Egrip Alternative?

Since I have a box of the Aspire 2.1ohm BVC's in my possession I've been wanting to use the coils in my eGrip ever since I found a few videos on Youtube showing how easy it is. But, I've only read and seen egrip users using the 1.6 or 1.8ohm version. I was wondering if anyone in here has tried this out or is currently using them I the eGrip. Pros? Cons?...just wondering  

So, I know that the Sony VTC batteries were the like "Go-to" battery. But they are being faked a lot and are hard to come by some authentic ones.

So whats the next best option?

I have a few different batteries and I definitely can tell the difference in the quality of the hit, and the life of the battery.

I have a red IMR 2000 mAh 18650 and it hits the worst out of all of my batteries.

Then I have a blue samsung battery (Can't really read the writing) but I can see it says 25r on it. This one hits decent.

Then I have a green 2600 mAh battery. Its a beast. Hits like a champ and lasts long. I would like to find a similar battery to this one. Im guessing this is the Sony VTC 5.

I really want to find something that is just as good as the Green one.

Does anyone know where to find these or a similar battery that is 2600mAh 30 amp? If so, are there any deals going on online where I could get a good price? Id like to order some new batteries.

Thanks for the help all!


Edit. One more question. Anyone know the difference between the Amps on each of the batteries? Just from guessing id say the red is 20 amps, blue is 25, and the green is 30? Does that sound right?  

So I just got my Joyetech eGrip in the mail today and after about 30 minutes I'm getting a burnt hit every 4-5 hits ? Tried changing the wattage, I'm pretty sure I'm using a 50/50 juice... what's happening ? Coil can't be bad as it is brand new and even with the wattage in low it does this. Really pissed off. Any help ?  

So I just bought a kit, it doesn't come with batteries -- which I wasn't told (was led to believe it was charged through the USB port according to vape store employee). So I ordered x4 Nitecore-NL1834 18650 3400mAh 3.7 Protected Lithium Ion (Li-ion) batteries and now the door won't close. I read an old article saying that Protected 18650 can be bigger. If there's a possibility of buying batteries that cost $18 a pop shouldn't they let you know there's a chance that it won't be the right size?
Is there a trick to getting the battery lid to close or do I need to now buy unprotected 18650 batteries and hopefully get my money back on the protected batteries I bought?  

Some of you may be familiar with the problems I've encountered the past couple of months trying to find a vaping unit that works well for me. I think my problems are solved. I've been using a Joyetech Egrip for two days and I'm thrilled and delighted. No tanks to fool with, it's built in. It gives a wonderful smooth hit. It's 20 watts and you can actually vape at full 20 without worrying if your coil is going to fry. You have to use the replacement coils, 1.5, designed by Joyetech, can't use generics. It holds almost 4 ml of juice so you can fill er up and you're good for the day. I could go on and on, but suffice to say this little unit is AWESOME. If you're into simplicity, not into building your own and fooling with a lot of different tanks etc then you should check it out.

Its $69.99 everywhere except I found one place selling it for $49.99, Vape NW. I just ordered a second color. They also sent me a 17 ml bottle of juice (I asked if they could send me a "sample" of one of the juices they carry.)  

Hey guyz,i am planning to buy a mtl setup and was wondering how to decide on good battery as i cant get a good explanation to the terms being used.i plan to vape around 15-25 watt and am looking for a 18650 battery that can last me well.i also saw people saying that sometimes its better to go for more amps than mah.So i was hoping someone can help me understamd as well as decide in some batteries  

Hi guys, just had a quick question. I'm not sure if there is any problem here but I recently bought some mxjo 18650 batteries, they work great. but my issue is that on the bottom of one of the batteries there's a small indention. The mark look likes it's from the pin on my mods end cap. Should I be worried about this or is this normal?  

My mother in law just came home with a new Ecig. She is fairly old, yet insists, no matter how how many people tell her, that Cigarette sized ecigs are NOT economical in the long run. Don't even try to make suggestions, she's really stubborn.

Anyways, she's been off of Cigarettes for a while, and has been using an EGO/Stardust combination for almost 2 years. She said her battery wasn't holding a charge, and decided to pickup a new ecig. She bought something called a Mistic brand ecig...but it has a tank on the end of it. The whole unit is about the size of a normal cigalike. However, the end is a mini tank system. I tried it, and little vapor comes out of it.. which she says is fine. I will say, the products looks nice.

It seems it has a very small battery in it with a smaller than a mini protank II style general configuration for the atomizer. I doubt the thing holds a mil, and I doubt the battery is over 100MaH. The unit screws off the battery, and then the coil and wick unscrews out of the tank. It reveals a setup similar to a mini protank, where the chimney goes into the coil. The coil is TINY. I tried peeking down to see if I can see the coils, but I couldn't. I can't find any sort of specs about the product, type of connector (It's smaller than a 510), battery size/capacity, or even where to buy replacement coils. On the box, there is a website... MysticVapors.com is up for sale!!, but even that site is vague on anything about it and only sells the starter kits. Is there any information about the device anyone knows about? Its a cigalike size with a tank. Can replacement coils be bought? any gotcha's (besides incredibly low amount of vapor) A link to the exact item she bought is HERE. I feel she's just wasted money, but if I tell her that, she just gets all huffy.


Thank you in advance.  

Hello!

So I started vaping 5 or 6 years ago. Started with on of those ego pens and some kinda weird atomizer I don't even see around anymore and gave up on it within a month.

About 2 months ago I started again when my buddy gave me his old vv pen(not sure of brand) and his Nautilus (sp?) tank. I liked the flavor much more but it still wasn't cutting it. So I went to my local b&m and ended up with an egrip. Now, that sucker is what got it all started for me.
Within a week, I got the rba and started reading tutorials and safety tips for days upon days. Built my first coil on it and fell in love with rebuilding.

Anyways, I'm getting off subject lol. So I went with the egrip and upgraded to an istick 50 watt with a freak show RDA. Was buildimg on that thing daily, not for bad reasons besides addiction to building lol.
I used that for a while. Then i thought I wanted more power so I then upgraded to a sigelei 150. Using a lemo and magma exclusively. My favorite RTA and RDA.

Last week I was shopping around online and found a rogue RDA for 5 bucks and a kbox for like 12-15 bucks. Went ahead and ordered 3 of each because I figured if I didn't like em I could sale or give them to friends.

Well it turns out that this new 20 dollar set up is now my absolute favorite and don't see myself needing any of the other equipment anymore. Cept the lemo for drives and what not.

I just wish I would have realized this earlier.
Got a picture of it for you, next to can for size reference.
Not sure why the pic is sideways like that but tilting your head makes it look normal ha.  

Hi.

I need some new batteries for my Aspire Tigon Tank. It has to be much like the Tigon battery.

Not big batteries and not small, cause i don't like heavey batteries, and it should give lots of vapour. It should be the cylinder shaped batteries.

Whats the watts on the Tigon? Is it 40? It should be the same.

And else should you notice? Do you also need to notice volt? Is does'nt need to be 1800 mah, but it should be high. Maybe least 1300.

And of course 510 connection.

Please name som models, that fit my description.

What about: Vision Spinner 2, Innokin Endura T18, Joyetech Ecxeed D19, Kangertech EVOD VV?