Noone's Making Custom Pnp/voopoo Coils?!

Hey Guys,

I have been learning the ropes of RDA vaping, and so far I absolutely love it! As the title states I’m wondering what coils (FC, Aliens, etc) Would be best for flavor and vapor output? I’m currently running some Wotofo 0.33 Fused Claptons (~0.17 in dual coil) @ 60 Watts. The flavor and vapor is ok, But I’m looking for a little more. Maybe something I could run at a slightly higher wattage and get more vapor / flavor?

Any help would be greatly appreciated!

Thanks!  

Where can I buy just the Clapton coils or wire for my SmokeTech Cloud Beast. I’ve been using the rebuildable coil for 2 years and it’s always been at .3 ohms. Over the last week it has slowly gone up to .52 so I took it apart and saw that the putter wire is degrading.

They are Clapton, correct? Or fused Clapton?  

I'm so tired of the recent "mesh only" craze. I just don't understand it at all.

I have used roundwire sub tanks for close to 4 years, and can generally get a pretty accurate flavour representation from my juices. Obviously some are better than others, but the og Uwell Crown coils and .4 Cleito coils are pretty stellar.

Recently decided to mix it up and try something new, so i went on the hunt for a new sub tank, only for the market to be completely littered with mesh-only tanks. The only tanks i could find that still use roundwire are from years ago.

I figured i had been missing something, so i picked up a collection of mesh sub tanks, only to be dissapointed by every one of them.

The list was:
Ehpro Raptor with both the raptor coils and the Horizontech Falcon coils.
Innokin isub B.
Aspire Odan Evo.
Aspire Cleito Pro.
Geekvape Zeus.

I got absolutely zero of the liquid nuance that i get from 3+ year old roundwire coils. I just get a blast of full-on "all the flavours at once", and for juices with sweetener, that is the primary profile. Interestingly, i found that with fruit flavours, it was a little more palatable, but since i primarily vape bakerys this wasnt all that much use.

I figured i would give the mesh rta's and rda's a shot, as everyone is raving about them, so i picked up:
Wotofo Profile RDA.
Wotofo Profile Unity RTA.
VandyVape Mesh RTA.

Tried all of them, same dissapointing experience. They were basically mesh sub tanks in RTA form. Literally exactly the same "flavour".

So, after wasting a chunk of money on all of these, im back to using the Cleito Pro with the 0.4ohm Cleito coils and the Uwell Crown Mini with the og Uwell Crown coils with the occasional use of the Wake Mod co RTA when i can be bothered to rebuild.

Is it just me? I dont understand the hype in any way. Maybe it's just my particular flavour profile doesn't work great with mesh, or maybe its just me, i dunno. It's just a shame to see that any recent sub tanks that come out are all mesh, apart from the very occasional sprinkling of roundwire thrown in here and there.

Anyone else have a similar experience? And have any recommendations on recent sub tanks to try that aren't just mesh?  

Hi all,

Thought I would share with you guys, didn't place my order yet, trying to figure out how to spend my money in the angelcigs anniversary sales page Angelcigs Clearance, prices r just ridiculous, a few things i have my eyes on :

Pollux Style Rebuildable Dripping Atomizer Black 1:1
Omerta Style Rebuildable Dripping Atomizer 1:1
Venturi Kayfun Styled RDA Rebuildable Atomizer 1:1
Shield Style Rebuildable Dripping Atomizer 3 Rings
Doge V2 Styled RDA Rebuildable Dripping Atomizer
Orchid V3.5 Styled Rebuildable Tank Atomizer 1:1
AQUA V2 Style Rebuildable Atomizer RTA+RDA 1:1

Happy shopping guys  

I recently got a VOOPOO mini. Came with a small low wattage coil installed already. Used that one and got great flavor. Just went thru 2 N1 coils. Terrible burn and horrible flavor. I let both coils prime for over 15 minutes and set at low wattage to begin with. I am very unhappy with these coils so far.  

Hi. I have just purchased the heavy hitter mech mod.
The coils I bought are wotofo .28 dual core fused claptons.
It is a asgard mini RDA, it will be a dual coil build , so resistance should be .14
Will a Samsung 40t battery be ok with this build.
In regards to saftey and amp draw.
Thanks  

I recently upgraded to the Istick 30 and Subtank nano, and kinda want to try out a dripper, but do not want to build coils, check ohms etc. Are there any drippers available that take pre made coils? I guess I can wick if needed, but I'm not ready to jump into coil building yet. And if anyone could explain the benefits of dripping over a tank system, that would be great also I know changing flavors without dumping a tank, but any flavor or vapor advantages?  

So I've got a bit of a convoluted question. I've been vaping for about 8 years and followed most of the trends. Spent a fair amount of time in deep subohm territory with freebase juice, low nic levels, lots of thick flavorful clouds. Over the last two years I've gravitated towards the salt juices with the tiny mods and PIP coils. The cost of replacement coils is getting annoying when combined with the cost of salt nicotine juices in comparison to the freebase bottles I used to buy. To address this I've tried building my own high ohm coils on the SMOK Rpm rebuildable head. Results have been less than satisfactory.

For what ever reason, even when I can block the airflow and build a high ohm coil..the flavors in salt nicotine always taste awful, nothing like what they taste like in the rpm 1.0 coil. As near as I can tell, the only reason I can think of is the different style of wicks..inner cool wick for a DIY vrs outer wick for the smok prebuilts.

This got me thinking of building a juice that's a bit heavier and smoother with a higher vg content and flavor content to work in a DIY coil (prob something simple like a single 26-28 gauge spaced wrap) but still pack some of the nic punch (sans throat hit) as a salt based juice..and will still work in a pod device. I'm thinking it would probably need to be in the 12-15mg nic range to get a similar buzz as the 25-35mg nice I usually vape at low power.

Is this even feasible..or are the flavors and thickness of the old style free base juices incompatible with salt based nicotine? A 40pg/60vg juice with a 12-15mg salt nic level that will work on a .8 single coil at 10-15 watts or so I think. And not taste awful.

In my state it's becoming problematic to source flavors other then basic tobacco.. so it might be time to go strictly DIY with a pod type device.

Thoughts?  

Hi I've been in the vaping industry for years now and have had many tanks over the years both mesh and normal coil, for me mesh was amazing at flavour and for more cooler vape lovers, however I found that normal coils provided more cloud and less juice consumption with some tanks and were able to achieve the same amount of flavour as mesh with the right build. But I still curious as too how many people prefer mesh over normal coils and vice versa and why ?  

Hello
I have the wotofo serpent rta top airflow single coil tank now and I just purchased the augvape druga rta. Flavor is 100% better in the augvape drugA rta but juice leaks out the bottom of the tank every time which is why I have to stay with top airflow as it never has leaked on me. So I’m looking for a top airflow rta single coil . I typically vape between 20-30watts so I don’t need a powerhouse. I just want the flavor and don’t care about clouds. Can anyone recommend the best top airflow rta? The wotofo serpent works well but it takes a hit on flavor. The serpent only has 2 small air holes around the coil area and I think this is why it isn’t producing a good vape. I was looking at the Zeus? Augvape intake of the dual one? Or any others anyone can recommend ?

primary goal: outstanding flavor
No leaking
Lots of air holes around the coil


thanks for your time