils last longer?! For this reason, I can't wait to get my Lemo 2 in. I'll be able to rewick daily and not worry about cost.

The way things are going, I am losing so much money on coils it's nuts. See picture to see whats happening.

Oh yeah, this is happening on all kinds of juices I vape. Mt Baker Vapor, Vista Vapors, 4 Pillars, The Milk Man. Some are budget juices - others are premium. No matter what juice I use, it happens.

The BIGGEST killer is Zeus Juice with 80%PG, 20%VG. This juice kills a coil in one tank full. I'm guessing the sweeteners in that juice do it.

It's frustrating because I LOVE my Herakles tank running at 55W but if I have to replace the coil every 1-2 days, that's SO expensive.  

Somehow, I inadvertently pushed the buttons just wrong today and it went from 7 watts (my usual power setting) to 50 watts (the highest setting). I didn't even mean to push any of those buttons.

I experienced instant burnout and a horrible taste in my mouth and the coil was instantly ruined.

Do people really vape at such high power? If so, how often do you have to replace the coil? And how many ohms are you putting that through? The coil I replaced it with is 1.77 ohms which is about the same as the one I burned out.

50 watts seems so excessive to me that I double-checked and yes, that's what it says it goes up to. Even at 7.5 watts the coils seem to burn out too fast which is why I vape at 7.

I feel like Nigel Tufnel designed this thing. "But it goes to 50. That's 43 higher than 7. So it's like 43 more. So when you're vaping at 7 watts and you want that extra push over the cliff..."

(I'm actually impressed that Nigel could do the math to figure that 50 was 43 higher than 7)  

Hey everyone,
I've been vaping for about two years now, and have decided to start dripping. For the last few weeks, I have been dripping on an IGO-W, 26G Kanthal single coil (7 wrap micro coil reading at 0.8ohms) on my iStick 30w.

I just recently purchased a new battery that should arrive today, and was wondering if anyone had advice/tips on producing some fat clouds! Dual Coils? Different coil builds? Number of wraps? Watts to vape at? I think you get the picture lol.

The items I will be using are as follows:
-SMOK XPRO M80 Plus
-IGO-W
-26 Gauge Kanthal Wire
-Japanese Organic Cotton
- 80vg/20pg Juices

All input is greatly appreciated. Thanks!
-Tyler  

I got a great number of responses on my last post, with tons of useful information, so here’s another question I have for you all. What is the best type of juice for flavor in a MTL RTA?

I’ve found that lower mg salt nic usually tastes better than its higher mg counterpart - I.E. a 30mg and a 50mg bottle of the same juice will taste better in the 30mg option.

I’ve read about people smoking 0, 3, and 6mg freebase in pod systems, so I bought some myself to try it out in my MTL RTA (the lady at the vape shop said 3mg would have a lot more flavor than Nic salts).

I’m not sure if I somehow got a bad batch of juice (I have 4 different flavors/ 2 different brands so idk the likelihood of that) or what, but it doesn't have a prominent taste.

Ive tried from .6 to 1.2ohm coils with 28ga stainless steel single round, as well as some 1ohm mtl fused claptons. Is it possible to make the juice work with my current set up or do I need to buy different gauge wire and up my watts? I’m not interested in heavy cloud production, just flavor.  

I'm using a Subtank Nano on the KBOX. Should be absolutely no problems.

But my coils (both the 0.5 and 1.0) are tasting awful. I prime them great, I make sure everythings good and secure, and I'm using a 75%-ish VG juice.

But I can't go above 20 watts with two new packs of coils I have, and especially on the 1.0 coils, that's ridiculous. I'll get a vaporized rubber taste that tastes like the worst clearomizer coil I've ever come across.

Dry cotton should just have sort of a cottony, almost doggy or smokey taste. But this is a pure rubbery flavor. Are the gromets going to crap? These things should be built for Sub-Ohm Vaping!

I have no clue what's wrong but I can't use this thing anymore.

I'm also getting more juice in my mouth than I would if I drank it. These coils have started to spit and spew like nothing I've seen. I've used these coils for months and could always go up to 30 watts, no issues!  

Recommendations Please!

