Best And/or Max Safe Watt Use

I have the Istick 50 with a Nautilus tank. 1.7 ohm coil. What would be the highest watt useage recommend for this set up? I read the user manual for the tank and didn't see a max safe watt. I don't want a melt down. I did however notice that once I get above 18 or 19 watts the flavor of the juice starts to diminish. is this something that could be rectified with a different type of coil in the tank that would allow for higher wattage and give a better taste. Or a different mix of juice?  


Similar Content



Juice Turns Dark.

I only have this problem with one juice flavor. It has to be the juice. Same tank and setup as all my others. I have a fresh coil and tank, load it up, and in less than a day my coil is gunked up and turns my clear juice dark brown. Is this safe to vape? It's annoying having to finish it and rinse my coil. Usually I can just fill my tank/top it off without worrying about cleaning it all. Anyone else have this issue?  

Why Do I Cough?

Been using drag x before but i got the drag Max now but i can barely go over 40 watt on it without coughing...i usually vape at 80 watt on my drag x without any problems. The coil says 60-80 watt recommended. Im using a new juice now btw. Is that juice supposted to be vaped at lower watt?  

Another Variable Sweet Spot Thread

I'm finding a 1.3 ohm coil to be to low for me. On my Provari, between 2.9 and 3.5 volts are OK. I haven't used this tank on either of my other two variable wattage regs, but I'd think it to be in the 6 - 7 watt range. It's time to re-wick the other tank or quit typing and do it already. I think I'd go for the former, but then I'd have to think about that. The other tank's coil I wrapped to about 1.7 ohms. My mech and me would be ever so gladder if that tank was fully operational again.  

Upgraded My Tank But Still Tasting Liquid ??

Hey there guys, new here.

I have a Vappresso Revenger Mini kit and I have upgraded my tank from NRG SE Mini tank to a "Geekvape Z Sub Ohm tank(Much Larger Tank)". Because I wanted to taste more flavor and still blow lots of clouds in the air with my vaping device being fairly cheap.
I put a New Geekvape Z series coil 0.4ohm 50-60W because I burnt my original 0.2 Ohm coil , I wont talk about my previous coil. I'm getting 2 problems here.

1. I'm using 60W, normal setting and every time I vape or inhale I get a taste of E-Liquid in my mouth. However its blowing perfect clouds and still getting an amazing taste but its just that the liquid drops in my mouth. I just want to spit it out every time. How do I fix that problem?

2. The other thing is if I use Higher Wattage and High settings the liquid pours out of the air flow and starts leaking and backspits in my mouth.

(Before I vaped with new coil)I put the new coil in, I soaked it for 10-15mins, while I fill half tank of E-liquid which is 0.8Ng/0.2PG. Then I inhaled 3-4x with no button pressed. Then I vaped to test, still leaking. I set the vape to 70W and high setting then blow downwards into the device 5-6x. All I was trying to do is desaturate it. My results got better didnt notice much of a leak but I still get a little bit of liquid in my mouth. If you can help me out here, I would much appreciate it.

Thank you and kind regards

Tuatara Vaper  

Does Using A Sub-ohm Tank At Low Wattage Damage It Or The Mod?

I just got a Delta II tank as an entree to sub ohming after a disastrous adventure with a MELO. Strangely enough, though, while blowing an occasional cloud at 30 watts is fun, I find I also like running it with the air flow pretty restricted on the tank and at 14-16 watts on the regulated mod and taking mouth hits. Really nice flavor and "just right" (to me) vapor production.

Is running a sub-ohm coil at low wattage potentially causing any damage to my mod (iStick 30w) or my tank?  

Coil Ohms And Wattage Solution

Hello Been vaping about 2 years now
My setups are Vaporshark Rdna 30 Istick 30 watt and a provari 2.5 and a IPv mini v2 30 watt
So like many others I have been juggling with wattage I currently Use A couple of kanger subtank minis using the RBA and a kayfun v4 I've been all over the place building ohms but have settled on 1.2 - 1.4 ohms BTW I'm not into sub ohms
So after many months of different ohms and watts with the help of steam engine I have found I like my vape at a heat flux of around 175 so to get to this and I can't believe how simple it was I just take the ohms I am using such as 1.2 @ 12 watts = 178 heat flux 1.3 @ 13 watts = 178 heat flux and so on I can't believe it became that simple
So I suppose all it takes is to find what heat flux you enjoy and adjust from there
I never bought that what I have read thru the last 2 years that 14 watts is 14 watts no matter what ohms you use it seems to me there had to be more factors involved
Just my thoughts


Sent from my iPhone using Tapatalk  

Mvp 20 Watt Not Reading Ohms Right

My MVP 20 watt recently started to get a little wonky on me. I use 1.5 ohm coils in an aerotank but for some reason the MVP is readin it as 4.9 and sometimes even higher. Of course its not hitting right either. I know its not the coils because if i put that same tank on my MVP 2.0 it reads correctly. The MVP 20w doesn't do this all the time but today its been doing it all day. It won;t go below 5 ohms and sometimes its even higher. Is this thing shot?  

Confused On Kanger Coils

Ok so I know that kanger subtank .5 ohm coils are good for up to like fifty watts and the subtank 1.2 coils are good for up to 26 watts, my question is this kanger has released vocc coils pretty much the same coils they have for the aero tank , genitank ,etc except now they have organic cotton like the subtank coils. Is it safe to think that the 1,2 and 1.5 ohm vocc coils will be safe as the 1.2 and 1.5 subtank coils at the 26 or so watt range, if not how many watts are safe so I don't burn them to hell  

Just Picked Up A Herakles Sub Tank

I must say, this is a decent tank. I now have an Atlantis sub tank and a Herakles tank. I do like them both, but on my Atlantis im limited to 30 watts. Anything above that starts to taste burnt. The Herakles I already have up to 40 watts and the juice tastes good and I get good clouds. Im picking up a Sigelei 100w plus from a buddy of mine. Im thinking I may pick up a Matrix tank to go along with it. Anybody have any experience with the Matrix tanks? Good? Bad? Neutral?  

Strange Burnt Taste

I've got one that has me puzzled. I went through two fills of my Aerotank V2 with Cosmic Fog's Milk and Honey when it started to taste burnt. I figured no big deal, let me change the coil and clean the tank and all will be well. Well, new coil and cleaned tank and about 4 drags in it tastes burnt again. Thinking maybe I have a bum coil I try another one. Same deal.
I'm at a loss. It's the same bottle of liquid, same tank (cleaned each time), same battery (iStick 50w), same wattage (8.9), same resistance (1.2 ohm). Anyone have any clue what's could be causing this? It's getting expensive in coils and liquid!

Thanks