Istick 50w Resistance Reading .2ohms High

OK so I got an aspire nautilus mini for free today (my close friend upgraded and gave it to me) and I was using it on my Istick 20 watt for a couple hours and then out of no where it started saying no atomizer and it wasn't firing at all and the Istick wasn't even reading the ohms it just says 0.0 it so I put it on a Itaste VV and it wont fire on that either I have no idea what to do?  

Greetings to all

Having quit cigs, I am alternating With Jf Minifit*20mg Nicsalt for outside and nic craving, and Aspire K4*3mg regNic at home, because as it leaks and, at just over 12cm, too big, annoying for pocket. K4 is great to vape and at length with low nic, since I do sometimes just need to keep puffing, and I am worried about how much I use the minifit with the 20.

I am hoping y'all'll be able to advise and help. The following is a rather stretched permutation of a similar thread (with older gear and less details):
Will the Aspire Nautilus fit the iStick Pico?

Looking now to have something with the (1)dual function, to gradually lower the nicotine while shifting the settings to keep things cofortable and satisfying. In other words, I am seeking to have something that can do both 20mg Nicsalt and Subohm.
(2)Size (averse to large devices) and (2)leakage are priorities. So is (4)ease of filling and coil replacement. In addition, if possible, I would like to exclusively (5?)keep with salts (even as I lower the nic).

The boys at the store recommended istick pico + nautilus 2s. Does this setup work for the numbered and underlined above? Do the pieces fit? If so, can I use the sub-ohm coil for low nicsalt or is the material of the salt just bad for sub-ohm regardless of nic level?

Which is easier to fill/change coil: nautilus 2s standard or TPD? ANy other differences? Is the TPD available in Europe?

Is nautilus the only tank with the dual function?

Is it worth having two tanks to be able to keep shifting? Whether Nautilus 2s or another? And is there some sort of bag or case for my stuff to keep in my backpack (saw a lady with something for her stick in her purse once)?

Given the purpose of ease, Should I consider the Orion Lost vape, or is the ability to lower the wattage just not enough, and I need something with high-ohm. Keeping in mind I don't like anything higher than 3mg on the Aspire K4.

What about Chubby Bunny and Magico? Easy alterntives that vape better than Minifit, have a little more options but not too complicated and still easy to use, fill, etc?

I noticed, pico is small, together with 2s they'll be bigger than K4. Given the purpose of size, what about the istick pico baby + nautilus mini? Do the sizes fit and can nautilus mini take high/sub-ohm coils?

Is nautilus mini easy to fill like 2s or is it like the old nautilus requiring cap removal?

On their website, I read that nautilus mini has 2ml capacity and standard/tpd 2.6, but in the thread above it said the standard has 5ml. Who's correct?

Why didn't the boy recommend other setups? I came across istick pico X and Snowwolf mini and what about Aspire own mods like the one that comes with nautilus; the Zelos, K1 Stealth or Reax Mini?

Finally, is there antyhing I should know about VG/PG percentages with Salts and any of the devices above?

Thanks in advance!  

Hi all. I've been thinking of trying the Aspire Nautilus tank on my MVP 20w since I've read so many good things about it here. I'm doing mouth to lung vaping and I have an iStick 30 on the way too.

I just want to confirm the Nautilus tank will work on both mods? And what replaceable coils should I get for the Nautilus? Thanks!  

For the past 11 months I've been using a combination of kanger pro tanks and then more recently nautilus tanks with their respectful "throw away" atomizer heads. With these tanks I've been using either the itazte vv 3.0 or itazte VTR while keeping the vaping around 8-10 watts.

I've since purchased an Eleaf Lemo and have been making my own single coils in the same 1.8-2.5 range as the protank and nautilus coils.

Should I be able to and get successful results by cranking up the heat to let's say 12-15 watts now that I'm rebuilding the coils with cotton? Have the stock coils been holding me back in terms of cranking the heat? Maybe because they don't wick as well self-built coils?  

I have the Smok xPro M80 plus and I have a couple Kanger subtank minis I use with it. I usually use .5 ohm coils. Sometimes it will show the ohms fairly correctly at .54 or even .61, which seems close enough. However, as I puff, the ohms reading will tend to change after every few puffs. Sometimes it will even say up to 1.5 or 2.0 ohms on the same tank coil! One tank seems to do it worse than the other, but the two I use now both will change quite often, and once in awhile quite drastically. It sometimes helps if I unscrew the tank and screw it back on, but if it isn't really tight, the ohms read are really far off from what they should be. I'm not sure if it is the tanks or the M80 plus that has the problem. When it reads really high, if I don't catch it before I take a puff, it is horrible and burny-dry, since it thinks the ohms are so high...

Has anyone else had this problem and/or have any ideas as to how it can be fixed??

By the way, I've cleaned the connections and everything thoroughly, so it's not that...  

I have a CE4 blister kit. Not real a fan of CE4 tanks either. Looking for an upgrade. Thinking one of the istick families or a mvp 3. Don't know what tanks to choose. Not looking for RDAs, but a decent tank that will last long. Probably the istick 20w but not sure. Any suggestions?
Thanks!  

OK so I got an aspire nautilus mini for free today (my close friend upgraded and gave it to me) and I was using it on my Istick 20 watt for a couple hours and then out of no where it started saying no atomizer and it wasn't firing at all and the Istick wasn't even detecting it so I put it on a Itaste VV and it wont fire on that either I have no idea what to do?  

Am I the only one who has half a dozen tanks on my desk and could start e-juice surfing anytime in the evening?

Let me be a little more precise: Each tank has a different juice in it. Some are RBA's, some are Nautilus tanks, some are standard Aspire or Kanger tanks. Sometimes I just switch between tanks (therefore juice) every few minutes, just like channel surfing, but with e-juice.

As an example: After eating, I might go for a tobacco juice with high nic content, then switch to a tea flavor with little nic, then to a menthol with a nic content that's in between. I might end it with one of my ADV juice that's lower in nic content so my setup is also ready for the morning...

Anyone else does this?  

So I'm on the fence with my latest stint using the aspire vivi nova and mini tanks.. I break and loose them so fast I refuse to spend over $20 on a new tank. And Iv also had mixed results with the coils. I use a provari which has out survived all the tanks.. well, that's another story..

I'm wondering if the Atlantis performs better than the vivi nova tanks Iv been using.. It , with a SS tank might survive my abuse. But I seem to break the base connection more than the glass when I drop them.

Can someone enlighten me how the different Aspire tanks perform? how many different styles of coils are available now? Should consider a different system with more consistent coil performance? I'm tired of the one day aspire coils..

Thanks!  

Hi everybody, I have lost track of new vaping gear and need an advice.
Finally one of my mods died. The newest one, Joyetech eVic Primo. Bad from the beginning (because of its faulty protection) it just stopped working. Another mod should die soon. It is a clone of iStick 30, 4+ years old. It's my best mode, but its battery already is at about of half capacity (after about 1500 charges).
So, now I use iStick 30, iStick Pico 25 and iStick Pico. Tanks (from best to worst) Kayfun 5, Siren 2, Ammit, OBS Engine NANO.
I need a new mod and, possibly, a new tank.
Thanks for reading.