Having A Hard Time Adjusting.

I’m curious as to why you shouldn’t do DL when using nic salts. I’ve got an Aegis Hero with a 0.6 coil at 15 watts. Even with the airflow closed off, it’s still to loose for a MTL. I keep reading and hearing I shouldn’t use nic salts for DL. The worst thing I’ve experienced so far is a mild headache. The nic salt is a 30mg.
Thanks in advance. ECF is my only true support group and I’m having a really hard time not smoking the stinkiest. Been back to vaping for about a month, and keep telling myself it’s all about baby steps. Not how many I smoke but how many I don’t smoke. I’ve got to quit for health reasons.  

Hey guys I’ve been enjoying vaping for a few months now and I’m loving it.
I’ve learnt how to fix some leaks and backspits so I am happy with that .
But I have washed one of my coil cleaning it under tap water and left it to air out for a week cuz I used another coil at this time.


I’m not getting much juice and the cotton in the coil is quite hard. So I’m sucking mostly Heat vape
But it’s not terrible or anything?

What should I do ?

Kind regards  

Hello
I have the wotofo serpent rta top airflow single coil tank now and I just purchased the augvape druga rta. Flavor is 100% better in the augvape drugA rta but juice leaks out the bottom of the tank every time which is why I have to stay with top airflow as it never has leaked on me. So I’m looking for a top airflow rta single coil . I typically vape between 20-30watts so I don’t need a powerhouse. I just want the flavor and don’t care about clouds. Can anyone recommend the best top airflow rta? The wotofo serpent works well but it takes a hit on flavor. The serpent only has 2 small air holes around the coil area and I think this is why it isn’t producing a good vape. I was looking at the Zeus? Augvape intake of the dual one? Or any others anyone can recommend ?

primary goal: outstanding flavor
No leaking
Lots of air holes around the coil


thanks for your time  

I change my coil infrequently,I notice sometimes when I rewick or change flavour on my rta,my coil looked black and gunk.After I rebuilt it and used it,the favour is ok and no dry hit, just a little less flavour.Recently,there is people contracting Vape related illnesses and a few died.I just don’t have too much time recoil and built,as usually rebuilding my rta which is relatively new released would take around 20min and I don’t have the time.Is dry hitting dangerous for the health because of Formaldehyde of dry hit or is the risk low?
What’s actually risky vaping nicotine,PG/VG only?  

After taking onboard what everybody told me about not using a 50mg nic salt with a 0.5 coil I switched to 25mg nic salt . I got some new 1.2 coils , it took 3 weeks to get from England , and I don’t like them at all, it completely changes the taste . So back to the 0.5 . So I tried cutting the liquid by 25% with PG ,and it’s ok but not wow . Then I tried mixing the 25 mg salt with 3mg freebase and again it’s ok but not wow . I have used 18 mg liquid with the 0.5 atomiser for yrs so how bad is it using the 25 mg nic salt with the 0.5 coil because that’s the one that I really like .and I don’t feel drunk I feel fine . Thanks John  

I have a ton of 0 mg juice that I would like to make 3 mg Nicotine, but I don’t know where to buy nicotine, what type I need or how to mix it properly. Some of you are going to say search the forums but all the old threads I’m not interested in as things change everyday with products and techniques. That’s why I am starting a fresh post and need help in which would be greatly appreciated.

So that’s one thing I need help with.

Second thing I need help with is deciding which dripping atomizer would you recommend. I’m looking for something that’s came out recently that has good reviews. I don’t have much time to search for reviews so maybe you know what’s hot and what’s not? I know it all comes down to personal opinion and I would like your opinion please. (RDA Specifically is what I’m interested in.)

Thank you.  

74 days without a cigarette so I’m still new to this whole vaping thing.

Started with Juul, got tired of refilling pods very quickly.

Switched to a Smok Nord. Have grown tired of the hit/miss with cools.

Just got my Zenith tank. Went ahead and got the Kroma/Zenith kit and it’s my first non-pod setup.

Like it so far. Only issue so far is there seems to be a lot of juice coming through when I take a hit. When I take a drag but put a thin white piece of cloth over the tip there is a very noticeable amount of brown stain on the cloth. Had the same issue when I got my Smok Nord but I corrected by switching from 50/50 nic salts to a 70v/30p freebase.

Currently Using the same 70vg/30pg 6mg Halo Tribeca.