I loved this mod, but after 4 years needed to retire it due to shortened battery life.
Wismec/Jaybo RX mini
Reuleaux RXmini Kit

Bought this one next from Vape Wild and really enjoyed it, but after 3 months it completely stopped charging and wouldn't turn on. Never got wet and never dropped. Just very poorly made. That was money thrown away.
Geek Vape Aegis Mini
Geekvape Aegis Mini 80W Starter Kit

Got this one next, and it's been great, but the charging port has broken. Vapor DNA was great and they're sending a full refund.
VAPORESSO LUXE NANO 80W TC
Vaporesso LUXE NANO 80W TC Starter Kit – VaporDNA

So, now I need something new and am looking for advice for what to get. I really like the "mini" mods, but a long lasting battery and durability is very important too.

I would really appreciate suggestions.

Thank you!  

So I decided to get another clearomizer and the Donner by Amigo Itsuwa is what I got to replace my Aspire Atlantis.....
So here are my thoughts on it and it's just My Opinion:

Holds 4mls of juice - holds more juice so I'm not refilling my tank 2-3 times a day
.50hm Coil head is cotton & Kanthal wire & a wire mesh around the opening for better wicking ( You can use Atlantis coil in this thing and it's better in this tank then it is in the Atlantis) It comes with 2.
There's no notches or trying to center the coil head. It sits in the Clearo and just sucks juice lol
Great Flavor sub-ohm - The flavor you get from this is amazing, I was a little taken back bc I chose a sour raspberry and it really was more sour tasting then in any of the other tanks I had the same juice in
I personally like the drip tip but it's not for everybody
Adjustable air flow control is a wide slot - It's a slide around, but the draw from almost closed to full open is nice any way you wanna vape.
Vape production is great I use 10/90vg - 20/80vg


There are some things I don't like about this tank...
Priming the coil is a process - on a fresh coil the directions state to drop a few drops onto the coil, then once tank is filled let sit for 1-2 minutes prior to use. On your second fill of the clearo you have to let the coil sit for 2 minutes b4 use....I kinda wanna fill and vape, not fill and wait
Holding 4mls of juice is great, but if you can't vape 1ml of juice at the bottom of your tank it sucks. You can't vape the last ml of juice because the coil head sits to high so it can't wick the remaining juice.
I did find that when I put the Atlantis coil head in that the wicking was alot better then the coils that it came with, now this could be bc I am using a high vg juice.

So let's talk price....I bought this at a B&M so I paid A LOT more then what I've found online.
My price was $45.00
I have found these online for as little as $23.00
and for this price I would probably buy it again, not for $45.00
Iv'e been vaping on this for about a week now, I've gone through 2 coil heads in 4 days & now put the Atlantis coil head in it and am having better luck with it.
So there's my thoughts on my new clearomizer.  

I'm almost two years into vaping and it has been great.

I've been using a VW Ehuge 35 watt 26650 mod with a Kanger Subtank. Its huge and heavy but the battery lasts a long time. Also been using an Innokin Coolfire 2 with a Gladius tank.

Figured it was time to upgrade. Been watching several review videos to see whats out there. A lot of new sub ohm tanks and they all seem pretty good.

I've never had a box mod and figured it was time. Bought a Cloupor T6 recently to put my Subtank on. The T6 is supposed to be a 100 watt device. The Kanger coil only goes to 30 watts so no big deal there.

I really like the T6. Pretty small for a 26650 mod. Surface is slippery though, need to get a wrap for it. Butons are nice any clicky. The battery cover has magnets which is nice, no screw driver needed. Feels solid and the internals are clean. Its thick and the 25mm Subtank fits nicely on it.

Recently after watching some videos, I came across a new kinda unknown Sub Ohm Clearo. Its the Freemax Starre Sub Ohm. .5ohm or .25ohm coils. Mine came with the .5ohm. The .5ohm is rated 20-60 watts and the .25ohm is rated 20-100 watts. Reviewers were all impressed with the vapor and taste of this device. So I ordered one.

Wow, OMG, this Freemax Starre rocks. Blows away my Kanger Sub Tank in vapor production and flavor. Holds 5ml and the air holes are huge. Surgical Stainless Steel and Surgical Cotton used in the coil. Amazing.

After some more research, I discovered the Cloupor T6 really doesn't put out 100 watts. Well, that makes sense as its only a single battery device.

So went to the local vape shop today and bought a Sigelei 150 watt to put the Freemax Starre on. Will order some .25ohm coils soon.

Lovin the Sigelei so far. Magnets on battery cover, comes with a silicone gel case, nice clicky buttons, takes 2 18650. Its taller and wider than the T6 but not as thick. One thing it lacks that the T6 has is a USB charging port.

The Freemax Starre fits perfectly on it. The Kanger Sub Tank is wider than the Sigelei but fits perfect on the T6.

Really enjoying both of these box mods.

A few pics