Any Box Mods With Batteries Built In?

Hi folks,

I recently purchases a Sigelei 100w box, and got the purple Efest batteries that the vendor recommended.
I'm using this with a KangerTech Subtank Mini.
It's currently set to 42W - 5.0V, and the resistance it shows me is 0.6 ohms.

I have some questions about my setup.

- I read some reports that these batteries have different specs than what is reported, and it could potentially be dangerous. What should I do to be safe? Is there a max W/V that I can set it to?
- I have a TrustFire TR-001 charger (output: 4.2V / 500Ma). Can I charge those batteries with that? I read the charger supports 18650 batteries, but I'd rather be sure...
- If the charger is no good, any recommendations of what I should be using?

Thanks a lot!  

I am interested in setting up an Arduino charger for my vape batteries. But the charger I want to use, an Adafruit bq24074 solar charger, does not support nominal 3.6V batteries. And basically all the Mooch approved batteries are nominal 3.6V. So, which 3.7V batteries are considered fairly robust for high current, vaping purposes?  

I bought my Sigelei 100w Plus a few days back and ordered 2 Sony VTC4's on my same order (I'm confident they're legitimate, I've bought some before) to be able to marry them together and use them with my Sigelei. Upon receiving the batteries, I labelled one A, and one B and put them into my charger at the same time (charger was off, put both in and turned it on), one battery is slightly more charged than the other (it's 2/3 bars, while the other is still 1/3). I'm a bit worried about using married batteries, I understand rotating A and B in my Sigelei and charger but will they be the same charge when they're done? They're new batteries and they both went on at the same time yet one of them is charging a little bit faster.

When both of the batteries are fully charged, will they be safe to use and cycle accordingly? I heard about if one battery has even a tiny bit less, the batteries will take an uneven load and it will make it risky. How do I ensure that these batteries remain married?  

Okay so I did look this up and it appears that other people have mentioned this specifically with sigelei mods but I didn't see any that were more recent. I look at my mod to see what my batteries charge looks like to see if I need to go ahead and change batteries and I swear to God the thing starts jumping around as though the batteries are charging themselves and then going back to the 40%. Apparently that's a problem that the mods have and isn't something to be concerned about but it freaked me the heck out. They're doing just fine now that they're in their external charger thingy but I just want to make sure that that's not a sign of something going wrong with the batteries that it's just my mod being weird I've checked the connections and everything to make sure it was clean and that the batteries were fine and not dented or unwrapped and everything looks good. I just need some assurance that the batteries were not like failing or that a regulated mod would shut itself off if batteries were jumping around like crazy in reality if that's even possible
For clarification it was doing this when I was not firing it  

I wanna buy the sigelei oni edition 150watt but iv not used any box mods that require batteries yet, my jellyfish and innovkin has internal batteries, can you gents recommend 2 good batts and charger. and is there any tips i might need to know.  

I ordered two of these batteries from FastTech. The cheap price and high capacity (without having a mod or some awkward huge battery) attracted me to them. Some two weeks later they show up...

I have two Puff King chargers that came with starter kits we bought at a B&M store. We've been using them with Tripl3 eGo batteries, one Puff King battery (and another Puff King battery, which was taken back and exchanged for another eGo-T battery, which broke), and so far no problems screwing any batteries in. These two from FT show up however and neither will screw into one Puff King charger, but they both did into the other (same charger, down to the model number and everything). Now, one battery from FT still screws in, but the other doesn't.

I took the non screwing in battery to a local B&M store and the guy there was able to screw it into one of their chargers. He handed it to me, and I unscrewed it, screwed it back in, unscrewed it again, and then neither of us could screw it in again. Now I have one battery from FT that will screw into one of my chargers, but not the other. The other battery will charge, but it has to just like sit in the charger and hope the connection stays okay for it to charge. I still have no problems screwing any of my other batteries into either charger, just these ones from FT. Also, it's worth mentioning that the FT batteries never seemed to screw in right... it always felt weird and finicky getting it to go in.

What's up with these batteries? They claim to be eGo/510 threaded, just like my other batteries. They look just like my other batteries too, except they won't screw in right...  

Is it safe to use the vaporesso revenger (built in batteries) and the vaporesso revenger mini (lights up) after owing it for three years? It seems to have kept 3/4 battery charge and I have not used them in a year and a half. I ask because I’ve read older batteries can be dangerous to use if they have low voltage or something.

Also is it safe to use Sony lithium ion batteries after 2 1/2 years? Their volts was at 3.6 when I started charging them. I haven’t used them in a year and a half, but I did charge them once during the year. Using them in arrow sense mod.  

LONG STORY:
Following a previous thread (Question about battery and coils (Swag II)) I have been using Molicel P26A with my two Swag II's for a couple of months.
I purchased four batteries but I have been using only two of them. I always keep them in the Swags, since I use the Swags to recharge them. Practically I keep one of the Swags under charge while I am vaping with the other one.
I find this routine very convenient however I am wondering if that is the best way to recharge them. While a the begining both batteries were working quite well until they reached a 20% level, now one of them seems to be very weak as soon as it reaches 50%, and for that reason I have decided that it was time to replace it.
The other one is still Ok.

SHORT STORY:
Is it ok to recharge the P26A's with the Swag II's or should I use an external charger? Would an external charger significantly improve the life of the batteries?
Also, can an external charger fix a battey that seems to have lost 50% of its capacity.  

So, I know that the Sony VTC batteries were the like "Go-to" battery. But they are being faked a lot and are hard to come by some authentic ones.

So whats the next best option?

I have a few different batteries and I definitely can tell the difference in the quality of the hit, and the life of the battery.

I have a red IMR 2000 mAh 18650 and it hits the worst out of all of my batteries.

Then I have a blue samsung battery (Can't really read the writing) but I can see it says 25r on it. This one hits decent.

Then I have a green 2600 mAh battery. Its a beast. Hits like a champ and lasts long. I would like to find a similar battery to this one. Im guessing this is the Sony VTC 5.

I really want to find something that is just as good as the Green one.

Does anyone know where to find these or a similar battery that is 2600mAh 30 amp? If so, are there any deals going on online where I could get a good price? Id like to order some new batteries.

Thanks for the help all!


Edit. One more question. Anyone know the difference between the Amps on each of the batteries? Just from guessing id say the red is 20 amps, blue is 25, and the green is 30? Does that sound right?  

Hi, so I have several different brands of 18650 batteries but I'm getting ready to pick up the new Geekvape Aegis X, I wanted to get some new batteries. I have been reading up on it but I'm so confused, I don't vape very high wattage It's always under 50 watt, 45 usually being the most, so what would be the best batteries for long activity? Any input would really help. Thanks