Using the 1.6ohm coil;
Started at 14 watts;
Dropped to 11 watts and it reduced the juice but also the temp of the vape.
Adjusting the airflow doesn’t really make a difference.

Anyone else having the same issue with the amount of juice coming into their mouth? Is this normal with this type of setup? Did I flood the coil or something? I primed it with 5 drops then let it sit for about 10-15 minutes before taking the first hit.

Will probably limit it use at the house because I don’t want to carry around so much weight in my pocket.  

First off, I would like to say that I’m very new to vaping. I started off with a JUUL, then a Smok Novo 2, and eventually got sick of buying pods.

Now I have a Hellvape MD, and an Ares 2 - the first provides better flavor, but it’s still not comparable to what I was getting in my pod systems. I just recently purchased a BP Mods Pioneer, and I’m hoping that gives me better results. I’m using an Aegis Mini for a mod.

I’m trying to figure out what I’m doing wrong, because it’s really frustrating to spend all this money for worse flavor, when I was hoping it would let me save money.

I have about 40 bottles of salt nic flavors that are 50 or 35 mg, and a couple 3mg freebase I bought (120ml for $7 seemed like a steal). I would really like to get away from the salt nic, but I seem to get even worse flavor from the 3mg.

I’m using 2.5ID 28ga SS316L round wire from Master Wire Supply (I have a spool) with Puffs Organic Cotton. My coils are usually .7ohms, but I’ve tried up to 1ohm. I’ve also tried 1 ohm Vandy Vape Superfine MTL fused claptons, and experienced similar results.

I’m using the MD with the most restrictive airflow settings (3 small hole airflow disk), low (2-3) adjustable AFC setting. I have my coil as low as possible to the airflow, and I have thinned / fluffed my wicks.

I haven’t tried adjusting the airflow below the coil on the Ares 2, because the video instructions say wide open airflow below the coil is the best for flavor (I have found the opposite to be true for the MD).

Can someone provide me more insight?

Will 2mm ID coils with the same amount of wraps taste better than 2.5? Do coil ohms do anything for flavor, or does it only change how fast it heats up? Will I lose flavor if my coils hang outside the diameter of the airflow disk?
Is there a certain type of coil that would give me better flavor than regular round wire?

I use TC at 420F 20 watts


Any kind of feedback is appreciated and if I left anything out or you have questions about my set up that could help me out please ask! I’m at a loss on what to do, and it seems like no amount of research is helping  

Hi,

I just tried to TC vaping - and it’s awesome!

it was harder to build the coil, took me couple of tries, but once I reached R of 1.3, everything started to work.
I used 26awg wire SS316L (that’s what they had ready in the store).
I have no dry hits - at all, it’s just perfect. It’s like having on the fly automatically adjusted curve!

I do have one small problem- 1 out of 10 mod firing - (almost) nothing happens.
is it a problem (not good chip/mod, wire, else?), or is it intended? (Coil overheated, wick is dry, else?). But that’s a small nuisance - I wait 10 seconds and wape again no problem.

what I still don’t understand - why I was always told at the stores “don’t TC vape - it’s the old way, now VW is the way to go” without any explanation.
So far I have a feeling that it was done exclusively in stores interest:
- because they know it’s harder to built, so they didn’t want to have a complaining customer “it does not work”, because the mods for tc probably cost more so it’s tougher sell, and they wanted to sell me more coils, wick, juice...

are there other reasons against TC? (Safety, medical reasons (idk - SS wire releases particles or something - seems unlikely (I know with Ti and Ni you should be causious)), else?

I continue to research this topic as well, online, YouTube, etc, but so far I found nothing against, except what I already mentioned (mainly it’s a bit harder to build the coils).

Would appreciate your opinions!

regards,
Vadim

ps. I use EHPRO Cold Steel 100 mod, Siren 2 MTL RTA.  

Hey Guys,

I have been learning the ropes of RDA vaping, and so far I absolutely love it! As the title states I’m wondering what coils (FC, Aliens, etc) Would be best for flavor and vapor output? I’m currently running some Wotofo 0.33 Fused Claptons (~0.17 in dual coil) @ 60 Watts. The flavor and vapor is ok, But I’m looking for a little more. Maybe something I could run at a slightly higher wattage and get more vapor / flavor?

Any help would be greatly appreciated!

Thanks!