Looking For Good Prebuilt Coils....

Ok so I know that kanger subtank .5 ohm coils are good for up to like fifty watts and the subtank 1.2 coils are good for up to 26 watts, my question is this kanger has released vocc coils pretty much the same coils they have for the aero tank , genitank ,etc except now they have organic cotton like the subtank coils. Is it safe to think that the 1,2 and 1.5 ohm vocc coils will be safe as the 1.2 and 1.5 subtank coils at the 26 or so watt range, if not how many watts are safe so I don't burn them to hell  

Hey guys I'm looking to upgrade from what I have right now which is the atlantis v1. I'm not a huge fan of the atlantis because of the inconsistency with the coils and the loss of flavor after 2 tank full. The atlantis v2 seems nicer with the occ coils and improved airflow, but I'm not sure if its worth the upgrade since I could just get the new 5-pack occ coils for my v1. The subtank mini still has better options with the occ coils and RBA. Also it seems the occ coils for the subtank is easier to rewick which could save me a few dollars.
I'm not sure which one to go with. I'm leaning more toward the subtank, but still not sure. Maybe someone who has either one or knows more about them could help me. I like to have a good amount of clouds while still keeping the flavor.

Or if anyone has a sub-ohm tank they could recommend that they like more than the ones I mentioned that would be good too.

I use an ipv2

Thanks  

I'm using a Subtank Nano on the KBOX. Should be absolutely no problems.

But my coils (both the 0.5 and 1.0) are tasting awful. I prime them great, I make sure everythings good and secure, and I'm using a 75%-ish VG juice.

But I can't go above 20 watts with two new packs of coils I have, and especially on the 1.0 coils, that's ridiculous. I'll get a vaporized rubber taste that tastes like the worst clearomizer coil I've ever come across.

Dry cotton should just have sort of a cottony, almost doggy or smokey taste. But this is a pure rubbery flavor. Are the gromets going to crap? These things should be built for Sub-Ohm Vaping!

I have no clue what's wrong but I can't use this thing anymore.

I'm also getting more juice in my mouth than I would if I drank it. These coils have started to spit and spew like nothing I've seen. I've used these coils for months and could always go up to 30 watts, no issues!  

So, like everyone else, I have my preferred juice (extremely complex DIY with all NET flavors) and my preferred all day driver (Subtank Nano and an Ego One 1100 mah battery). It's performed GREAT. I use prebuilt OCC coils and I rebuild those coils, too. Most of the time, they work just like they do with any other rig... they hiss (like all atomizers) and pop and crackle... part of the nature of sub ohm vaping (I use the 0.5 ohm heads, btw).

Once in a while, the stars align and the vaping gods smile down, and NO popping. I have to actually fire the device for a while to make sure it works. The telltale hiss is there, just no popping. It's happened with prebuilt coils and coils that I've rebuilt. Not sure what the deal is, but the vape is SOOOOO much better.... flavor seems improved too, but it might be mental.

Whatever the case, thank you, vaping gods, stars, fates, or whatever. That occasional perfect coil is nice.  

I am kinda a noob when it comes to prebuilt coils. I am looking for coils that feel very strong/sturdy, but I am not sure what material it is.

I had coils that said they were .25ohm and all it says is "KA1 WIRE + Ni80 wire" and they felt very sturdy/hard to pull the wraps apart etc....

I bought what I thought were a good replacement for those, but they feel flimsy and easy to pull apart the wraps. They are .36ohm, 316l stainless steel, 30gx4/36g.

So apparently the stainless steel wires are more flimsy...I cannot seem to find coils that have KA1 + Ni80 like the sturdy coils I once had. I
am trying to figure out which material/what I need to look for in order for the coils to be sturdy like the old coils.


Can someone help me out with this? Thanks in advance.  

To keep it short, my coils are lasting a day on average. I vape a 12mg store bought Skittles flavor and occasionally mix it with 18mg Menthol juice between 25-30 watts. The coils taste burnt and get clogged with some black crud. I'm priming the coils with juice, doing the dry hits that's recommended, essentially everything by the book but I can't get any decent lifespan out of these coils. Any insight would be greatly appreciated!  

I recently got a VOOPOO mini. Came with a small low wattage coil installed already. Used that one and got great flavor. Just went thru 2 N1 coils. Terrible burn and horrible flavor. I let both coils prime for over 15 minutes and set at low wattage to begin with. I am very unhappy with these coils so far.  

Hi all,

I've recently decided to buy a Kanger Subtank Mini to test the waters out and see how it compares to the Aspire Atlantis. Unfortunately, my coils are only lasting me 6 hours at the most before the cotton is charred black and everything tastes burnt. I've heard about coils that are coming back as duds. What is a good way to tell if the coils I've bought are duds?

Thanks in advance!  

I've had the same exact set up for about a year and a half now. Itaste VTR + Aerotank with 1.5 ohm coils, and i vape at 9.0 watts. I tend to only vape one specific brand/flavor, I'm one of those weird people that just like one thing and stick with it. Up until July last year, i used a local vape shop's liquid. I liked it and it was fantastic. I'm a little fuzzy on their ratio, but I believe it was 70/30 pg/vg. Their liquid would never pool under the coil and my coils would last for over 5 weeks at a time. Then i moved. The cost of their liquid plus shipping was just too high, i was already paying 22 bucks for a 30 ml plus shipping on top of it was just killing my wallet. I found a couple other sources of liquid, one on the net being Apollo ecigs, and the other being local B&M selling VGOD liquid. Both of those i believe are 70/30 vg/pg.

Now since the switch to either of those 2 liquids, my coils are only lasting 5 days tops, and at nearly 2 dollars a pop, its killing my wallet even more than with the liquid i was having shipped here from that local store in FL. What is going on? Is that ratio of VG/PG killing my coils? Its not so much that the coils are burning out, but i just keep having to take a harder and harder draw as the days go on. When its a fresh coil, i get tons of flavor and good vapor, but towards day 4-5, flavor minimizes and vapor decreases. I've soaked them in distilled water and let them dry out, but even that the flavor/vapor tends to peter out after a day or so.

Thoughts?  

I have the Smok Mag Grip (18650 battery), the vaporesso cascade tank and vaporesso .5 ohm coil which i love. I vape very cool, on watts the lowest recommended which is 25 it's even a bit high for me. I was wondering about using TC, the coils are SS316L, so i set it to steel, 25Watts, but then it asks for another number which i believe is the "TCR" it is adjustable from 0.00010 to 0.00300. I have no idea what to set the last number at. The ceramic coils are great, low power, great flavor and they last a long time, just wondering if I can get better results in TC vs just Watts. Thanks! Oh and e juice is vg based Lazarus Vintage: Journey(still the best ive ever had for 5 Years)