Uwell Caliburn G Info

Hi
As one of Caliburn users I encountered problem with opening pod cap/drip tip for refiling. On some pods it is very tight, a few times I had to use pliers and spend considerable amount of time still. I even contacted Uwell directly about this and had been told that the problem is known and basically I have to deal with that.
The problem is hidden in inner top portion of the pod cap. There are 2 notches/teeth pointing down, those are going into juice fill holes and thus holding the cap in place. And in addition, it is very hard to grab the cap to pull it up, I wish it had some kind of bumps for better finger's traction.
Here is the answer to this, the cheapest and the simplest possible.
Get some cheap tweezers and bend tips inwards, creating hooks on both sides. Take a new pod and crab the cap from the top so the end points of those hooks will go under the outer cap sides from both sides of the pod, then gently pull up, one side at the time. It took me about 30 seconds to open tight fitted cap.

See simple, rudimentary pictures below.



 

Hi
I got myself second Caliburn and from the start I feel that auto firing is not as fast as my first one, just like a second or so behind. If I use the button it seems to be OK.

Also, it feels more airy. I check the same pod on both devices and first one seems to have a bit more restrictive airflow. Or, due to late auto firing, I am inhaling first clean air instead of vape, and thus, the feeling of less restrictive airflow.

And lastly, which is not a problem, but it is not feeling OK, second Caliburn pod latching thing feels more loose, where on the first, when I push pod into the slot, I can feel and hear distinctive click, on the second, just a very little bump and very shallow click.

Would first, auto fire delay constitute good grounds for warranty replacement? I got it less than a week ago.

Any thoughts?  

Yup. I got me a caliburn. I cannot belieive the flavour and warmth of vapour with the 1.2 ohm coils. I gave my Coolfire 4 TC100 away to a friend and both my cleito tanks.

12mg nic salts, 50pg/50vg and amazing.

My set up has gone from big to tiny and the salts are so satisfying compared to normal eliquid that I don't need to DL anymore.

Amazed at the performance from these tiny modern pod devices better than a nautilus mini by miles.  

Now you can really vape anywhere well with a pod like the caliburn, juul, ect. But still!
Oh and it's $6 and change shipped


CLOAC | Vapor Eliminator Accessory | Vape Anywhere  

Hi all,

I'm coming off a 2 pack a day smoking habit and have been vaping for about 3 weeks now.

I purchased the Caliburn G as this device seems like one of the best for nicotine salts.

They said nicotine salts is the best way to get off smoking and its helped a lot so far.

I'm on 30ml nic salts per 100ml bottle and I've got my smoking down to 3-6 cigs a day.

My question pertains to coil life.

If I chain vape, will this affect coil life ? And to what degree will it affect it ?

I've had to change the coil every 5-6 days so far, but from what I've researched, it is because of my chain vaping habit.

Can the coil last about 8-10 days if I don't chain vape, or is this pushing it ?

Also, is it normal for the liquid in the pod to become a dark brown / black colour after a few days ?

Thanks,

Andy  

I'm so tired of the recent "mesh only" craze. I just don't understand it at all.

I have used roundwire sub tanks for close to 4 years, and can generally get a pretty accurate flavour representation from my juices. Obviously some are better than others, but the og Uwell Crown coils and .4 Cleito coils are pretty stellar.

Recently decided to mix it up and try something new, so i went on the hunt for a new sub tank, only for the market to be completely littered with mesh-only tanks. The only tanks i could find that still use roundwire are from years ago.

I figured i had been missing something, so i picked up a collection of mesh sub tanks, only to be dissapointed by every one of them.

The list was:
Ehpro Raptor with both the raptor coils and the Horizontech Falcon coils.
Innokin isub B.
Aspire Odan Evo.
Aspire Cleito Pro.
Geekvape Zeus.

I got absolutely zero of the liquid nuance that i get from 3+ year old roundwire coils. I just get a blast of full-on "all the flavours at once", and for juices with sweetener, that is the primary profile. Interestingly, i found that with fruit flavours, it was a little more palatable, but since i primarily vape bakerys this wasnt all that much use.

I figured i would give the mesh rta's and rda's a shot, as everyone is raving about them, so i picked up:
Wotofo Profile RDA.
Wotofo Profile Unity RTA.
VandyVape Mesh RTA.

Tried all of them, same dissapointing experience. They were basically mesh sub tanks in RTA form. Literally exactly the same "flavour".

So, after wasting a chunk of money on all of these, im back to using the Cleito Pro with the 0.4ohm Cleito coils and the Uwell Crown Mini with the og Uwell Crown coils with the occasional use of the Wake Mod co RTA when i can be bothered to rebuild.

Is it just me? I dont understand the hype in any way. Maybe it's just my particular flavour profile doesn't work great with mesh, or maybe its just me, i dunno. It's just a shame to see that any recent sub tanks that come out are all mesh, apart from the very occasional sprinkling of roundwire thrown in here and there.

Anyone else have a similar experience? And have any recommendations on recent sub tanks to try that aren't just mesh?  

Hmmm... So the 1.4 is good. But the 1.2 is GOOOOOOD.

But a caramel tobacco liquid seems way too sweet in the 1.2 pod. The flavour is great, just ay too intense in sweetness.

Would it make sense that sweeter liquids would be better in the 1.4...? I have both  

It's often been said to test a new coil build on a regulated mod before using it in a mech mod. Just for fun, I tested a new build on multiple platforms to see how consistent they a

These are AVS stainless steel premade quad core clapton 30x4/40 3.5 7/6
Two coils in a Dead Rabbit V2 RDA

Coil Master Tester 0.17
Uwell Crown mod 0.19
Wismec mod 0.18
Geek Vape Aegis 0.18
Vapresso Luxe 0.18

Closer than I would have thought!

Incidentally, the old coils were in there for 8 months, although this unit is in rotation, so maybe a months worth of actual use.

Also, the top cap was just about impossible to remove from the tube. I had to insert a chap stick into it and slam it on the desk for it to come off.  

I have said many times all mods break sooner or later. I dropped one and It quit working. I had to use an older mod I had for backup and it was usable but would randomly change the wattage. I bought a UWELL EVDILO a couple of months ago and it didn't work out of the box. I bought another mod the Vandy Vape Gaur-21. I received it yesterday. I like it but, I think the battery lights are not functioning properly. I used it for 24 hours and the battery indicators report the batteries are still at full charge. Doesn't seem possible. I am just sharing this info. Merry Christmas!  

Hi everyone. I ordered a vape (Voopoo Drag X Professional) that's on back order from Hong Kong to replace my problematic Uwell mod and I think I might need to go with disposables in the meantime until it gets here. I don't know anything about disposables. Can anyone make recommendations? Thanks.