Any Drippers Out There That Take Pre Made Coils?

a few little questions. I actually like dripping my 3 mg nic in max better even than vaping. I drip using 3 mg nic on a Istick 50 watt set about 23 watts with a draw of about 2.5 seconds and the coils reading says 1.6 ohms and the air holes blocked a tad on the el diablo bael. I vape on the Istick 20 watts somewhere around 7 to 8 watts on factory coil of 1.8 in a nautilaus mini
my questions: 1) does sub ohm in a rebuildable tank give flavour similar to a dripper
drippers seem to require higher watts is this in anyway suggested as less healthy ( I am not too concerned about the increased supposed formaldehyde issue I believe Dr F had issue with the research and in my opinion I probably breathe more formaldehyde off gassing wandering around carpets and insulation and pressboard)
2) the nic level is quite a bit lower in the dripper Does this actually translate to a drop in nicotine/contine levels in my blood in other words would I need to drip more to keep my nic levels somewhat reasonable re setting off " the I want a smoke brain run"
3 if I were to drip only for 3 or 4 days am I likely to find my 12 mg vape to strong

thanks for any insight you might provide  

Recently, I developed a pretty nasty cough, and I suspect vaping, since it usually happens right after I exhale, and at night when I'm in bed, it's a LOT worse. The problem seemed to start shortly after I got my Kanger SubTank Mini, which was about 4 months ago or so. I've been using 50/50 liquid for the past year or two and haven't changed the flavor in a couple years. I've also been using the same brand for about 4 years. The cough is brutal, and sometimes it hurts and makes me feel like I have to throw up. It's a lot like that tickle in your throat you get when you have a cold.

Things I've tried to remedy this:
- Gone all the way down to 20% PG, suspecting this may be a culprit.
- Tried many different coil lengths. I've built everything from 0.3 - 1.5 ohm.
- Tried using the OCC heads that are built for the subtank mini
- Changing airflow on the tank
- Building "looser" coils
- Building coils with different diameters

None of these have fixed the cough. The last step I guess I could try is a new tank or something, but I don't really want to do that.

Also worth noting, sometimes it's completely fine. No coughs.

Any ideas?  

GS Air coils/GS 3ml tanks.
I Googlefied this and Did see One place that said A worn out tank could make coils not last as long. (Sounds near fetched to me...)

Can an old tank start Causing premade coils to show Low ohms, like. 05 ohm?

I am pretty sure these are factory coils not FT copycats.
Bruce in Ocala, Fl  

I bought a Kanger Subtank and Atlantis V2, but sold them because they just weren't wicking my 100% VG liquid (Velvet Cloud & Gypsy eJuice) well at all. I tried using the atlantis with the .3 ohm coil installed at 70-80W, which was the stated operating range, and found it to be EXTREMELY hot. So hot that the tank quickly heated up to the point of almost burning my lips. The Kanger just burned the wick up at 20W+ with the .5 ohm coil, despite letting it sit filled for a few minutes and priming.

I am very interested in picking up a Royal Hunter, although I've no idea what pre-made coils (i dont want to make my own coils, just dont have the knowledge or time to learn how) and battery to get. VaporDNA sells UD pre-made coils in various resistances, but figuring out what resistance to use, and thus what wattage battery to get is where I am stuck. Not sure if it'd be better to run at lower ohms / higher wattages, or higher ohms / lower wattages. I'm not sure if it's possible to get massive clouds, but a cooler vape at the same time, but that's my aim.  

I ordered a new version of the Vamo V7 varible voltage 40 Watt mod and I am wondering if the Kanger Subtank Nano with a 1.2 ohm coil would be a viable combination. I want to try this tank just for the better flavor possibility but since the Vamo V7 is only rated down to 0.8 Ohms, I figure that I would have to use the 1.2 Ohm coil that is supplied with the Nano. I'm not quite ready to start dripping at this point in my vaping experience but want to get close to it. Are there any other tanks that would work better with the Vamo V7 than the nano? Thanks in advance for the advice.  

Hey guys I'm looking to upgrade from what I have right now which is the atlantis v1. I'm not a huge fan of the atlantis because of the inconsistency with the coils and the loss of flavor after 2 tank full. The atlantis v2 seems nicer with the occ coils and improved airflow, but I'm not sure if its worth the upgrade since I could just get the new 5-pack occ coils for my v1. The subtank mini still has better options with the occ coils and RBA. Also it seems the occ coils for the subtank is easier to rewick which could save me a few dollars.
I'm not sure which one to go with. I'm leaning more toward the subtank, but still not sure. Maybe someone who has either one or knows more about them could help me. I like to have a good amount of clouds while still keeping the flavor.

Or if anyone has a sub-ohm tank they could recommend that they like more than the ones I mentioned that would be good too.

I use an ipv2

Thanks  

Hey guys, I bought the Subtank Nano and loved it with the packaged coils.

I bought back-up coils that had a white insulator instead of the red, and the first one I popped in gave me such a severe sore on my tongue that I can barely talk. Both of them I've bought have really made it so bad and the flavor isn't good either.

I think they're clones that really have some bad coil material or something, but I can't tell... do the authentic ones have the red insulator?

Thank you!  

I never used anything but Kanthal and Nichrome wire to build my coils.

All things being 100% equal (wire gauge, coil type, coil diameter, ohms, etc) do SS coils require more power to run to get the same vapor as the exact same coil/resistance made from Kanthal or Nichrome wire?  

I'm a little late to the drop-in PNP coil game, I just got Wotofo's SMRT PNP rebuildable coil system and I LOVE IT. I've always been an oldschool rebuildable, low ohm, high watts, big hot vapor fan, and extremely skeptical of the replaceable pods because, let's be honest 5 years ago they didn't hold a candle to a plain'ol RDA that you have to spend 15 minutes building and getting just right.

Well the PNP coils have me kicking myself for not trying them sooner as they produce 95% the same amount of vapor of a *perfect* RDA build, but with 10x better warmth and flavor.

So I'm wondering why the heck other companies besides wotofo aren't upping the anty and making better PNP coils like Wotofo (the Voopoo ones are great, but Wotofo really outshines them with their rebuildable mesh-style pods). I would easily pay $20 for an Ohm Science pre-made Alien Clapton pnp pod or something a little more intense. Since you can put these PNP'S on an 80+ watt mod, there's a world of possibility for plug-n-play cloud chasing if you want, and I think there's some financial incentive for that.

Does anybody know where you can maybe buy some blank wholesale pnp shells because I might try and make my own if no one else does!  

I just Started rebuilding my kanger dual coils and im having a issue , seems like when i build them and check my ohms on my meter they are right where i want them but when i put them in my tank and fire them up the ohms fluxuate like crazy from low to high ohms, any idea why it happens ? It occurs even when i build single coils. Anyway to fix this? Thanks