Joyetech Evic V-t?

Anyone get one of these yet? Any thoughts? Favorite color?  


Similar Content



Best Tank For Evic Joyetech 1st Gen?

Hello, I've been using the Aerotank giant with an eVic Joyetech 1st gen battery since 5 months ago and the glass of my tank broke a few weeks ago so, I'm looking for a new tank upgrade, I've seen good reviews about the KangerTech Sub Ohm but I havn't had the time to see reviews about other thanks and this one looks pretty cool, what other tanks are out there to compete with this one? Should I get this one? I'm ordering in the next 3 hours or so, so, any advice is welcomed!

Thanks in advance vapers!  

Evic Vt Any Good

I'm thinking about pre ordering the evic vt by joyetech has any one used it yet and if so is it worth it.  

Evic Vt 60w

Evic VT 60W by Joyetech PREORDER | Vape Street


eVic VT 60W PREORDER

ONLY $65 DURING PREORDER!!

Presenting the eVic-VT 60W, its new cutting edge technology of temperature control, embodying the concept of a healthy alternative lifestyle. eVic-VT features a super large OLED screen, supporting VT-Ti (Titanium)/ VT-Ni (Nickel)/ VW mode, and battery capacity of 5000mah.
The Variable Temperature (VT) brings out a different flavor experience with the change of temperature settings, not only improving the taste,but also saving battery and liquid consumption. eVic-VT is not your typical vape, it’s an evolutionary start.
Features:
Size: 47*25.5*85.6mm
Capacity: 5000mAh
Output mode: VT-Ti/VT-Ni/VW Mode
Temperature Range: 100-315℃/200-600˚F
Output Wattage: VT Mode:1W-60W
VW Mode:1W-50W
Output Voltage: 0.5V-8.0V
Resistance Range: 0.05-1.0ohm for VT mode
0.15-3.5ohm for VW mode
Color: Racing Yellow, Cool Black, Dazzling White
eVic-VT Visual Display:
VT-Ti mode/VT-Ni mode/VW
Wattages/ Voltages
Atomizer Resistance
Battery power/Puff/Time
ETA: Approximately mid June 2015  

Where Are The Joyetech Aio D22s?

Hello Everyone,
Been looking for my favorite vape the Joyetech AIO D22 pen. All the sites say they are either out of stock or discontinued. Does anyone knows why and if they are coming back? After all these years would hate to have to find a new vaping device.
Enjoy PaulCincy.  

Suntank Mini Guide For Toodle Puffers

So I'm a toodle puffer. My normal set-up is a Joyetech Evic Easy and a Kayfun lite with unflavored liquid. The Evic Easy has a regulated 3.3 volt mode and an unregulated mode. I run the Kayfun (original V1) at 1.5 ohms, so I'm vaping at a whopping 7 watts.

Just on a whim, since I was ordering some supplies and stuff, I decided to try one of those new-fangled subtank minis...hey, it was on sale. This is my result after 2 days.

First, the .5 ohm was out of the question, so I primed and put in the 1.2 ohm OCC coil. Well, this was just not a good fit for me. The problem is, I think, the wire guage. I bet the coil is made from 24-26 guage wire. My 3.3 volts took forever to heat that wire. I had to hold the button down for 3-5 seconds to get any sizzle at all, and just couldn't get much vapor.

So, the next step is to try the rba base. This is very kayfun-like, and I built it the same way. Inspecting it, I found a burr on one of the juice channels, but filed that off with a needle file. I built a 1.8 ohm 30ga 2mm coil that turned out to be 2.0 ohm...oh, well close enough. Wicked it with my typical cotton ball and laid the tails across the deck.

I looked at the mouthpiece. Are you kidding me, looks like a tailpipe. Swapped to a favorite drip tip, turned the airflow to the lowest setting, and started vaping.

I've gone thru 2 tanks, and it's working great. Maybe better than my kayfuns. I'm going to try rebuilding the OCC coils for backups, and will likely get a couple more rba bases. The beauty may be how easy it will be to swap out the coil.  

I Love The Joyetech Egrip

Some of you may be familiar with the problems I've encountered the past couple of months trying to find a vaping unit that works well for me. I think my problems are solved. I've been using a Joyetech Egrip for two days and I'm thrilled and delighted. No tanks to fool with, it's built in. It gives a wonderful smooth hit. It's 20 watts and you can actually vape at full 20 without worrying if your coil is going to fry. You have to use the replacement coils, 1.5, designed by Joyetech, can't use generics. It holds almost 4 ml of juice so you can fill er up and you're good for the day. I could go on and on, but suffice to say this little unit is AWESOME. If you're into simplicity, not into building your own and fooling with a lot of different tanks etc then you should check it out.

Its $69.99 everywhere except I found one place selling it for $49.99, Vape NW. I just ordered a second color. They also sent me a 17 ml bottle of juice (I asked if they could send me a "sample" of one of the juices they carry.)  

Joyetech Evic-vt Kit Vs Sub-tank Mini Kit

I think both of these kits are gorgeous and the price is pretty close. I was curious which is the better setup/value? I think my next purchase will be one of these kits and I am hoping you guys can help me choose. I know the Sub-Tank mini has the RBA and I think the e-Vic has temp. control but I was more thinking overall impressions or durability and quality. Thanks.  

Evic Vt

So I was originaly going to buy an istick 50w with a kanger subtank buy I bought the Evic VT in racing yellow. It's on it's way in the mail. Was this a bad idea? Also should I just stick with the tank it comes with or should I buy a kanger subtank. My goal is big clouds and nice flavor!  

New Mod And Tank For 10 W Vaper

Hi everybody, I have lost track of new vaping gear and need an advice.
Finally one of my mods died. The newest one, Joyetech eVic Primo. Bad from the beginning (because of its faulty protection) it just stopped working. Another mod should die soon. It is a clone of iStick 30, 4+ years old. It's my best mode, but its battery already is at about of half capacity (after about 1500 charges).
So, now I use iStick 30, iStick Pico 25 and iStick Pico. Tanks (from best to worst) Kayfun 5, Siren 2, Ammit, OBS Engine NANO.
I need a new mod and, possibly, a new tank.
Thanks for reading.  

Joyetech Egrip Burnt ?

So I just got my Joyetech eGrip in the mail today and after about 30 minutes I'm getting a burnt hit every 4-5 hits ? Tried changing the wattage, I'm pretty sure I'm using a 50/50 juice... what's happening ? Coil can't be bad as it is brand new and even with the wattage in low it does this. Really pissed off. Any help ?