Gurgling Nautilus

I'm just breaking in my Nautilus on my Aspire battery, as of yet I expected a bit more vapor production from this set-up at least 2x more than my Triton.When puffing on it frequently, it runs a bit hot even with the 1.8ohm coil.Eiether the Nautilus or the battery likes the 1.8ohm coils better than the 1.6ohms why is that?I also experienced leakage and gurgling. Once I put a new coil in, that went away. I'm just thinking how can I get a bit more vapor production.It's better than my Triton but not by much.Is it the battery?  

I've got a Nautilus with a 1.6ohm coil, and an iStick 50w. On the side of the coil it says 3.2v-5v, and I want to know if that's just a guideline or a limit for the coil.

I'm running it at 4.8 volts, but I get better flavor and vapor at 5.5 volts. There are no wicking issues or burnt taste at 5.5v, but I don't want to damage the battery or the coil. Any advise would be great thanks!  

okay so i hope i'm posting this in the right place, but i have a nautilus mini that i've had since december and i just bought a new coil for it yesterday from my trusted local vape shop and it was working okay at first, but then it started gurgling and spitting juice into my mouth

this isn't the first time it's done this, i actually stopped using it for a while because of this problem (and the coils were old, so i thought that's what was causing it) but i just put a new coil in and it's still happening...

i have scoured the internet for reasons why this might be happening and i've tried every trick in the book and nothing has worked

PLEASE HELP!  

I have a Sony vtc5 that won't charge. It was charged and working fine. It wasn't hot, did not vent, it just stopped working. Any reason this would happen? It's not my rda or mod because I put my other vtc5 in the mod and it fired just fine.  

Just wondering what everyone who has used both tanks think of there effectiveness. A 1.6-1.8 bvc coil nautilus vs a 1.5 micro coil in a kayfun v4 (clone). Would you rate them the same?? I only ask because it seems the nic (6mg) in my nautilus tank at 17 watts has less effect than my kayfun 4 (tobecco clone) at 17 watts, (same juice 50/50 mix) Obviously the kayfun is not a dripper, but does the micro coil have any impact as far as vapor effectiveness??Sometimes I think I get a little nic sick compared to the the nautilus mini. idk maybe I'm just paranoid lol  

So, as the title says, after about a month with the ITaste CLK 1280, I want to go ahead with the ITaste MVP 3 and hang onto that for a while.

I am just debating which clearomizer i should use to go with it. The original Aspire Nautilus(5ml) or Aspire Nautilus Mini(2ml)?
I go through about 3-4 ml at least a day. But is the MINI worth having to refill?

Much thanks in advance!

-Luc  

Starting from a clean - authentic nautilus mini - with a brand new 1.6 (or 1.8 it makes no difference) coil (coils also verified as authentic).

1. Turn tank upside down - with tip removed and fill with juice.
2. Take base unit and set so no air holes are open.
3. Put a tiny bit of juice around the o ring of the base unit (i get the issues if I do this or not)
4. Put 2 small drops of juice into the coil (I get the issues if do this or not)
5. Screw the coil into the base unit (as tight as you can comfortably get it without going past the obvious stop point and damaging something)
6. Screw the coil/base unit into the tank.
7. Turn nautilus mini correct way up.
8. Move air hole to a middle setting.
9. Take some primer puffs with no power.
10. Leave standing for 5-10 mins.
11. Begin vaping gently at 6 watts - moving up slowly to 10.

Ive tried all types of juice - both high VG and high PG and in-between. Invariably at some point i start to get the gurgle. Ive tried the following fixes:

1. Using a paper towel blow gently out of the air hole to get rid of juice - doesn't work - if i kept on blowing id blow the whole tank of juice out.
2. Take the unit apart - most times there will be juice in the base unit underneath where the coil sits - dry this out - dry the coil off and repeat from step 2 above missing out steps 3 and 4. - this sometimes works but its a temporary fix.

There seems to be no pattern to the problem. Sometimes the gurgle starts as soon as ive changed the coil - sometimes its ok for a week. I have 2 units and 2 spare tanks and have rotated them all using the above method - still get the issues.

I have actually never experienced the burnt taste or reduced draw because Ive always got sick and binned the coil before that point.

I am vaping generally at 9.2 watts - but have tried as low as 7 and as high as 13 - it makes no difference.

I don't draw hard - I cannot understand why I keep getting juice in the air chamber - its not a problem with a "dud coil" unless they are all intermittently dud coils - they are all authentic aspire and I've bought them from different places - so its not a dodgy batch issue - the rings are all the correct way up - I have spent hours and hours researching to try to fix these issues - and cannot for the life of me maintain a stable nautilus mini.

Can anyone save me from madness and tell me what Im doing wrong - Im tending towards a conclusion of all nautilus mini components are junk at the moment.

Many thanks in advance  

Curious if any of you have gone to the Kanger Aerotank from the Nautilus Aspire tank? I have two Nautilus tanks and I have to say it is real hit and miss when I change the coils out. Sometimes I will have a clean hit and no burnt taste and other times it is burnt tasting for the life of the coil. A local vape shop told me to switch to the Kanger Aerotank. They did not have it in stock so I ordered it to try. Yes I am doing the whole prep scenario with the drops and hitting it 4 to 5 times before hitting the button. He told me it is common with the Nautilus, but not with the Kanger Aerotank. Any feedback?  

My GF is a chronic smoker (over a pack a day) and Ive been doing a heap of research into vapors in an effort to help her quit, I just bought an Aspire Nautilus Mini for her but upon further research i notice some users were worried about the ceramic fiber in BVC Nautilus Coils.

I know Aspire claims the ceramic filter is ok but there is lots and lots of research to show ceramic fibers cause cancer, so whilst my GF has bigger problems with her excessive smoking i dont want to give her something to compound the chances of cancer.

Question: Can i fit and use a BDC in a Nautilus Mini? the filters are different but i know they are interchangeable, i just dont know if it will work? anyone tried?

The BVC contains the ceramic coil and the BDC doesnt?

Thanks for anyone with a reply, i appreciate your time.  

So I've been vaping now for almost 5 months. I own 4 different regulated mods, many sub ohm tanks and a few rda's. I'm wanting to pick up a mech mod, but not sure which would be better. I'm pretty much looking at either the nemesis clone or the stingray x clone. Any thoughts on which is better, or any other mechs that I may want to look into?