Imagine your self filling an RTA with fresh juice, only to have the worst vape you can endure as you cough up a lung. No its not a dry hit. Do you blame the juice or a clogged up coil? In this episode, I will take a short journey and explore to a better vape.
After a week of chain vaping, over 50ml of juice, a mix of 3mg and 6mg Nic, the rayon wick has finally given up and no longer produced a clean vape. After visual inspection, the coil and the wick has indeed had a significant build up from juice. To the point that I could no longer see wick material between a spaced coil.
After discarding old wicking material and cleaning the coil, i wicked an RTA with fresh Rayon and filled it with juice. My favorite tobacco juice has come a live, i can now take long and deep direct lung hits with enjoyment. My taste buds are intoxicated, as my lungs fill up with smooth and silky vapor with every inhale.
Keep an eye on your coil by visually inspecting it on daily basis. Trust your body and your taste buds when a juice no longer tastes as it should. Re-wicking your RTA/RDA on regular basis or every few days, will help you eliminate many concerns and issues that you might be having with juice flavor or vaping experience.
It only takes ten minutes to rewick, and in return you will continue to enjoy many hours and days of pleasurable vaping experience.
Good Night.
So I decided to get another clearomizer and the Donner by Amigo Itsuwa is what I got to replace my Aspire Atlantis.....
So here are my thoughts on it and it's just My Opinion:
Holds 4mls of juice - holds more juice so I'm not refilling my tank 2-3 times a day
.50hm Coil head is cotton & Kanthal wire & a wire mesh around the opening for better wicking ( You can use Atlantis coil in this thing and it's better in this tank then it is in the Atlantis) It comes with 2.
There's no notches or trying to center the coil head. It sits in the Clearo and just sucks juice lol
Great Flavor sub-ohm - The flavor you get from this is amazing, I was a little taken back bc I chose a sour raspberry and it really was more sour tasting then in any of the other tanks I had the same juice in
I personally like the drip tip but it's not for everybody
Adjustable air flow control is a wide slot - It's a slide around, but the draw from almost closed to full open is nice any way you wanna vape.
Vape production is great I use 10/90vg - 20/80vg
There are some things I don't like about this tank...
Priming the coil is a process - on a fresh coil the directions state to drop a few drops onto the coil, then once tank is filled let sit for 1-2 minutes prior to use. On your second fill of the clearo you have to let the coil sit for 2 minutes b4 use....I kinda wanna fill and vape, not fill and wait
Holding 4mls of juice is great, but if you can't vape 1ml of juice at the bottom of your tank it sucks. You can't vape the last ml of juice because the coil head sits to high so it can't wick the remaining juice.
I did find that when I put the Atlantis coil head in that the wicking was alot better then the coils that it came with, now this could be bc I am using a high vg juice.
So let's talk price....I bought this at a B&M so I paid A LOT more then what I've found online.
My price was $45.00
I have found these online for as little as $23.00
and for this price I would probably buy it again, not for $45.00
Iv'e been vaping on this for about a week now, I've gone through 2 coil heads in 4 days & now put the Atlantis coil head in it and am having better luck with it.
So there's my thoughts on my new clearomizer.
Sooo last weeks I was able to wick my atty in a way that for me it's perfect...no dry hits no leaks or flooding or anything and I enjoy Soo much...
After vaping some strawberry cookies and chocolate....(very dark juice coil abuser) it was rewicking time...
Put fresh cotton and start vaping and dammm bad taste....dry hit
Tried make it work...nothing...
Ok let's rewick...again same dry hit
Not anything crazy but just that light dry hit bad taste....
After rewicking 3times and using almost no cotton hahaha I was like ...... Cant dry hit now
TURNS OUT IS WAS A JUICE I BOUGHT ALREADY MADE...WAS CUSTARD CARAMEL AND SOME CEREAL STUFF TOGETHER OR SOMETHING
THIS THING TASTES LIKE DRY HITS!!!
WHAAAAAAAAAAAAAA not exactly same taste but was very similar EWWWWWWW
I AM SUCH A NOOOOOOOOOB
anyways that's all....I make my own juice just forget my bottle and I was at work so I bought a juice from a store nearby
So I'm using a juice that is pretty sticky. So sticky that when I squeeze the dropper to create suction I have to actually wait like 3 seconds before the air escapes the tube and longer for it to fill with juice.
So when I'm vaping this, the vape seems to be a bit on the weak side and I think its because of the wicking. could anyone advise me on how to wick my coils? (ex. more/less constricted inside, more/less in juice well)
The setup inside my RDA is dual 24g coils with an internal diameter of ~2mm with resistance ~0.2 ohms. Wicked very lightly constricted and just long enough to make a full contact with the juice well on both sides.
Two issues I wanted to fix. The first is the battery run time using the low ohm coils. Second is when the e-liquid gets to the top of the sub ohm coil housing in the Kangertech I've noticed a lot of dry hits when heavy vaping, ( I like a higher VG juice. ) I would find myself closing the air intakes and sucking hard to get the wick saturated, ( a real pain in the ***. )
NOTE: I like an airy hit and run the air intake ports full open.
So here's what I did.
