Google wasn't too much help, you guys are more reliable.
Prior to this thread I wrote what appeared to be a 10,000 word essay that I realized went way overboard so I deleted it all and am starting fresh.
Here is the scenario. I have an iclear 30 at 2.0 ohms, an MVP V2, and a Nautilus mini which I acquired today from a local B&M. I am vaping a 20pg/80vg, 18mg nic liquid. Throughout the day I've been getting progressively muted to even bad flavor from both devices. Although both coils failing in line with each other is possible, it is on the unlikely side of things.
Now, instead of throwing a dozen possible scenarios at you, I think it would be easiest to start with a few little questions.
What does a dry hit or failing/bad coil taste like? Please describe it in great detail if possible so I can assess my situation. Are they different tastes? Is it a spicy, burny, peppery sort of taste? What can you compare it to?
Either I have some psychological issues that need addressing or something else is going on. Your input would be greatly appreciated. Thank you!
I'm using a Subtank Nano on the KBOX. Should be absolutely no problems.
But my coils (both the 0.5 and 1.0) are tasting awful. I prime them great, I make sure everythings good and secure, and I'm using a 75%-ish VG juice.
But I can't go above 20 watts with two new packs of coils I have, and especially on the 1.0 coils, that's ridiculous. I'll get a vaporized rubber taste that tastes like the worst clearomizer coil I've ever come across.
Dry cotton should just have sort of a cottony, almost doggy or smokey taste. But this is a pure rubbery flavor. Are the gromets going to crap? These things should be built for Sub-Ohm Vaping!
I have no clue what's wrong but I can't use this thing anymore.
I'm also getting more juice in my mouth than I would if I drank it. These coils have started to spit and spew like nothing I've seen. I've used these coils for months and could always go up to 30 watts, no issues!
I'm having trouble with my Jem Pen E cig - hopefully someone can help me.
I take the coil out clean the tank and battery area, put it back in with liquid + prime the coil. for about 5 minutes it tastes fine and is vaping as normal. then a really horrible burnt taste comes in which is unbearable to smoke and making my throat hurt.
I take the coil out and clean again, put more liquid. the same thing happens! it tastes absolutely fine again and then gets burnt.
any idea why this is happening ? the device gets quite hot too...
i don't think the coil is the issue because why does it taste fine for a few mins?
I've ordered new coils so going to try that but worried its the device. i've only had it for 2 weeks and changed the coil about 5 days ago.
Hello,
It’s my first message here.
Im not a new vaper, I’m vaping since 2010.
But today I do have a question, I’m troubled.
I used a lot of vaping stuff since 2010, but I was stucked on a Nautilus 2 since 3 years, moving from 0.7 coil to 1.8, depending on my needs.
2 days ago, I acquired a Vaporesso Target PM80 SE.
I tried 0.2, 0.6 and 0.8 GTX coils.
But something new and disturbing is happening : all my favorites eliquids (DIY using concentrate mixes with 10% total flavor) taste strong sweetener, almost only sweetener and nothing else. It covers my entire mouth really fast and it becomes disgusting after a few puffs.
What do you thing is happening ??
I'm at my wicks end with this whole rebuilding thing!
Having given up anologs with my Nautilus Mini, I thought I'd treat myself to an authentic Kayfun v4.
My first rebuildable. It vapes great, lots of dense smooth vapour, but the cotton tastes awful!!
Tried cheap cotton from the chemist. Tried Koh Gen Do. The best so far has been Klaud cotton, but there's no denying it. While the vapour is superior to my Nautilus the taste is no where near as good.
Everything in my Kv4 tastes of cotton with a hint of the juice flavour.
I've watched all the videos on you tube, it's wicking fine, but cotton just tastes bad!
7wraps, 3mm ID, 28g Kantal, 1.4 Ohms.
Promised myself a Vapor Flask DNA40 for the Kv4. But if I can't get it tasting better
then this the Kayfun can go in the bin, I'll stick with the Nautilus Mini's on iStick 20w's.
Hello everyone,
I'm vaping with a Vaporesso Swag and have tested the GT2, GT4, Mesh and Ccell coils so far. I'm vaping 50/50 VG/PG liquid with 3ml/mg nicotine. I always use the coils at the lowest recommended wattage, airflow fully open and my puffs are usually 2 seconds long at max.
