So I decided to get another clearomizer and the Donner by Amigo Itsuwa is what I got to replace my Aspire Atlantis.....
So here are my thoughts on it and it's just My Opinion:
Holds 4mls of juice - holds more juice so I'm not refilling my tank 2-3 times a day
.50hm Coil head is cotton & Kanthal wire & a wire mesh around the opening for better wicking ( You can use Atlantis coil in this thing and it's better in this tank then it is in the Atlantis) It comes with 2.
There's no notches or trying to center the coil head. It sits in the Clearo and just sucks juice lol
Great Flavor sub-ohm - The flavor you get from this is amazing, I was a little taken back bc I chose a sour raspberry and it really was more sour tasting then in any of the other tanks I had the same juice in
I personally like the drip tip but it's not for everybody
Adjustable air flow control is a wide slot - It's a slide around, but the draw from almost closed to full open is nice any way you wanna vape.
Vape production is great I use 10/90vg - 20/80vg
There are some things I don't like about this tank...
Priming the coil is a process - on a fresh coil the directions state to drop a few drops onto the coil, then once tank is filled let sit for 1-2 minutes prior to use. On your second fill of the clearo you have to let the coil sit for 2 minutes b4 use....I kinda wanna fill and vape, not fill and wait
Holding 4mls of juice is great, but if you can't vape 1ml of juice at the bottom of your tank it sucks. You can't vape the last ml of juice because the coil head sits to high so it can't wick the remaining juice.
I did find that when I put the Atlantis coil head in that the wicking was alot better then the coils that it came with, now this could be bc I am using a high vg juice.
So let's talk price....I bought this at a B&M so I paid A LOT more then what I've found online.
My price was $45.00
I have found these online for as little as $23.00
and for this price I would probably buy it again, not for $45.00
Iv'e been vaping on this for about a week now, I've gone through 2 coil heads in 4 days & now put the Atlantis coil head in it and am having better luck with it.
So there's my thoughts on my new clearomizer.
I only have this problem with one juice flavor. It has to be the juice. Same tank and setup as all my others. I have a fresh coil and tank, load it up, and in less than a day my coil is gunked up and turns my clear juice dark brown. Is this safe to vape? It's annoying having to finish it and rinse my coil. Usually I can just fill my tank/top it off without worrying about cleaning it all. Anyone else have this issue?
I can only get about a 1-2 day life span out of coils that are organic cotton based. After 1-2 days, they start seeping a dark colored liquid into my tank and ruining the juice. This has happened in my Atlantis tank running Melo coils vaping at 32 watts and my Herakles tank running 55 watts. Keep in mind I vape about 7-10ml a day. Juices are 70VG/30PG or 80VG/20PG all at 3mg nic.
On the flip side, if I vape old school Atlantis coils at 32 watts on the same juices, I get a full week before this happens.
Any ideas on how to make cotton coils last longer?! For this reason, I can't wait to get my Lemo 2 in. I'll be able to rewick daily and not worry about cost.
The way things are going, I am losing so much money on coils it's nuts. See picture to see whats happening.
Oh yeah, this is happening on all kinds of juices I vape. Mt Baker Vapor, Vista Vapors, 4 Pillars, The Milk Man. Some are budget juices - others are premium. No matter what juice I use, it happens.
The BIGGEST killer is Zeus Juice with 80%PG, 20%VG. This juice kills a coil in one tank full. I'm guessing the sweeteners in that juice do it.
It's frustrating because I LOVE my Herakles tank running at 55W but if I have to replace the coil every 1-2 days, that's SO expensive.
I was borrowing my bro's Atlantis, for awhile. I put a new coil in it, a couple days before I returned it. It was hitting great. When I give it back, we dump the juice back in a bottle and put the tank back in its original box. About a week later, he sells it to my brother in law. Here's the weird part - we fill up the tank, assuming the coil needs no priming, and fire it up. It seems to be weak on vapor production. It has the nice crackle/pop, and there is no burnt taste or dry hits, but it just isn't producing the volume it used to.
Is this because it sat for a week?
My English not good but hope u guys understand....
I have question...I am gonna talk about rtas....soooo we got the air flow part of the tank when is the coil and that we suck air through it...and there is the juice part where holds the juice....and thing that seal the 2 spaces is the cotton....the juice reaches to the coil throught this capillary action I guess...I was thinking tho while we suck don't we create also vacuum and draw more juice if the airflow can't keep up with our draw?? And if that's correct then...this space that holds the juice should be sealed good so that it can't draw air lets say for example from the top fill cap and then push more juice into the coil cause it will have the atmospheric pressure?? Or maybe it's the opposite and the vacuum we create while we puff should get lose over time while we don't vape??? I am trying to get more understanding about how stuff works hope makes sense and someone can correct my mistakes and make things clear for me
Imagine your self filling an RTA with fresh juice, only to have the worst vape you can endure as you cough up a lung. No its not a dry hit. Do you blame the juice or a clogged up coil? In this episode, I will take a short journey and explore to a better vape.
