Help With Popping

Having a hard time getting my Dead Rabbit rda to stop popping and sputtering. I’m using it on a VT inbox. So far the only thing that’s helped is dropping the power down, but then I lose the flavor. I’ve got two setups and different wattages on both. One is 0.5 ohms at 30W and the other is 0.3 ohms at 50W. Ideas would help. I really enjoy the higher limits of my coils but get tired of the juice spitting in my face.  


Similar Content



Popping Sound When I Vape

New to rtas and using hellvape md I use 6wraps ss 28ga wire and cotton bacon prime and the thing is my vape makes popping sound all the time....my zpide tank used to pop also but didn't sound so loud I guess cause the rta has the chamber but I was wondering is that normal thing??? I tried wick veeeery tight like I didn't care if I get dry hit just to see if the popping would stop but didn't ...
I tried to go to lower wattage but then I feel like the juice boils and makes me scared I will get flooded coil and higher wattage don't help...do u guys get popping sounds when u vape ? Is it normal? Am I doing something wrong that I can't realise???? XD  

Max Flavor Out Of Mtl Rta?

First off, I would like to say that I’m very new to vaping. I started off with a JUUL, then a Smok Novo 2, and eventually got sick of buying pods.

Now I have a Hellvape MD, and an Ares 2 - the first provides better flavor, but it’s still not comparable to what I was getting in my pod systems. I just recently purchased a BP Mods Pioneer, and I’m hoping that gives me better results. I’m using an Aegis Mini for a mod.

I’m trying to figure out what I’m doing wrong, because it’s really frustrating to spend all this money for worse flavor, when I was hoping it would let me save money.

I have about 40 bottles of salt nic flavors that are 50 or 35 mg, and a couple 3mg freebase I bought (120ml for $7 seemed like a steal). I would really like to get away from the salt nic, but I seem to get even worse flavor from the 3mg.

I’m using 2.5ID 28ga SS316L round wire from Master Wire Supply (I have a spool) with Puffs Organic Cotton. My coils are usually .7ohms, but I’ve tried up to 1ohm. I’ve also tried 1 ohm Vandy Vape Superfine MTL fused claptons, and experienced similar results.

I’m using the MD with the most restrictive airflow settings (3 small hole airflow disk), low (2-3) adjustable AFC setting. I have my coil as low as possible to the airflow, and I have thinned / fluffed my wicks.

I haven’t tried adjusting the airflow below the coil on the Ares 2, because the video instructions say wide open airflow below the coil is the best for flavor (I have found the opposite to be true for the MD).

Can someone provide me more insight?

Will 2mm ID coils with the same amount of wraps taste better than 2.5? Do coil ohms do anything for flavor, or does it only change how fast it heats up? Will I lose flavor if my coils hang outside the diameter of the airflow disk?
Is there a certain type of coil that would give me better flavor than regular round wire?

I use TC at 420F 20 watts


Any kind of feedback is appreciated and if I left anything out or you have questions about my set up that could help me out please ask! I’m at a loss on what to do, and it seems like no amount of research is helping  

Best Type Of Juice In A Mtl Rta

I got a great number of responses on my last post, with tons of useful information, so here’s another question I have for you all. What is the best type of juice for flavor in a MTL RTA?

I’ve found that lower mg salt nic usually tastes better than its higher mg counterpart - I.E. a 30mg and a 50mg bottle of the same juice will taste better in the 30mg option.

I’ve read about people smoking 0, 3, and 6mg freebase in pod systems, so I bought some myself to try it out in my MTL RTA (the lady at the vape shop said 3mg would have a lot more flavor than Nic salts).

I’m not sure if I somehow got a bad batch of juice (I have 4 different flavors/ 2 different brands so idk the likelihood of that) or what, but it doesn't have a prominent taste.

Ive tried from .6 to 1.2ohm coils with 28ga stainless steel single round, as well as some 1ohm mtl fused claptons. Is it possible to make the juice work with my current set up or do I need to buy different gauge wire and up my watts? I’m not interested in heavy cloud production, just flavor.  

My Daily Juice Consumption Is Becoming Outrageous!

So....been vaping for 6 years.

For the last couple years I was using a Reo with an RBA at .5 ohms and was going through about 12-15ml a day. A friend of mine let me try his sub ohm tank a few weeks ago and I was hooked! The flavor was better than my Reo/RBA setup and the vapor was OMG.

Anyways, I've since bought a couple of sub ohm tanks with an IPV2 Mini, then graduated to a Goliath RTA with an SX Mini M Class. Using the Goliath with a .44 ohm dual coil at 30 watts on the SXM and I'm going through anywhere from 25-35ml a day! This just seem excessive....

Can anyone recommend an RTA that would use less juice but still give me a lot of airflow and flavor? I'm not all about the vapor, although I do enjoy it.

I'm guessing that if you want lots of airflow (I'm a direct lung inhale kinda guy) and a warm, full vape you pretty much have to vape at higher wattages/lower ohms and therefore use excessive amounts of juice...just wondering if anyone else has had a similar experience and has successfully cut down their juice consumption.

FYI, I DIY my juice so cost is not really an issue...I'm a bit concerned that using this much juice every day just can't be good for you.  