Now my problem, I'm going through coils faster than others change their underwear. I'm on my third coil now for 10ml (!) of liquid.
I prime my coils and I let them sit in the tank for at least 30 minutes before I use them. I get muted flavor after maybe 5ml of liquid and it tastes burnt after 10ml of liquid. I've also tried different liquid brands and at least 20 different flavors.
So what am I doing wrong? I'm about to quit vaping because of the immense cost of coils I go through. I just can't figure out what I'm doing wrong.
Hey everyone,
I've been vaping for about two years now, and have decided to start dripping. For the last few weeks, I have been dripping on an IGO-W, 26G Kanthal single coil (7 wrap micro coil reading at 0.8ohms) on my iStick 30w.
I just recently purchased a new battery that should arrive today, and was wondering if anyone had advice/tips on producing some fat clouds! Dual Coils? Different coil builds? Number of wraps? Watts to vape at? I think you get the picture lol.
The items I will be using are as follows:
-SMOK XPRO M80 Plus
-IGO-W
-26 Gauge Kanthal Wire
-Japanese Organic Cotton
- 80vg/20pg Juices
All input is greatly appreciated. Thanks!
-Tyler
I've got a Nautilus with a 1.6ohm coil, and an iStick 50w. On the side of the coil it says 3.2v-5v, and I want to know if that's just a guideline or a limit for the coil.
I'm running it at 4.8 volts, but I get better flavor and vapor at 5.5 volts. There are no wicking issues or burnt taste at 5.5v, but I don't want to damage the battery or the coil. Any advise would be great thanks!
Hey guys, so I've heard of the above mentioned symptoms of constant vaping, the whole losing taste of a certain liquid you've been vaping constantly and such, but I have a sort of weird scenario.
I get a very strange taste from some of my liquids. For instance, I bought some space jam Omega which is supposed to be peaches and cream with a hint of spices. My friends and girlfriend all seem to taste a very strong peach flavor, I however taste a weird spice flavor. It's almost a basil taste.
The weird thing is, this happens with a few different liquids, but so far it's only fruity liquids (space jams astro, and 2 of vintages liquids) which I don't vape very often. I've had some loss of flavor when I vape the same liquid constantly, but that's the thing I'm rarely vaping these liquids.
I tried using some mouthwash, staying hydrated, etc and nothing has worked.
Any tips/advice/possible info would be appreciated! I just wanna taste my juice!
I've got one that has me puzzled. I went through two fills of my Aerotank V2 with Cosmic Fog's Milk and Honey when it started to taste burnt. I figured no big deal, let me change the coil and clean the tank and all will be well. Well, new coil and cleaned tank and about 4 drags in it tastes burnt again. Thinking maybe I have a bum coil I try another one. Same deal.
I'm at a loss. It's the same bottle of liquid, same tank (cleaned each time), same battery (iStick 50w), same wattage (8.9), same resistance (1.2 ohm). Anyone have any clue what's could be causing this? It's getting expensive in coils and liquid!
Thanks
Hello everyone. I am new to the forum but I have read a few more topics before having to create an account and explain my problem in detail. I own a Geekvape Aegis Mini TC 80W (with the Cerberus tank) and I'm using a 50% / 50% e-liquid, with chocolate, coconut and oats from Nebula. I have owned it for about 2 weeks now. I've been using a .3 ohms coil in these weeks, and I've been really good, except for the last 2 days, I've burned the coil slightly and I don't like the taste anymore, so I decided to switch to the other .2 ohms that I've bought a couple of days ago, so I primed the coil by putting 4 drips in each cotton hole + 2 or 3 drips in the center cotton (it's a mesh coil). I forgot to say that I vape mainly from 30-40watts but it's fine even from 25-42W, I'll never go over it because only the noise scares me. Yes, I know, it's weird. Anyway, my problem is that after switching to a .2ohms coil (it's been about 30 minutes) at 30watts the taste is yucky, totally different, I wouldn't say burnt but not good, plus the noise is like it's muffled, yeah , I opened the holes, if I go over 30 watts the noise gets slightly louder but the taste worse. I would just like to know if I have to leave it overnight to let the liquid absorb well or change the coil directly because it is faulty (I have another 5 of .2ohms but no other so I can't go back to .3ohms)
So, is this normal?