After a week of chain vaping, over 50ml of juice, a mix of 3mg and 6mg Nic, the rayon wick has finally given up and no longer produced a clean vape. After visual inspection, the coil and the wick has indeed had a significant build up from juice. To the point that I could no longer see wick material between a spaced coil.
After discarding old wicking material and cleaning the coil, i wicked an RTA with fresh Rayon and filled it with juice. My favorite tobacco juice has come a live, i can now take long and deep direct lung hits with enjoyment. My taste buds are intoxicated, as my lungs fill up with smooth and silky vapor with every inhale.
Keep an eye on your coil by visually inspecting it on daily basis. Trust your body and your taste buds when a juice no longer tastes as it should. Re-wicking your RTA/RDA on regular basis or every few days, will help you eliminate many concerns and issues that you might be having with juice flavor or vaping experience.
It only takes ten minutes to rewick, and in return you will continue to enjoy many hours and days of pleasurable vaping experience.
Good Night.
Two issues I wanted to fix. The first is the battery run time using the low ohm coils. Second is when the e-liquid gets to the top of the sub ohm coil housing in the Kangertech I've noticed a lot of dry hits when heavy vaping, ( I like a higher VG juice. ) I would find myself closing the air intakes and sucking hard to get the wick saturated, ( a real pain in the ***. )
NOTE: I like an airy hit and run the air intake ports full open.
So here's what I did.
I've drilled the wick holes out to 3.5mm in the Kangertech coil housing. Then built a 1.1 ohm coil with 4 strands of 32ga. kanthal, ( twisted together first ), 5 wraps around a 3.47mm screwdriver. The coil was very springy to work with but got a bit stiffer after torching t closed to 1/4" width using adjustable tweezers. I used regular ball cotton for the wick in this experiment. The coil came in at 1.1 ohm.
Primed the wick and filled tank with a little bit of juice, just below the top of the coil housing.
All I can say is WOW. The first 10 hits taste a bit crappy but after the break in, WOW.
Taste and vapor production are great. There's a bit of crackle but no pops. Crackle I don't mind, Pops I mind. The ClouporT8 counted 75 hits and now the e-juice level is just above the wicking ports by a hair and still working great with full open air intake ports.
I will add post after I've used this set up for awhile.
Curious what other think!
VapeOn
I've been using 50/50. What's the best to use to extend the life of the coils? I get huge clouds with the 50/50 and am using a light colored juice. I get about a week out of a coil, could go longer but like a fresh coil. My friend had the same juice but 70vg/30pg and I found after the first hit it just does not seem to wick the best unless I let it sit a while.
Hey guys,
Just wanna drop in and say I ordered a Lemo2 to try my hand at rebuilding. It come with a coil and wick at .5ohm already in place. This thing really works awesome... tons of flavor and vapor and can even MtL hit if I dial down the air almost all the way. I do have two hopefully easy questions I'm sure someone knows the answer to...
How high of wattage can you push these or any handmade coil to? Also when you wick a new one, since it doesn't come with much info on it, how do you know if you're putting too much cotton in, and is there a trick to get the cotton right where it needs to be in that little wicking channel from the tank to where the coil is so the juice gets absorbed quickly and properly but without flooding it?
TIA and I know I'm know pro sub-ohmer by any means lol but for someone thinking about one this tank really works awesome.
Well decided to bite the bullet and get the istick 50w and the Atlantis 2, so far so good I got it off a Canadian website both for 120 and received it the next day! Gotta say the Atlantis 2 is our of control lol nothing compared to my aerotank mega put about 20 ml through it so far and not a single dry hit, seems to eat through juice like crazy tho lol and maybe just a little too much air flow for my liking but I'm sure I'll grow to these things but as they are kind of new their still a little weird for me, anyone else run this setup? Any tips or tricks for me? I noticed to get the maximum amount of liquid in it I screw the coil into the tank fill it right full then screw the bottom part on works well
So I purchased the eGo One after hearing amazing reviews of the device. I use an Aspire Atlantis on an MVP 3 but needed something more portable for work/going out. I was more than impressed with the eGo One using the .5 ohm coil, and equally so with the 1 ohm coil. The battery life is great, the flavour is perfect and the vapor production is unexpected. However, within 2 hours of using the .5ohm coil, the vapor began to taste burnt, more than on any other wick I have burnt. So until I could get hold of another I used the 1 ohm coil. 24 hours that one lasted. Joyetech said they would send me replacements free of charge, but while waiting for this I went to my local shop and bought another .5 coil. 1 HOUR LATER, it's frazzled. Wether I'm just being unlucky or the device is faulty I don't know, but I am incredibly disappointed. It's not through a lack of priming or using the wrong liquid, I'm an experienced vaper and had fully primed the wicks for 20minutes minimum and was using a 50/50 juice. This device had great potential, but it will be going in the bin for now (except the battery, which even does a great job on my Atlantis)