Stumped On A New Ecig Type

My mother in law just came home with a new Ecig. She is fairly old, yet insists, no matter how how many people tell her, that Cigarette sized ecigs are NOT economical in the long run. Don't even try to make suggestions, she's really stubborn.

Anyways, she's been off of Cigarettes for a while, and has been using an EGO/Stardust combination for almost 2 years. She said her battery wasn't holding a charge, and decided to pickup a new ecig. She bought something called a Mistic brand ecig...but it has a tank on the end of it. The whole unit is about the size of a normal cigalike. However, the end is a mini tank system. I tried it, and little vapor comes out of it.. which she says is fine. I will say, the products looks nice.

It seems it has a very small battery in it with a smaller than a mini protank II style general configuration for the atomizer. I doubt the thing holds a mil, and I doubt the battery is over 100MaH. The unit screws off the battery, and then the coil and wick unscrews out of the tank. It reveals a setup similar to a mini protank, where the chimney goes into the coil. The coil is TINY. I tried peeking down to see if I can see the coils, but I couldn't. I can't find any sort of specs about the product, type of connector (It's smaller than a 510), battery size/capacity, or even where to buy replacement coils. On the box, there is a website... MysticVapors.com is up for sale!!, but even that site is vague on anything about it and only sells the starter kits. Is there any information about the device anyone knows about? Its a cigalike size with a tank. Can replacement coils be bought? any gotcha's (besides incredibly low amount of vapor) A link to the exact item she bought is HERE. I feel she's just wasted money, but if I tell her that, she just gets all huffy.


Thank you in advance.  


Similar Content



Help Me Choose My New Ecig!

I have had a kanger protank 3 for a year and a half now with a itaste vv battery, i need a new updated Ecig now.

I am willing to spend around £30 (no more than £35) and would need a battery and a tank.


I want the best flavor and vapor production for the money. I also want it to be reliable as the kanger protank 3 leaked a lot in my time and sometimes would randomly stop working.


Thanks guys!  

Why So Little Love For Side By Sides?

Over the last 24 month or so, mods became bigger and bigger due to increasing sizes of batteries and comically large tank attys. Don't get me wrong, I appreciate the fact that I only need to change the battery and fill the tank once per day, that's awesome, however, some of those devices got to a point where they became not very portable anymore... Gone is the time in which the mod can be put in the pockets of your pants.
So, as far as I'm concerned, I got realy tired of those huge mods and went back to one of my first mods, no VV no VW no temperature control.... Its the REO mini..... Super small and tough as nails.
After a while I kept looking for something comparable but a non squonker mod. I found the Ministick with the 18650 extension.
I have it now for a few weeks and I'm sooooo happy with it.
It's just a tad larger than the REO mini but it carries the 18650 battery and the Kayfun V4. This mod would be quite a bit smaller than the REO mini if I take the battery extension off, which is very impressive.
I will very likely never buy another regular tube or box mod just due to its size.
I see only pros for side by sides, they are the perfect combination between small size and good battery/tank capacity, so I'm naturally wondering why they are so little loved?
What is your point of view?  

Can I Get Some Help Getting Setup Please?

Haven't vaped in like 8 years? So most of everything is new to me now..
But I did a little reading and I figured out a few things I need in a vape, but really there is so much, it's kinda hard to know what is good and what is not for brands and styles, so I'm hoping I can get some help by experienced vapers here.

I'm looking to quit smoking and here's what I'm looking for in a vape setup.

MTL Mouth to Lung setup so I can draw in and then inhale like a cigarette, but I would like a decent cloud. Not looking for huge, just good and maybe be able to slightly adjust what gets produced with using only 50/50 juice blends.

RTA setup? I need a rebuildable coil tank system.
I need to keep my maintenance cost low, so I need to be able to rebuild new coils.

No leak tank is a must. Needs to lay down on side on table and keep in pocket.

1 battery or 2. Doesn't matter much.

Would like a smaller mouthpiece compared to the larger style so I can get a good MTL draw.

Not sure what my options are for tanks and box mods or pen style? I think I need some kind of box mod? So i can slightly fine tune watts, volts to my coils if it just doesn't feel right and needs minor adjustments? Also like the option showing how many seconds used or draws.

