Rdna 40 New Coil Up Same Down

Hello Been vaping about 2 years now
My setups are Vaporshark Rdna 30 Istick 30 watt and a provari 2.5 and a IPv mini v2 30 watt
So like many others I have been juggling with wattage I currently Use A couple of kanger subtank minis using the RBA and a kayfun v4 I've been all over the place building ohms but have settled on 1.2 - 1.4 ohms BTW I'm not into sub ohms
So after many months of different ohms and watts with the help of steam engine I have found I like my vape at a heat flux of around 175 so to get to this and I can't believe how simple it was I just take the ohms I am using such as 1.2 @ 12 watts = 178 heat flux 1.3 @ 13 watts = 178 heat flux and so on I can't believe it became that simple
So I suppose all it takes is to find what heat flux you enjoy and adjust from there
I never bought that what I have read thru the last 2 years that 14 watts is 14 watts no matter what ohms you use it seems to me there had to be more factors involved
Just my thoughts


Sent from my iPhone using Tapatalk  

Don’t you feel low wattage pod system flavour is weak as compare to tank/pod-mod high wattage Vape flavour  

Hi, I just got the 8 in 1 pirate coil kit with 8 different sets of coils, I'm trying in a nonmechanical mod with the DejaVu RDA with a dual 0.45 Fused Clapton Coils, and I need help calculating at which wattage should I vape for Maximum Flavor.

Thanks for the help  

So I just got my Joyetech eGrip in the mail today and after about 30 minutes I'm getting a burnt hit every 4-5 hits ? Tried changing the wattage, I'm pretty sure I'm using a 50/50 juice... what's happening ? Coil can't be bad as it is brand new and even with the wattage in low it does this. Really pissed off. Any help ?  

I recently got a VOOPOO mini. Came with a small low wattage coil installed already. Used that one and got great flavor. Just went thru 2 N1 coils. Terrible burn and horrible flavor. I let both coils prime for over 15 minutes and set at low wattage to begin with. I am very unhappy with these coils so far.  

Just picked up a Vamo 7, 40w, and cannot figure out how to lock the wattage settings. Currently, if the + or - button is accidentally pushed, wattage increases or decreases which can lead to a surprising vape!

I push + or - to increase/decrease wattage

I push both + and - at the same time, it goes into "settings." In "settings," there are several sub-menus but none of them lock the wattage.

Some Vamo's lock the settings when pushing + and - at the same time for three seconds. Not this one. If I hold down both the + and - at the same time, it goes into settings mode.

Is there a way to lock in the wattage so it cannot be accidentally changed?

Thanks!!!  

I just got my first drippers in the mail today Doge competition and vertex v2 and I built a 1ohm micro using 28 gauge and a 0.3 ohm at 24gauge and at 50 watts(max for my mod) I find the 1.0 ohm build is way more satisfying. This is not a subohm bashing thread I loves them clouds but I have to say the performance of the 1 ohm coil is waay better... Am I just crazy or is there really no other reason to use sub ohm coils other than a mech mod or trying to get max wattage out of a 100+ watt device?  

Hello everyone, i bought a new vape 24H ago because my first one was terrible.
And when i use the recommended wattage for my resistance. The tast in my throat is pretty agressive.
Recommended : 40-60 Watts
Using : 26-30 Watts
So i wonder if using a too lower wattage can be bad for my resistance;vape itself.

Also i want to know if i use if i puff aproxymatly 0.5s is bad and i should make it more long.

Thanks (I don't know if its a duplicate, sorry if yes.)  

Hi, I was thinking about buying the Kanger 1.2 ohm enclosed wick but am not sure exactly what wattage or voltage to use. I currently use the Protank 3 on my Istick 50w. I am currently using the 1.5 ohm wicks and run my device at 9.2 watts and 3.8 volts. So I was wondering if this is right and if I should up the wattage for the 1.2 ohm coils and leave the voltage the same?  

Hello you guys, after being hesitating for 2 weeks, I finally chose the Voopoo vinci X and personally I think it's not bad, so far so good.
In this discussion, I am just wondering if anyone has the same question that, what's the best wattage setting when use their 0.3ohm and 0.6ohm oil? (My ejuice is 3mg freebase/Cookie Twist)

Although they recommend 32-40W for 0.3ohm, and 20-28W for 0.6ohm, the ideal wattage which comes with perfect flavor should be an numerical value, right?
Hope to hear your recommendations, thank you.

Have a nice vaping day
Gavin