Round Wire Vs Fused Clapton

I’m a mouth to lung vapor and currently using the holic rda and galaxies rdta. I’ve tried using ni80 round wire and superfine mtl fused Clapton ni80 wire. The round wire is so easy to work with and the superfine is harder but I’m getting the hang of it. My question is with coils that ohm out the same with each wire I get flat flavor with the round wire and the flavor definitely pops with the fused Clapton wire. Is this normal? Same juice, same wattage, same ohms and same rda and squonk.
I love working with the round wire but not worth it if I can’t get better flavor.  

Mvp 20 Watt Not Reading Ohms Right

My MVP 20 watt recently started to get a little wonky on me. I use 1.5 ohm coils in an aerotank but for some reason the MVP is readin it as 4.9 and sometimes even higher. Of course its not hitting right either. I know its not the coils because if i put that same tank on my MVP 2.0 it reads correctly. The MVP 20w doesn't do this all the time but today its been doing it all day. It won;t go below 5 ohms and sometimes its even higher. Is this thing shot?  

Having A Hard Time Adjusting.

I’ve been away from vaping for about 7 yrs. I don’t have any of my old equipment, which now I miss very much. I’ve been trying to get back to vaping for health reasons, and having to learn all over again. Everything is dual coil. I NEVER used dual coil, but I’m trying to learn. I got a Vaporesso PM40, a Drag S a hcigar vt inbox and a POS squonker that I’m using for a dripper (reviews said they leak and short out causing me to fire by their self. I joy cappo squonk box).
Do I figure dual coil watts and amps like I did my single coil builds. I never got into the low sub-ohm thing. Maybe 0.9-1 ohm.
It’s good to be back in ECF again.  

Old Vapor, New Sneezing Attacks - Forced Back To Ash Tray!

Last week on a road trip with my motorcycle club, I had to go back to the “ash tray”. It’s to dangerous on the road, on “two wheels” with these constant sneezing attacks. I bummed cigarettes, then bought cigarettes. There’s thousands of road miles planned this summer, I’m leaving again next weekend. I love to ride, hate cigarettes, the taste, smell and cost but vaping will surely kill me!

There isn’t much of anything here or on the WWW about my issue with sneezing attacks. Not just a little sneeze but 4, 5 6 or more with an irritable urge, watery eyes and nose. When I put down my vape for an hour, it goes away, when I hit it, it starts back. Allergy medicine doesn’t stop it and makes me drowsy. This just started about 3 weeks ago, it’s like I’m suddenly allergic to...?

I’ve been vaping since 2013 when my lovely 77 yr old Aunt shared her vape. I had tried everything on the market including prescription drugs and hypnosis to put down my 20 year pack a day stink habit. For 5+ years I’ve been using an RTA and DIY juice. I’ve been using the same DIY products from Nicotine River (fresh frozen) since Dec 2019 as well as same flavors, TFA, LorAnn, Capella and same recipes. using a VG 70/30 @ 8+ Nic.
For 4+ years with zero issues I used the Lemo 2. Yes an oldie, but ya no how it is when you find a good combination. Until last year, I could get all the rebuildable supplies at Fastech. Since 2020 I’ve been buying and using different RTA’s, RDA’s Squonks, mesh coils, etc. searching for a “new love”.
My tanks are Profile Unity, Zeus Dual RTA, Creed RTA, Drop, Brunhilde and Dead Rabbit. JIC it was the new packaged supplied wicks & coils, I went back to my old wicking material which didn’t help. Tried 100% VG with VG Nic Salts, no change. I’m at a dead end, totally out of ideas, I give up, still hate cigarettes but...

Any thoughts would be much appreciated!  

Premixed Vape Juice Shipping

With everything going on in the vaping world I was wondering if we’ll still be able to buy PG/VG premixed.
I buy premix PG/VG with nicotine already added so I’m wondering if I should buy 4 or 5 gallons to make sure I can get it.
Also I was told that if I buy a few gallons that I should freeze it or refrigerate it,is that right?
I sell mods and tanks so I have plenty to last years because I use to sell them on ebay until they ban selling them on the site.
I’m on private sights but don’t know what’s going to happen after April.
I live in New York so we already are have a juice ban so I mail it to a friend in another state and they forward it to me.
Now I’m buying premix so I can just flavor my own juice but I’m worried they might stop shipping premix PG/VG and then what will we do?
So any information on what’s ahead I’d appreciate your information. I’m new so I’m trying to learn how to find information on here.
Thank You  

What Coils And Battery To Use??

I bought a Kanger Subtank and Atlantis V2, but sold them because they just weren't wicking my 100% VG liquid (Velvet Cloud & Gypsy eJuice) well at all. I tried using the atlantis with the .3 ohm coil installed at 70-80W, which was the stated operating range, and found it to be EXTREMELY hot. So hot that the tank quickly heated up to the point of almost burning my lips. The Kanger just burned the wick up at 20W+ with the .5 ohm coil, despite letting it sit filled for a few minutes and priming.

I am very interested in picking up a Royal Hunter, although I've no idea what pre-made coils (i dont want to make my own coils, just dont have the knowledge or time to learn how) and battery to get. VaporDNA sells UD pre-made coils in various resistances, but figuring out what resistance to use, and thus what wattage battery to get is where I am stuck. Not sure if it'd be better to run at lower ohms / higher wattages, or higher ohms / lower wattages. I'm not sure if it's possible to get massive clouds, but a cooler vape at the same time, but that's my aim.