Has Mooch Blessed Any 3.7v 18650's?

I am interested in setting up an Arduino charger for my vape batteries. But the charger I want to use, an Adafruit bq24074 solar charger, does not support nominal 3.6V batteries. And basically all the Mooch approved batteries are nominal 3.6V. So, which 3.7V batteries are considered fairly robust for high current, vaping purposes?  


Similar Content



Efest 18650 (purple) Questions

Hi folks,

I recently purchases a Sigelei 100w box, and got the purple Efest batteries that the vendor recommended.
I'm using this with a KangerTech Subtank Mini.
It's currently set to 42W - 5.0V, and the resistance it shows me is 0.6 ohms.

I have some questions about my setup.

- I read some reports that these batteries have different specs than what is reported, and it could potentially be dangerous. What should I do to be safe? Is there a max W/V that I can set it to?
- I have a TrustFire TR-001 charger (output: 4.2V / 500Ma). Can I charge those batteries with that? I read the charger supports 18650 batteries, but I'd rather be sure...
- If the charger is no good, any recommendations of what I should be using?

Thanks a lot!  

Some Series 18650 Questions

I bought my Sigelei 100w Plus a few days back and ordered 2 Sony VTC4's on my same order (I'm confident they're legitimate, I've bought some before) to be able to marry them together and use them with my Sigelei. Upon receiving the batteries, I labelled one A, and one B and put them into my charger at the same time (charger was off, put both in and turned it on), one battery is slightly more charged than the other (it's 2/3 bars, while the other is still 1/3). I'm a bit worried about using married batteries, I understand rotating A and B in my Sigelei and charger but will they be the same charge when they're done? They're new batteries and they both went on at the same time yet one of them is charging a little bit faster.

When both of the batteries are fully charged, will they be safe to use and cycle accordingly? I heard about if one battery has even a tiny bit less, the batteries will take an uneven load and it will make it risky. How do I ensure that these batteries remain married?  

What Batteries And Charger Should I Get For This

I wanna buy the sigelei oni edition 150watt but iv not used any box mods that require batteries yet, my jellyfish and innovkin has internal batteries, can you gents recommend 2 good batts and charger. and is there any tips i might need to know.  

Ego-t Battery Not Screwing Into Charger

I ordered two of these batteries from FastTech. The cheap price and high capacity (without having a mod or some awkward huge battery) attracted me to them. Some two weeks later they show up...

I have two Puff King chargers that came with starter kits we bought at a B&M store. We've been using them with Tripl3 eGo batteries, one Puff King battery (and another Puff King battery, which was taken back and exchanged for another eGo-T battery, which broke), and so far no problems screwing any batteries in. These two from FT show up however and neither will screw into one Puff King charger, but they both did into the other (same charger, down to the model number and everything). Now, one battery from FT still screws in, but the other doesn't.

I took the non screwing in battery to a local B&M store and the guy there was able to screw it into one of their chargers. He handed it to me, and I unscrewed it, screwed it back in, unscrewed it again, and then neither of us could screw it in again. Now I have one battery from FT that will screw into one of my chargers, but not the other. The other battery will charge, but it has to just like sit in the charger and hope the connection stays okay for it to charge. I still have no problems screwing any of my other batteries into either charger, just these ones from FT. Also, it's worth mentioning that the FT batteries never seemed to screw in right... it always felt weird and finicky getting it to go in.

What's up with these batteries? They claim to be eGo/510 threaded, just like my other batteries. They look just like my other batteries too, except they won't screw in right...  

Which 18650 Batteries And Which Charger For Vaporesso Luxe S?

im going to buy a vaporesso luxe s and put a uwell valyrian 2 tank with either a triple or quad coil in and im not sure what batteries are good also which 4 port charger should i get? thanks in advance  

Any Reputable Canadian 18650 Battery Vendors?

Hi everyone,
Hope your all having a great weekend! Hopefully someone can help me figure out any good canadian or American reputable vendors for 18650 batteries for my arrow sense mod. Out of all the vendors listed in the battery thread, only one had the batteries I wanted, but it was in the US and would cost over $50 for shipping. Hoping to find shipping for $20-30 canadian instead. I am particularly interested in the batteries on the forums listed as tested by mooch in a stickier post. Or Sony battery with 2500 mah , I like to vape with two 18650 batteries at 60-80 watts.  

What's The Best Duel 18650 Batteries For 30-45 Watts Of Vaping?

Hi, so I have several different brands of 18650 batteries but I'm getting ready to pick up the new Geekvape Aegis X, I wanted to get some new batteries. I have been reading up on it but I'm so confused, I don't vape very high wattage It's always under 50 watt, 45 usually being the most, so what would be the best batteries for long activity? Any input would really help. Thanks  

Any Box Mods With Batteries Built In?

Im looking for a good box mod that has batteries built in, like a usb passthrough/charger, I cant seem to find anything on it. Something that could go up to 50w would be preferred, not really looking for anything over 100w, I dont really think i would need to go that high. I currently use a nemi clone for most of my vaping needs, but id like the option to be able to vape while i charge  

Best Way To Recharge My Molicel P26a

LONG STORY:
Following a previous thread (Question about battery and coils (Swag II)) I have been using Molicel P26A with my two Swag II's for a couple of months.
I purchased four batteries but I have been using only two of them. I always keep them in the Swags, since I use the Swags to recharge them. Practically I keep one of the Swags under charge while I am vaping with the other one.
I find this routine very convenient however I am wondering if that is the best way to recharge them. While a the begining both batteries were working quite well until they reached a 20% level, now one of them seems to be very weak as soon as it reaches 50%, and for that reason I have decided that it was time to replace it.
The other one is still Ok.

SHORT STORY:
Is it ok to recharge the P26A's with the Swag II's or should I use an external charger? Would an external charger significantly improve the life of the batteries?
Also, can an external charger fix a battey that seems to have lost 50% of its capacity.  

18650 Batteries

Hi I just got a sigelei 100 watt plus and this is my first time using freshly charged batteries in it... it's still reading at being 100% in the sigelei. ive been using it for maybe 3 hours total . Is this normal .. because its starting to make me wonder if something is wrong. Its been at 40 to 50 watts this whole time. I didnt charge the batteries at first when i got them because my charger did not arrive yet...then once it did come i charged them and now its continuing to stay at 100%