Help!

Hi, folks:

My order arrived in NYC from Mt Baker in 48 hours! Yay! I still have two full packs of cigs! Wow! I'm a happy girl! But ...

There're no directions for my battery. Mariel at Mt Baker had emailed me that to use the Kanger EVOD 1600, I should press the button, and if that didn't work, I should press the button five times fast, and that'd work. That made the light come on, but when I went to smoke it, the light was off. It appears that when I want to smoke, I need to hold the button down. Is that right? That seems like a pain in my bottom.

Worse, when I smoke, I cough so hard, I cough a lung up. I guess getting the 24mg wasn't a good idea after all. There's a place nine blocks from here called "Smoke Shop," so I MAY be in luck, but I live in the hood, so my hopes aren't too high. Still, how badly can they mess up some plain juice? I guess I'll find out, because I need to water this stuff down. Right? Is that what I need to do? That's my goal; what am I looking for? Is I get plain glycerin, I'll water down the flavor. Am I looking for, say, some Blood Orange with no nicotine?

Man, is this device ever BIG. I'm very slender, and this thing is about the size of my forearm. And the Blood Orange tastes good enough to eat, but bloody hell; I've coughed up my liver after three hits.

Do do I need to turn this thing off somehow? It looks off, but do I need to press the button five times to turn it off? Since it doesn't come with any instrux, I have no idea whether it's sitting there killing its battery.

It comes with a sleeve that sits between the tank and the battery, but it doesn't fit snugly, so it rattles. I guess a better word is "jingles."

The medium-sized case I bought doesn't hold anything but the charger and the spare tank. Oh: I guess the coils will fit in there, too. Sure doesn't fit a whole kit like in the photo! I don't think this gizmo will fit in the clutch purse I carry around. (It's really small.) I'm gonna hafta buy a bigger purse!

So far, I'm not a happy vaper yet, but I'll get there. I hope I will, anyway! Thanks for some tips!

Binky  

I have had a lot of mis fires on my Smokless Owl 25.00 squonker and had to press down extra hard

and sometimes side ways to get it to fire.

I just done some contact cleaning and scraping on the Smokless Owl Button.

I took my wifes Emory board finger nail file thingy and depressed the firing button and held it depressed and rubbed it

across the firing pin and then took a small jewlers screwdriver and scratched it back and forth across the end of the pin and

did the same thing to botton ground pin.

I noticed some black color on the end of the firing pin before I started this cleaning process.

I gently took the screw driver and scratched back and forth across the positive and negative end of the battery just to

take any small film or oxidation from the ends just to make a better connection.

It seems to fire now just like it should with no MISFIRES---mod is now perfect !  

I bought two Innokin Endura M18's, and both seem to have problems.
The lights have gone out. There is no way to know the battery power, when they are fully charged, etc.

And now both of them don't seem to vape very well, like there is a air leak. I am using the Innokin M18 tank/coils with them.

Does anyone else use the and how has your experience been with them?  

hi my smok 22 vape pen button is jammed in so the top bit is fully pushing in and the bottom is fully not pushed in. it’s not firing or anything when i don’t want it to so that’s good but it also won’t fire at all. idk how to add images  

Wich finger u guys use to press fire button on mod???
Index or thumb????  

So I recently bought a brand new Vaporesso Gen mod. Normally I stay away from compression/press fit 510 connections but I decided to give the Gen a shot. I've only had it 1 day, and already I've noticed that the 510 connection is raised slightly above the top of the mod and with a tank connected it is slanted towards the back of the mod. From what I can tell the 510 isn't loose at all. But it still slightly worries me. And a couple times I've taken a hit and everything is fine. Then all of the sudden while my finger is still pressing down the fire button it stops firing. Has anyone else experienced this with the Gen?  

I got a problem with my Luxotic Surface. I'm using a LG Choco Battery 18650, it was fully charged and when I press the fire button suddenly it appears for Battery Low even the battery was on fully charged. I tried my spare battery maybe its just a mistake putting a fully charge battery, but it was the same issue also with the spare battery. I tried the 2 batteries with my Geek Vape Aegis 100W to check whether my batteries are already broke but it works fine. I was vaping for my Luxotic Surface by 55.0 Wattage, 0.21 ohms, 3.40 Voltage. Can someone help me out to fix this problem?  

Well , I aint even gonna say much this thing is better than any mech mod out there . You guys told me to start building higher ohm coils and i did , I build a 2.3 ohm coil . My 2*18650 box mod performed like .... with it , I had to hold the button for 2 - 4 secconds before draw and i still got minimal vapor . So i got the istick 50w , i set it to just half of its full potention , 25W and it is firing up the 2.3 ohm coil as soon as I press the button and I am getting extreme vapor production . Also size i knew it will be small , but i can not believe how small it actually is , absolutely amazing , build quality is also amazing . I should have moved from mech mods to VW a long time ago .  

I have an orbit cannon vape pen. I believe it's 510 style.

I bought it 5 months ago. I just got around to using it. You press the button 5 times, and it turns on, press it 5 more times and it shuts off. The light also indicates the battery voltage. It turns white when fully charged, and then blue, and then red when it's almost dead. There is also a light on the charger that is red while it's charging and then it's supposed to turn green when it's done charging.

Well, the e cig battery light stays white for a short while, and then turns blue. It used to stay white longer. It's like after a short bit of usage, it goes blue. The red light on the charger also never turns green no matter how long it stays plugged in.

The e cig stayed in the box, and the battery was depleted. I picked it up a few days ago and put it on the charger to start using it and noticed this.

Does it sound like the battery is messed up? Last night I charged it 3 hours and the red light on the charger never turned green so I unplugged it. The light on the battery was white. Today I went to use it, and the light was blue - I never used it and the e cig itself was turned off.  

I accidentally locked the up and down buttons by pressing both of them simultaneously for 2 seconds, I have tried unlocking them by doing the same thing like the instruction manual calls for. It doesn’t work, no “unlock” pops up or anything. You can hold them as long as you like and...nothing.

I have since figured something might be wrong with it as I am almost positive I’m doing it correctly. Now I have tried getting the reset button to work in hopes of the up and down buttons being unlocked upon reset. I hold the reset button for 5 seconds and I’ve tried the method of the combo with the fire button and reset as well as the up arrow and reset and the screen goes blank and turns back on but never says reset and the settings are still the same as before.

My next idea is plugging it into my computer in hopes of an update fixing this but other than that I am out of ideas. The device is stuck on 20 watts which is too high for the cartridge I’ve got on it. Does anybody have any ideas, please help me out.