I've drilled the wick holes out to 3.5mm in the Kangertech coil housing. Then built a 1.1 ohm coil with 4 strands of 32ga. kanthal, ( twisted together first ), 5 wraps around a 3.47mm screwdriver. The coil was very springy to work with but got a bit stiffer after torching t closed to 1/4" width using adjustable tweezers. I used regular ball cotton for the wick in this experiment. The coil came in at 1.1 ohm.
Primed the wick and filled tank with a little bit of juice, just below the top of the coil housing.
All I can say is WOW. The first 10 hits taste a bit crappy but after the break in, WOW.
Taste and vapor production are great. There's a bit of crackle but no pops. Crackle I don't mind, Pops I mind. The ClouporT8 counted 75 hits and now the e-juice level is just above the wicking ports by a hair and still working great with full open air intake ports.
I will add post after I've used this set up for awhile.
Curious what other think!
VapeOn
I've been using 50/50. What's the best to use to extend the life of the coils? I get huge clouds with the 50/50 and am using a light colored juice. I get about a week out of a coil, could go longer but like a fresh coil. My friend had the same juice but 70vg/30pg and I found after the first hit it just does not seem to wick the best unless I let it sit a while.
So....been vaping for 6 years.
For the last couple years I was using a Reo with an RBA at .5 ohms and was going through about 12-15ml a day. A friend of mine let me try his sub ohm tank a few weeks ago and I was hooked! The flavor was better than my Reo/RBA setup and the vapor was OMG.
Anyways, I've since bought a couple of sub ohm tanks with an IPV2 Mini, then graduated to a Goliath RTA with an SX Mini M Class. Using the Goliath with a .44 ohm dual coil at 30 watts on the SXM and I'm going through anywhere from 25-35ml a day! This just seem excessive....
Can anyone recommend an RTA that would use less juice but still give me a lot of airflow and flavor? I'm not all about the vapor, although I do enjoy it.
I'm guessing that if you want lots of airflow (I'm a direct lung inhale kinda guy) and a warm, full vape you pretty much have to vape at higher wattages/lower ohms and therefore use excessive amounts of juice...just wondering if anyone else has had a similar experience and has successfully cut down their juice consumption.
FYI, I DIY my juice so cost is not really an issue...I'm a bit concerned that using this much juice every day just can't be good for you.
I only have this problem with one juice flavor. It has to be the juice. Same tank and setup as all my others. I have a fresh coil and tank, load it up, and in less than a day my coil is gunked up and turns my clear juice dark brown. Is this safe to vape? It's annoying having to finish it and rinse my coil. Usually I can just fill my tank/top it off without worrying about cleaning it all. Anyone else have this issue?
Hi,
I'm posting because I just encountered some silica wick on ebay while looking for pre-built coils and different kinds of pre-built wire.
I've only used cotton so far- gonna get some rayon eventually but I think I'll order some from USA, people here in UK buy the rayon in bulk from US and resell it by meter for ridiculous price. And whatever material Smok supplies with their RBA heads for TFV12 tank (I must say this material was pretty good, used it both in smok tfv12 rta and berserker mini rta, wicked well, tasted fine and lasted slightly longer than my normal muji cotton. It's gone now so I can't post a picture.).
Anyway- I tried to research here about silica wick but the latest posts were from 2013. Same on youtube- bunch of old videos. Found a thread with a few posts on reddit from like 3 years ago with some folks saying they still use silica wick, claiming the taste is cleaner, you can't physically burn it, you can dry burn it, lasts longer etc.
Why is it not popular anymore, why has it disappeared? Is it worth giving a shot? What are the disadvantages, as clearly there were some advantages I found, but there must have been a reason for folks to abandon this material (other than the one mention below)?
Wicking the coil itself is not a big concern for me, I've read about trouble to get it through a coil and I think I know how to deal with it.
Thanks
Just bought the Kangertech Subtank..... Was told I couldn't use my Max VG juice and I needed to buy some of their lower VG juice. I told the guy no thank you, I know what i'm doing and I can make it wick the Max VG.
Needless to say I got home, the STOCK OCC coil, .5 ohm, wicks my Max VG perfectly fine, even with chain vaping.
I ripped the pre-made coil out of the 1.2 ohm OCC head, and built my own .6 ohm coil in it, wicked it with Organic Cotton (Not KGD or Bacon, Just organic cotton from Walgreens) and it wicks perfectly fine with my Max VG.
I built a single coil .7 ohm spaced coil, wicked it with the double tails on each side, cut off to where it touches the deck, but not touching the threads, put the chimney cap on, and made sure the juice channel was free of blockage, and it wicks perfect with the Max VG.
No leaks, no dry hits, running each OCC head at 30 watts, and the RBA deck at 35 watts.
This is the original Subtank, 6ml for OCC and 4.2 for RBA, (NOT THE NEW 7.0mL version).
So let me hear it.... What have you guys noticed or seen about the wicking ideas, why has yours not worked?
WHY DO SO MANY PEOPLE SAY YOU CANT USE MAX VG ON RTA's, especially on the Kanger Subtank????
I have a smok pen 22, I have been using smoozie Maui Waui e liquid. I have to either wait a while for the juice to soak every few long hits or I have to drop some juice down the top. I tried loosening the cap different amounts it doesn't seem to help, some people said it would. I'm not sure if I need to use different E-liquid like a clear one or what, but I hate having to wait in between hits especially if I already filled the vape with juice. I tried priming the coil when I first got it there was no good there.