There's so many tanks out there, but it's hard to tell what is really good.
The battery side, I really have no idea what I would need... watts, ohms, voltage.. with all the combinations, I can figure out what I really need..

Not looking to just be easy simple. I want good quality and I can only buy once.. I can't really afford it as it is, but I need to stop smoking..
But I want to buy once and be good for long time and not wish I bought something else. I just don't have the money to play around like that..

So I hope I can get some help here or suggestions to get me looking in the right direction for tank and battery side system.

Quality brands?
Brands to pass on because there is better options?  

Different Nautilus Bvc Coils Floating Around..picture Included

Hey all,

So, I've been really happy with my new setup (iStick 50w and 30w, Nautilus and Mini Nautilus). Everything has been working smoothly, but I have a problem with the replacement coils I purchased (and cannot return).

Went to go change out the coil in one of my tanks this evening. Filled the tank up as usual, made sure the air shaft and drip tip were clean, screwed on my new coil, filled the tank, and let it sit and wick up for half an hour. Took some pulls without firing, dropped it to 8w (to "step up" and prime the new coil), and immediately got a nasty burnt hit that I can still taste an hour later. Unscrewed the tank to see what was wrong, and noticed the wicking material was bone dry.

For the longest time, I could not figure out what happened, why it wasn't wicking...until I looked closer. The e-liquid holes on the replacement coil I have are TINY! The coils that came with the tanks have holes that are at least twice, maybe three times the diameter. The holes are so small that my e-liquid will not even enter them to soak the wicking material. I checked the serial number scratch off on Aspire's site and both boxes of replacement coils I have came up as authentic.

I'm displeased. $22 down the drain, now I have to rush and find a dealer who has the "correct" coils. I cannot use these coils whatsoever, and the dealer I purchased from does not accepted returns on atomizers.



On the left is the coil that came with the tank (both of my tanks came with this exact same coil, and two replacements that look exactly like it, but I've used them up and am on the new ones). On the right, the coil I purchased in a replacement pack of 5. You can see they look nearly identical, except for the size of the wicking holes. Also, the piece at the bottom seems a bit more flimsy, as you can see in the picture, it's not exactly straight with the rest of the atomizer.

So, can anyone point me to a dealer that has the coils I need? I'm afraid of ordering from somewhere and getting the ones on the right, which are useless and do not soak up any e-liquid whatsoever.  

Very Disappointed With Sub Ohm Vaping!

I started vaping ages ago back in 2007 or thereabouts.
The only ecigs available then were either 510 or older type 801 atomizers.
We then bought the chucks and vaped on 6 volts with 5 ohm atomizers for a while. (Custom made Vivi Nova 5 ohm coils)
This "while" lasted for years, and I am a little "out of the loop".
I recently bought an IPV mini 70 watts with a few subohm tanks (Kanger, Artic, Herakles etc, 0.5~1.2 OHMS).
The internet is riddled with videos of guys blowing huge clouds of vapor with these sub ohm systems. This intrigued me.
What they do not tell you, is that it is impossible to take a mouth to lung puff, because these tanks afford too much airflow.
Personally, I feel very uneasy breathing anything directly into my lungs. My older 801 and 510 atomizers sometimes spurted out liquid.
I would like your thoughts on this one?

I find that a mouth puff gives you more taste. It's sort of wasted if it goes directly into the lungs.
Another thing I discovered is that these sub-ohm tanks vape much hotter than my previous e cigs. I cannot get a cool/cold vape no matter what wattage I use.

Thirdly, The kanger sub ohm mini coil crackles loudly, sort of Pops loudly from time to time. This greatly annoys me and adds to my lung inhale paranoia.
I'm a little stuck at the moment, and do not know what ecig/tank/coil system to transition to.
 

Having A Hard Time Finding The Right Set-up

I'm having a mad time trying to find a tank or clearo to fit a relatively small battery to upgrade from my triton without having to go to a MOD set-up I need a nice drip-tip too.It seems like an in between of my Triton tank and a MOD I can't quite find the vapor production I'm looking for I lowered my ohms on the triton 1.8 it did produce a bit more vapor but the tanks just aren't built for those ohms and they run to hot.I've already gone through three coils.I looked at the Aspire Nautilus mini premium kit not completely sold on it, eGo One battery with Nautilus mini but I think the tank I'm looking for should hold more e-liquid.Any help here much appreciated.  

