Rda Coil, Somethings Wrong

Where can I buy just the Clapton coils or wire for my SmokeTech Cloud Beast. I’ve been using the rebuildable coil for 2 years and it’s always been at .3 ohms. Over the last week it has slowly gone up to .52 so I took it apart and saw that the putter wire is degrading.

They are Clapton, correct? Or fused Clapton?  

It's often been said to test a new coil build on a regulated mod before using it in a mech mod. Just for fun, I tested a new build on multiple platforms to see how consistent they a

These are AVS stainless steel premade quad core clapton 30x4/40 3.5 7/6
Two coils in a Dead Rabbit V2 RDA

Coil Master Tester 0.17
Uwell Crown mod 0.19
Wismec mod 0.18
Geek Vape Aegis 0.18
Vapresso Luxe 0.18

Closer than I would have thought!

Incidentally, the old coils were in there for 8 months, although this unit is in rotation, so maybe a months worth of actual use.

Also, the top cap was just about impossible to remove from the tube. I had to insert a chap stick into it and slam it on the desk for it to come off.  

I ordered a geekvape Aegis Boost Pod-Mod I read on a site that it is a salt nic device and ordered a kit that had 2 juices that came with it. The juices that came with had the option of 30mg and 50mg. I also ordered a few more juices and replacement coils. Iwith the higher mgs because I smoke and when I don't smoke I have a chew in. After doing some research i seen you can't use that high of mgs in a sub ohm device. The coils it came with are .4 and .6. Did I waste my money or can I use 50mg vape juice with the geekvape aegis boost  

I bought a Kanger Subtank and Atlantis V2, but sold them because they just weren't wicking my 100% VG liquid (Velvet Cloud & Gypsy eJuice) well at all. I tried using the atlantis with the .3 ohm coil installed at 70-80W, which was the stated operating range, and found it to be EXTREMELY hot. So hot that the tank quickly heated up to the point of almost burning my lips. The Kanger just burned the wick up at 20W+ with the .5 ohm coil, despite letting it sit filled for a few minutes and priming.

I am very interested in picking up a Royal Hunter, although I've no idea what pre-made coils (i dont want to make my own coils, just dont have the knowledge or time to learn how) and battery to get. VaporDNA sells UD pre-made coils in various resistances, but figuring out what resistance to use, and thus what wattage battery to get is where I am stuck. Not sure if it'd be better to run at lower ohms / higher wattages, or higher ohms / lower wattages. I'm not sure if it's possible to get massive clouds, but a cooler vape at the same time, but that's my aim.  

Hello, so i have been vaping with this new Aegis mini kit with a cerberus tank that i bought a couple of weeks ago. I have used up the 2 standard coils that were in the box, but for some reason in my country i am not able to find specific coils for aegis mini kits online (I live in Belgium). My question is if there are any other (more available) coils that i could use in my cerberus tank? I don't want to pay like $30 just to have them shipped from the UK to Belgium to be honest as they should be aroun $16 for a 5-pack. I noticed i could get "Geekvape Cerberus coils", would these fit my cerberus tank? Maybe a dumb question but you can't be sure enough.

Thank you in advance!  

Hello guys,
I recently purchased a single coil RTA, my first rebuildable experience. I love it!! .
I saw at the shop a double coil RTA and a Double coil RDA, was planning on buying one of them until I thought I only have a 100W mod. Do you guys think it is enough? Are there some specific ohms coils that could make it work etc? Or is a 100W enough? I am new to this so calculating ohms law and all the other stuff I will learn, I just need a answer from the double coilers if you guys use higher wattage mods or not.
Thank you in advance!  

New to RDA's, I got a Cloudscape atty 510 RDA and was wondering wich coil would be the best all around coil to use. I usually vape 50-60 watts on an Aegis solo. And what online site would have them. Thank you  

also which mg nicotine would be reccomended for sub ohming for a person who vapes MTL 10 mg,



Was looking for a vape to use for DL, without making my own coils, found the geekvape aegis mini the tank it comes with has good reviews, not sure about the coils though has anyone tried them?  

hi, i have been vaping with same setting for 2 years :
Regulated mod, Single coil rda, 2.5 mm alien coil 0.25 ohm, 30-35 watt, 18560 sony batteries.
I have been using the same batteries over and over for 2 years.
And I consider my self an expert when its come to my setting i mean I really know when its wicking issue or burnt coil or wrong coil position, 510 contact, battery contact etc ....
The thing now is that i feel some thing wrong with my vape, i dont feel it hit hard as it was before, it do spitback the ejuice to my mouth, flavor is little bit down.
So what i am asking is :
- could it be the batteries since I abused them?
- Is it possible that my mod show 30watt in the screen and doesn’t manage to deliver that 30 watt to the coil?
- I know as fact that long time used batteries have less capacity so they will charge and discharge fast, but i wonder if they also will be weak and don't hit hard enough in compared with its original states ?  

I'm a little late to the drop-in PNP coil game, I just got Wotofo's SMRT PNP rebuildable coil system and I LOVE IT. I've always been an oldschool rebuildable, low ohm, high watts, big hot vapor fan, and extremely skeptical of the replaceable pods because, let's be honest 5 years ago they didn't hold a candle to a plain'ol RDA that you have to spend 15 minutes building and getting just right.

Well the PNP coils have me kicking myself for not trying them sooner as they produce 95% the same amount of vapor of a *perfect* RDA build, but with 10x better warmth and flavor.

So I'm wondering why the heck other companies besides wotofo aren't upping the anty and making better PNP coils like Wotofo (the Voopoo ones are great, but Wotofo really outshines them with their rebuildable mesh-style pods). I would easily pay $20 for an Ohm Science pre-made Alien Clapton pnp pod or something a little more intense. Since you can put these PNP'S on an 80+ watt mod, there's a world of possibility for plug-n-play cloud chasing if you want, and I think there's some financial incentive for that.

Does anybody know where you can maybe buy some blank wholesale pnp shells because I might try and make my own if no one else does!