Best Type Of Juice In A Mtl Rta

First off, I would like to say that I’m very new to vaping. I started off with a JUUL, then a Smok Novo 2, and eventually got sick of buying pods.

Now I have a Hellvape MD, and an Ares 2 - the first provides better flavor, but it’s still not comparable to what I was getting in my pod systems. I just recently purchased a BP Mods Pioneer, and I’m hoping that gives me better results. I’m using an Aegis Mini for a mod.

I’m trying to figure out what I’m doing wrong, because it’s really frustrating to spend all this money for worse flavor, when I was hoping it would let me save money.

I have about 40 bottles of salt nic flavors that are 50 or 35 mg, and a couple 3mg freebase I bought (120ml for $7 seemed like a steal). I would really like to get away from the salt nic, but I seem to get even worse flavor from the 3mg.

I’m using 2.5ID 28ga SS316L round wire from Master Wire Supply (I have a spool) with Puffs Organic Cotton. My coils are usually .7ohms, but I’ve tried up to 1ohm. I’ve also tried 1 ohm Vandy Vape Superfine MTL fused claptons, and experienced similar results.

I’m using the MD with the most restrictive airflow settings (3 small hole airflow disk), low (2-3) adjustable AFC setting. I have my coil as low as possible to the airflow, and I have thinned / fluffed my wicks.

I haven’t tried adjusting the airflow below the coil on the Ares 2, because the video instructions say wide open airflow below the coil is the best for flavor (I have found the opposite to be true for the MD).

Can someone provide me more insight?

Will 2mm ID coils with the same amount of wraps taste better than 2.5? Do coil ohms do anything for flavor, or does it only change how fast it heats up? Will I lose flavor if my coils hang outside the diameter of the airflow disk?
Is there a certain type of coil that would give me better flavor than regular round wire?

I use TC at 420F 20 watts


Any kind of feedback is appreciated and if I left anything out or you have questions about my set up that could help me out please ask! I’m at a loss on what to do, and it seems like no amount of research is helping  

I’m a mouth to lung vapor and currently using the holic rda and galaxies rdta. I’ve tried using ni80 round wire and superfine mtl fused Clapton ni80 wire. The round wire is so easy to work with and the superfine is harder but I’m getting the hang of it. My question is with coils that ohm out the same with each wire I get flat flavor with the round wire and the flavor definitely pops with the fused Clapton wire. Is this normal? Same juice, same wattage, same ohms and same rda and squonk.
I love working with the round wire but not worth it if I can’t get better flavor.  

With everything going on in the vaping world I was wondering if we’ll still be able to buy PG/VG premixed.
I buy premix PG/VG with nicotine already added so I’m wondering if I should buy 4 or 5 gallons to make sure I can get it.
Also I was told that if I buy a few gallons that I should freeze it or refrigerate it,is that right?
I sell mods and tanks so I have plenty to last years because I use to sell them on ebay until they ban selling them on the site.
I’m on private sights but don’t know what’s going to happen after April.
I live in New York so we already are have a juice ban so I mail it to a friend in another state and they forward it to me.
Now I’m buying premix so I can just flavor my own juice but I’m worried they might stop shipping premix PG/VG and then what will we do?
So any information on what’s ahead I’d appreciate your information. I’m new so I’m trying to learn how to find information on here.
Thank You  

So I've got a bit of a convoluted question. I've been vaping for about 8 years and followed most of the trends. Spent a fair amount of time in deep subohm territory with freebase juice, low nic levels, lots of thick flavorful clouds. Over the last two years I've gravitated towards the salt juices with the tiny mods and PIP coils. The cost of replacement coils is getting annoying when combined with the cost of salt nicotine juices in comparison to the freebase bottles I used to buy. To address this I've tried building my own high ohm coils on the SMOK Rpm rebuildable head. Results have been less than satisfactory.

For what ever reason, even when I can block the airflow and build a high ohm coil..the flavors in salt nicotine always taste awful, nothing like what they taste like in the rpm 1.0 coil. As near as I can tell, the only reason I can think of is the different style of wicks..inner cool wick for a DIY vrs outer wick for the smok prebuilts.

This got me thinking of building a juice that's a bit heavier and smoother with a higher vg content and flavor content to work in a DIY coil (prob something simple like a single 26-28 gauge spaced wrap) but still pack some of the nic punch (sans throat hit) as a salt based juice..and will still work in a pod device. I'm thinking it would probably need to be in the 12-15mg nic range to get a similar buzz as the 25-35mg nice I usually vape at low power.

Is this even feasible..or are the flavors and thickness of the old style free base juices incompatible with salt based nicotine? A 40pg/60vg juice with a 12-15mg salt nic level that will work on a .8 single coil at 10-15 watts or so I think. And not taste awful.

In my state it's becoming problematic to source flavors other then basic tobacco.. so it might be time to go strictly DIY with a pod type device.

Thoughts?  

Hey guys,

I’m new to vaping. I have been a heavy 2 pack a day Marlboro light smoker for 20 years. I recently got into vaping and so far it has been an amazing journey!

I started with a small pod device (Caliburn) with 16MG nic salt. I found that I was still not able to quit smoking. I went back to my local Vape shop and got some 20mg nic salt juice, and that was too strong! It made me dizzy and confused and I just felt unwell. Even though @20mg I was getting a lot of nicotine I still wanted to smoke a cigarette.