Am I A Luddite?

Or maybe even a heretic, or a blasphemer?
I like mini tanks and small batteries. My favorite setups are mini protank version 1 clones with 650mah basic ego style batteries. Stainless steel finish, no funky colors or designs. Single bottom coil on the tanks, no air flow controls. Standard voltage batteries, no twisty things on the bottom, no usb passthrough, no digital displays, just a battery. I like the ego style because the protruding button is easier to find and helps keep them from rolling around. The lack of features I don't need means the batteries are small. I like small, sleek, simple.

I have a nice big fancy Smok vv/vw battery. If I cut my juice in half with VG I can blow some massive clouds without knocking myself out. I found this to be mildly amusing for a short period of time. I also found out that with my regular mix when I dialed around for the "sweet spot" I ended up at 3.7 volts...

The mini tanks don't hold a day's worth of juice, and the 650mah batteries don't last all day. So what? Tank gets low, twist it off and pop another on. Battery light flashes, same thing. I've got a battered old EGO case from my first starter kit, it holds four tanks and batteries and a bottle of juice with room to spare.

I got my first mini pro tank from a vape shop. I just assumed it was a Kanger, but there was no mention of Kangertech anywhere on the packaging or tank. Whatever, I really liked it. I figured the real deal would be even better so I ordered one online. Kanger had discontinued the version 1, so I bought the "new, improved" version 2. It was good, but I liked the clone version 1 better. The clone tanks are polycarbonate rather than pyrex, but I don't vape plastic eating flavors, so that's a non-issue.

Now I'm not knocking all the cloud chasing, coil winding, wick trimming gear heads that seem to dominate these forums, but if there's anybody else out there who enjoys vaping with a nice, simple, inexpensive setup, I'd like to hear from you.  

Using A Different Coil For Aegis Mini Kit With Cerberus Tank

Hello, so i have been vaping with this new Aegis mini kit with a cerberus tank that i bought a couple of weeks ago. I have used up the 2 standard coils that were in the box, but for some reason in my country i am not able to find specific coils for aegis mini kits online (I live in Belgium). My question is if there are any other (more available) coils that i could use in my cerberus tank? I don't want to pay like $30 just to have them shipped from the UK to Belgium to be honest as they should be aroun $16 for a 5-pack. I noticed i could get "Geekvape Cerberus coils", would these fit my cerberus tank? Maybe a dumb question but you can't be sure enough.

Thank you in advance!  

Obsess Much?

Just sat down this morning and had a quick look at where all my money's been going for the past few months.
Previously, I had smoking down to ~5 a day. Used to get them all from abroad, so roughly £5 for 20 at most. 40/week so £10/week and £520 in a year.

My current ecig spend:
£30 for first ecig
£25 for a Vision Spinner Battery
£15 for replacement tanks
£40 replacement coils (standard coils, then unicoils)
£100+ - Totally Wicked liquids
£50 - iStick
£25 - Subtank mini
£70 - mixing kit and concentrates
£50 - e-sheesha + cartomisers
£50 - premium liquids

£455+ (and that's just about 6 months, started in October)

I know that most if it was invested in the kit, and now that I have my ideal setup I hopefully won't be making those expensive purchases anymore on tanks and batteries. The DIY kit has enough to keep me going, now it's just buying concentrates that I need for recipes. I would have saved a lot more if I'd got the quality kit early on, but at the time I was new to it and wasn't sure if it's something I'd pursue.

It's probably not even that much in comparison what others spend, but I still feel like I've spent way more money than I should have.
Anyone in the same boat?  

Need To Update My Spinner And Protank

Hi,

I am currently using two different Vision Spinners (900mah and 1600mah). Both are variable voltage. I have paired the spinners with the Kanger2 Mini protank.

I vape at about 4.3v. I use 1.8ohm or 2.2ohm coils. I have been happy with the result so far.

I am not interested in a big old MOD or anything. I like the pen-like style.

I bought an Aerotank Mini that turned out to be a clone and it didn't work. Maybe it came with a bad clone coil? I don't know.

Any suggestions on updating the mini protank 2 and the Spinner? There are just way too many products and I have no clue where to start. The short life of the Kanger colils has been pretty annoying. I read they have better coils now for the Protank 3.

Anyway, thanks for any input on this!