If The Kayfun And The Goblin Has A Baby.....

It would be this guy.

Cthulhu Mod RTA

CTHULHU MOD, RTA





All the good bits from each all rolled up into one. Hope you buy your juice by the gallon, lol


If any retailers are reading this they are looking for distributors.




Mods can move this as needed, just trying to get a little exposure out here  


Similar Content



Cthulhu Rta?

It's hard to find a lot on this one. I haven't seen some of my favorite youtubers who normally review stuff (grimmgreen, rip) make a video on it.

I currently have the subtank mini and considered getting it. Has anyone here had any experience with it?  

High Ohms Kayfun V4

So I've been using a Kayfun v4 and provari p3 using the hybrid connector and have never been able to get th ohms below 2 using .2mm guage kanthal bought from Vape escape one 2 mm coiling tool and about 6 wraps was initially happy with that but after reading the results other users are having they typically end up around 1.2 1.4 ohms using far more wraps then I have been using I tried to increase my coil diameter to 2.5 mm and the ohms exploded to 5 ohms making it unusable I have noticed that my spring in the Kayfun gets incredibly dirty and charred with what I can describe only as soot if anyone has any insights into what could be going on I would much appreciate it ive been enjoying my Kayfun but I'm still looking for that mind blowing Vape I keep reading about  

Preparing

So I dug out 3 of my old Provari 2.5s with the extension caps ,I ordered 6 18650 button top batteries from 18650 batteries web site I have about 6 Berserkers a coupe of Geekvape Ammits and 3 2019 Kayfun minis tons of 28 gauge wire been building 1.5 ohm coils and wow it feels like 5 years ago lol , Anyway I just hope this whole thing with the FDA Pmtas just goes away if not I really hope a couple of my juice suppliers makes it thru I vape Heathers H vapes Dark Horse ,Black Note , Real tobacco Extracts ,Naturally Extracted Tobacco and rocket fuels reaper blend most all on a daily basis ,I do want to say this whole thing that's going on in this country is almost to the point of prejudice against people who vape I smoked for almost 35 years and finally quit in 2013 when I started with a Halo Triton and a Lavatube , I know I should be making my own juice just don't have the time ,and maybe buying a mech mod or 2 But I have about 10 VW/VV mods plus my 3 Provaris which are built like a tank ( I miss provape), well good luck to all  

No Flavor On Kayfun V4

I bought a Kayfun v4 I'm running around .5 ohm coil and a 70 vg 30 of juice but I'm not getting much flavor I've heard so many good things about this device what am I doing wrong. Please help.


Sent from my iPhone using Tapatalk  

Mesh Upgrade From Big Baby/x Baby User

So I've been vaping for 2-3 years now. Mainly on a Big Baby Beast and Baby Beast. When the X Baby came out I got one but stayed with the big baby. X Baby motivated me that vaping wasn't gonna get much better than what we already had. Now after 6-9 months out of the loop, I see mesh is in. My local supply doesn't even carry X Baby coils anymore. So since I've been using the same 2 tanks for over 2 years, well it's time. I just want something better than what 2017 had to offer. I have rebuilt coils in the RTA for the Big baby. I can build basic coils. I want easy. I'm too busy to do anything past a simple mesh RTA or a new mesh sub ohm replaceable cool setup.

I like DL Vapes in the 30-50 watt range. With the Smoke stuff I've never went over 50 watts and I'm happy with that or I would need a new mod.

It would be nice to get a recommendations that the typical local supply would carry coils for  

Rda Or Rta?

So I got my first RTA the other day, a Goblin V2 by Youde. I have to say, this thing hits amazingly. Up until now I've been using either a melo or my doge V2 but I have to say, I'm really liking the Goblin. All the fun of rebuilding with convenience of a tank. My question to all of you rebuilders out there is which do you prefer? RDA's, RTA's or regular clearomizer tanks?  

How Is This Even Possible

8/9 wraps of AWG 29 Kanthal on 2mm bit should give you around 1.8 ohms, right? At least that is what it has always given me. This evening I was rebuilding a Nautilus BVC like I have done so many times before. Lo and behold I put the coil on the ohm meter and it's reading 0.18. I look for sticking out bits of wire. None. I throw out the coil and start over with exactly the same build as always. Again I get 0.16 ohms. I test it on all my regulated mods... same result on all of them.

How is this even possible?!  

Anyone Has A Picture Of A Provari P3 Ti + Kayfun V4?

Sorry guys, I wasn't sure exactly where to post this, it could fit into at least 4 different forums so if this isn't the best one please move it to the correct forum.

As the title states, does anyone have a P3 Titanium + Kayfun v4 and can share a picture? I'm just trying to get a sense of how the Ti looks compared to the SS used on a lot of tanks, specifically the Kayfun v4. Also, a picture with the P3 Titanium + Squape-R would be great as well.

Not to be picky or anything but I would really prefer authentic versions over clones as I plan to buy the authentic versions.

Thanks everyone, it's much appreciated!  

Ok So It May Just Be Me But.

Well i was at the supermarket the other day and was walking out to my Jeep minding my own and puffing away and a smoker came up to me so i was like hmm well i guess hes gonna ask some questions about my gear or what not. Well was i way wrong, he was like yo dude you vapers are so dumb you have no idea what your putting in your body. I was like hmm ok and the 7000 all rolled up in your analogs are ok? I mean im not about to dis a smoker how can i? I used to be one lol. So it went on and on he was saying how dumb i was then i took a drag because heck i needed something to calm me down. To be polite i exhaled upward to the side and he said keep your nasty lung juice away from me um i was done at that point. The nerve of some people i swear. Anyone ever had any similar experances?  

National Save Vaping Day

Monday 7th October

On Monday, October 7th, asking vape shops, online retailers, distributors, manufacturers, and other entities that want to see vaping survive to donate some, or even all, of their profits for the day to the AVA and CASAA. Additionally, we are asking you around the United States to support small vape businesses around the United States on October 7th by shopping at businesses participating.