On a whim I decided to give sub ohm vaping a try. I got myself a Lost Vape Thelema DNA 250c + a Freemax Mesh Pro 2 tank. I opted with 6MG freebase juice at 70/30. And sure enough it worked! I was able to quit smoking and have been smoke free for a week now!

My question though, is 6MG freebase nic @0.2 ohms (dual mesh), 70-80 watts too much? I feel fine for the most part and my cravings for cigarettes are under control. However from what I’ve read (and what the guy at my local Vape shop says) is that for sub ohm vaping you generally should stick to about 3mg of nicotine.

I know everyone is different, and you should do what works for you. But I’m just worried that with the large amount of Vapor I’m producing 6MG might just be a little risky.

I Vape quite a lot (200-250 puffs a day) and probably somewhere around 15-20ml of juice a day (at 0.2 ohms @ 70w the juice burns pretty quick). As mentioned above I generally feel fine. However sometimes I do feel a bit out of breath and like my chest is heavy. This could be gas (perhaps from inhaling so much air?). Or it could just be me adjusting from cigarettes to vaping. I don’t feel nauseous or have headaches.

Please let me know your opinions. Would really appreciate some advice from more experienced vapers!

Thanks!  

I’m curious as to why you shouldn’t do DL when using nic salts. I’ve got an Aegis Hero with a 0.6 coil at 15 watts. Even with the airflow closed off, it’s still to loose for a MTL. I keep reading and hearing I shouldn’t use nic salts for DL. The worst thing I’ve experienced so far is a mild headache. The nic salt is a 30mg.
Thanks in advance. ECF is my only true support group and I’m having a really hard time not smoking the stinkiest. Been back to vaping for about a month, and keep telling myself it’s all about baby steps. Not how many I smoke but how many I don’t smoke. I’ve got to quit for health reasons.  

Hey Guys,

I have been learning the ropes of RDA vaping, and so far I absolutely love it! As the title states I’m wondering what coils (FC, Aliens, etc) Would be best for flavor and vapor output? I’m currently running some Wotofo 0.33 Fused Claptons (~0.17 in dual coil) @ 60 Watts. The flavor and vapor is ok, But I’m looking for a little more. Maybe something I could run at a slightly higher wattage and get more vapor / flavor?

Any help would be greatly appreciated!

Thanks!  

I’m a long time vaper. I have been vaping 83/27 PG/VG juice with 12-16 mg nic. I use an avacado tank with dual Clapton coils at .3 ohms and around 50-60 watts. With this config I can get my most desirable lung hit but only with certain juices and I tend to chain vape. Whenever the shop is out of my regular juice I’m always Leary picking something new because a lot of times even at the same nic level I don’t get the satisfying lung hit I crave and end up with a sore throat from hitting it so often. Soo... I moved to Hawaii and my system is all screwed up. The juices here are all 50/50 so super watery, the juice is also double the price, I burn through it twice as fast, the lung hit is barely there, and it pops and crackles really loud which drives my wife nuts and has cuased many arguments about my “stupid crack pipe”. So in an effort to make my wife happier, spend less money, and maybe vape less I decided to venture into the salts realm.

I started with a geek bar to test the waters and lung hit was phenomenal! But at $20 a pop and only lasting a day that just wasn’t going to work. So after much research I just picked up a SMOK NORD 2 and some 48mg juice. I set it for 50 watts and took my first drag. Good god almighty! One hit and I caught a buzz. I have NEVER caught a buzz from a vape before. After some messing around I dialed it down to 25 watts and so far seems like the sweet spot and I don’t have the urge to chain vape... so success? I don’t know yet? It’s for sure a lot quieter and 1/4 the size of my tank MOD. Does going from chain vaping 16mg to 48 salt nic seem excessive or about right? I may try the 24mg juice when this one is out but any other suggestions? I’m a little worried I’m going to give myself nic poisoning after that first drag lol  

Im pretty much freaking out right now, I have been vaping the same juice for 7 years and I just received the 3 bottles that I ordered and I went through 8 coils thinking I had bad coils, well it wasn't the coils I went and smelled my juice and it smelled like a burnt coil with a mix of burnt plastic. I called and they said they didn't change manufactures so I'm assuming something went wrong in the lab. Anyhow I have 1 good bottle left and that's only 30ml, I vape USA #1 from Ecig pros and hopefully they fix it otherwise I'm going to have to wait until they get there next batch which will be a while, because they just got this batch. So I need to find a new juice to vape for now, I prefer max Vg and tobacco flavors but not with the Carmel or dark colors. I love a little nutty flavor, so please can you give me some names juice and where to get it. Also I don't do the salt nic. Thanks so much  

I have a ton of 0 mg juice that I would like to make 3 mg Nicotine, but I don’t know where to buy nicotine, what type I need or how to mix it properly. Some of you are going to say search the forums but all the old threads I’m not interested in as things change everyday with products and techniques. That’s why I am starting a fresh post and need help in which would be greatly appreciated.

So that’s one thing I need help with.

Second thing I need help with is deciding which dripping atomizer would you recommend. I’m looking for something that’s came out recently that has good reviews. I don’t have much time to search for reviews so maybe you know what’s hot and what’s not? I know it all comes down to personal opinion and I would like your opinion please. (RDA Specifically is what I’m interested in.)

Thank you.